WenmarOpen by Wenmar Pro

Service bulletins for the 2017 MINI Clubman

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

139 on file from NHTSA, as of 2026-10-19.

By type

By component

Bulletins, newest first
M6401172018-11-26. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. FOUL, MUSTY ODOR FROM HVAC: WET FOOTWELL CARPET This Service Information bulletin supersedes SI M64 01 16 dated September 2016 and SI M64 02 14 dated August 2016 are being combined to prevent duplication of effort and streamline the repair. The customer reports one, or both, of the following: ? Damp front foot-well carpet after long period of air conditioning use. ? A foul smell (musty, rotten, and vinegary) when the A/C is first turned on for a short time. The condensate drain hose is not properly draining the condensate from the vehicle. The micro-filter is absorbing condensate water from the evaporator housing.
M5102172018-11-26. Service bulletin. EQUIPMENT. ONSOLE STORAGE COMPARTMENT LID DOES NOT OPEN EASILY. Center console storage compartment lid requires too much force to open as demonstrated in accompanying video. tinyurl.com/mkphrma A. Sticky release mechanism. And/or B. Improper alignment.
M4101162018-11-26. Service bulletin. STRUCTURE:BODY:DOOR. EDGE CORROSION IN THE DOOR JAMB AREA. Corrosion on inner door panels at the following holes and cavity openings: Door brake (1). Door wiring harness pass-thru (2).
M1203172018-11-26. Service bulletin. ENGINE. "?Primarily when vehicle is at altitudes higher than 1500m above sea level, and engine is at operating temperature, the idle is sporadically elevated (up to approx. 1200 rpm). MIL indicator is illuminated. Fault code 1E0001 - ""Idle speed control: Speed too high"" is stored in DME. CAUSE DME software error The DME software improvements come in 2 steps 1. Primary improvements with I-level XXXX-17-03-50x. 2. Additional minor improvements with I-level XXXX-17-07-50x (ISTA/P 3.62.0 - expected release July 6, 2017 or ISTA NEXT 4.06.1x -expected release June 23, 2017)."
M6202162018-11-13. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. PERCEIVED SCRATCH IN INSTRUMENT CLUSTER. INFORMATION Replacing the instrument cluster for this issue will NOT be covered or reimbursed under MINI limited warranties. [ Copyright (c)2016 BMW of North America, Inc. ] Page 1 of 3 Page 2 of 2 https://www.minitis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/350...9/2/2016 https://www.minitis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/350...9/2/2016 Page 1 of 3 https://www.minitis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/350...9/2/2016
M6101162018-11-13. Service bulletin. VISIBILITY:WINDSHIELD WIPER/WASHER; VISIBILITY:WINDSHIELD. SI M61 01 16 General Electrical Systems August 2016 Technical Service Front Windshield Wiper Noises This Service Information bulletin supersedes SI M61 01 16 dated April 2016.. Customer complains wipers are noisy or chattering during wiper operation. CAUSE Wiper arms out of adjustment and/or windshield cowl misaligned.
M5106162018-11-13. Service bulletin. VISIBILITY:REARVIEW MIRRORS/DEVICES:EXTERIOR. SQUEAKING NOISE FROM POWER FOLDING EXTERIOR REARVIEW MIRRORS. A squeaking noise can be heard when folding the exterior rear view mirrors in or out. Tolerances in the exterior rear view mirrors
M3402162018-11-13. Service bulletin. SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:WHEEL SPEED SENSOR/TONE RING. DRIVING STABILIZATION CONTROL FAILURE: ABS/DSC INSTRUMENT LAMPS LIT- DIAGNOSIS. 1. DSC's fault codes stored from two different wheel speed sensors (both front or both rear): 4809B0 - wheel speed sensor - front left - drive off recognition faulty and 4809CD - wheel speed sensor - front right - drive off recognition faultyor 4809B9 - wheel speed sensor - rear left - drive off recognition faultyand 480686 - wheel speed sensor - rear right - drive off recognition faulty. 2. Next ignition ON (after above codes stored). a) DME fault can occur:1F054D - drive, safety function: Drive power output reduced, DSC signals implausible and b) Malfunction Indicator Lamp (MIL) may light up. Faulty drive off recognition due to: a towing operation with a raised axle operation of the vehicle on the vehicle hoist operation of the vehicle on the roller test stand DSC diagnosis recognizes implausible wheel speeds, so no control is possible. DME fault is entered on safety grounds since the DSC fault still exists after a terminal change and may only be removed while driving.
M3401162018-11-13. Service bulletin. SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:WHEEL SPEED SENSOR/TONE RING. DRIVING STABILIZATION CONTROL FAILURE: ABS/DSC INSTRUMENT LAMPS LIT. ABS/DSC lamps lit in instrument cluster. Fault codes may be saved in the DSC control unit: 480AAD - wheel speed sensor - rear left - smoke monitoring 480AAC - wheel speed sensor - rear left - unexpected jump in the signal 4809B9 - wheel speed sensor - rear left - driving off recognition faulty 480716 - wheel speed sensor - rear left - plausibility: direction of rotation 4809B7 - wheel speed sensor - rear left - missing tooth 480719 - wheel speed sensor - rear right - plausibility: direction of rotation 480686 - wheel speed sensor - rear right - driving off recognition faulty 480AB3 - wheel speed sensor - rear right - unexpected jump in the signal 480AB4 - wheel speed sensor - rear right - smoke monitoring 4809C2 - wheel speed sensor - rear right - missing tooth Rear wheel pulse generator (wheel speed sensor) retaining screw is loose, missing or broken.
