WenmarOpen by Wenmar Pro

Service bulletins for the 2021 Ford Mustang Mach-E

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

329 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Backup camera are shown. Show all

Bulletins, newest first
SSM 504972022-02-23. Service bulletin. BACK OVER PREVENTION; ELECTRICAL SYSTEM. Some 2021 and 2022 Mustang Mach-E vehicles may exhibit a Driver Monitoring Camera Blocked message and/or diagnostic trouble codes (DTCs) B115E:97, B15E1:97, and/or B15E2:97 stored in the driver status monitor camera module (CMR). To correct the condition, place the steering wheel in the center position so that the driver status monitor camera is visible. Connect the Ford Diagnosis and Repair System (FDRS) and clear the DTCs. Turn the ignition off and wait 10 seconds. Turn the ignition on and wait 1 minute. Using the FDRS, perform the CMR self-test to confirm the codes are cleared.
SSM 503852022-02-04. Service bulletin. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. Some 2021 Mustang Mach-E vehicles may exhibit a Driver Monitoring Camera Blocked message and/or diagnostic trouble codes (DTCs) B115E:97, B15E1:97, and/or B15E2:97 stored in the driver status monitor camera module (CMR). To correct the condition, place the steering wheel in the center position so that the driver status monitor camera is visible. Connect the Ford Diagnosis and Repair System (FDRS) and clear the DTCs. Turn the ignition off and wait 10 seconds. Turn the ignition on and wait 1 minute. Using the FDRS, perform the CMR self-test to confirm the codes are cleared.
SSM 497562021-05-03. Service bulletin. BACK OVER PREVENTION:SOFTWARE. Some 2018-2021 vehicles supported by FDRS may not list a software update for a module under the SW Updates tab although an SSM or TSB is published for a software update. This may be due to the module already being at the latest software level. A later software level may have been programmed at the assembly plant, during a previous dealer visit or by an over the air (OTA) update for vehicles that have automatic updates enabled in the SYNC system settings. To review a vehicle's OTA update history, visit the Connected Vehicle > OTA Dashboard tab in OASIS. Information about the OTA Dashboard can be found on FMCDealer.com when performing a search on OTA History Job Aid.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.