M3101152018-11-13. Service bulletin. SUSPENSION:FRONT:SPRINGS:LEAF SPRING ASSEMBLY:U-BOLT, LEAF SPRING TO AXLE. A groaning and/or squeaking noise from the front axle occurs when turning at low speeds or idle.
M1110162018-11-13. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM. "THERMOSTAT FAULTS (B-ENGINES). The Service Engine Soon light is on. A Check Control message for ""Engine overheated"" and or ""Exercise caution!"" may also display. The following fault codes may be stored in the DME: 1D2401 - Characteristic map thermostat, actuation: Short circuit to B+ 1D2402 - Characteristic map thermostat, actuation: Short circuit to ground 1D2404 - Characteristic map thermostat, actuation: Line disconnection During diagnosis the coolant may be found to be discolored. Insulation on the wiring for the map activation thermostat (heating element) may be damaged. Exposed wiring may allow coolant to enter the harness. This may cause damage to the heating element."
M3201162018-11-05. Service bulletin. EQUIPMENT; STEERING. "EPS INTERMITTENT ASSIST FAILURE, FC 4823FA. The steering assistance fails after several, consecutive parking maneuvers or sustained hold at the end stop. EPS assistance starts functioning again after a few minutes. And, Fault code 4823FA (""EPS control unit internally overload, reduction in steering assistance"") is stored in the EPS control module. EPS software error (overloading protection function over sensitivity)."
M3103152018-11-05. Service bulletin. SUSPENSION:FRONT; EQUIPMENT ADAPTIVE/MOBILITY. CRACKING NOISE IN THE AREA OF THE FRONT AXLE SUPPORT/WISHBONE This Service Information bulletin supersedes SI 31 03 15 dated February 2016. Cracking noise coming from the area of the front axle when driving over rough road surfaces, railroad crossings and speed bumps. CAUSE Wishbone rubber mount.
M3101152018-11-05. Service bulletin. SUSPENSION:FRONT. Groaning/squeaking noise from the front of the vehicle. A groaning and/or squeaking noise from the front axle occurs when turning at low speeds or idle.
M2701162018-11-05. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY. F54 ALL4: FAULT CODE 440317 STORED IN THE LMV. The following Check Control Message (CCM) is displayed in the instrument cluster: CCM 350: Driving stabilization. Drive at a moderate speed. The following entry is present in the fault memory of the LMV: 440317 - Pump motor: General multiple fault. Further fault memory entries can occur in combination: DSC: 48068C - Transfer box - clutch closed down temporarily, possible overheating. 48078A - All-wheel drive clutch - clutch position open, only front-wheel drive. LMV: 440304 - Pump motor: Current too low Unfavorable software of the longitudinal torque distribution module (LMV).
M5110162018-11-05. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; SUSPENSION. "SERVICE ACTION: CHECKING AND REWORKING PVC SEAM ON STRUT TOWER. A PVC seam of the front strut spring tower may not be providing the necessary corrosion protection. Improper application of seam sealer. AFFECTED VEHICLES Vehicles which require this Service Action to be completed will show it as ""Open"" when checked either in the ""Service Menu"" of DCSnet (Dealer Communication System) or with the Key Reader."
M3201142018-11-05. Service bulletin. STEERING; STEERING:ELECTRIC POWER ASSIST SYSTEM. The power assisted steering is unavailable at start up. No communication with the Electric Power Steering (EPS). Multiple possible fault codes. Cause: Electric Power Steering (EPS). Perform a vehicle test with ISTA to identify fault code entrie
M1206152018-11-05. Service bulletin. POWER TRAIN. "ENGINE POWER REDUCTION WITH "CLUTCH DAMAGED"" FAULTS STORED This Service Information bulletin supersedes SI M12 06 15 dated July 2015. A drivetrain malfunction check control message is displayed, prompting the customer to contact the dealer for a service visit. F54, F55, F56, F57Target Integration level: F056-16-11-501 or higherThe vehicle drives normally, but fault(s) for a damaged clutch are stored in the DME. ? 1D3101 - Clutch: Damaged, transmittable torque too low ? 1D3201 - Clutch: Severely damaged, transmittable torque too low CAUSE 1. The DME software diagnostic for detecting excessive clutch slip is too sensitive. 2. The clutch is damaged."
M6402142018-11-05. Service bulletin. EQUIPMENT. Foul Odor when Switching On A/C. The customer reports a foul smell (musty, rotten, and vinegary) when the A/C is first turned on that lasts about five minutes. Micro-filter position too low in the IHKA housing.
M6401162018-11-05. Service bulletin. ENGINE AND ENGINE COOLING. Water Ingress In Footwell Area From A/C Condensate Drain This Service Information bulletin supersedes SI M64 01 16 dated March 2016.. Damp front foot-well carpet after long period of air conditioning use. Musty odor in the vehicle (moldy, old socks, laundry room). The A/C condensate drain hose is blocked by the heatshield. The A/C condensate drain hose is not attached properly to the housing. The A/C condensate drain hose was damaged during installation or previous repair.
M5112162018-11-05. Service bulletin. STRUCTURE. SERVICE ACTION: RUBBER STRIP ON REAR SIDE WINDOW TRIM IS CRACKED. The rubber strip on the rear side window trim may crack. In some cases a gap may be evident on the rubber trim strip. Results are cosmetic- no water leakage or sound intrusion. Combination of unfavorable materials.
M6602172018-11-05. Service bulletin. LATCHES/LOCKS/LINKAGES:TAILGATE:LATCH. (SMART OPENER) CONTACTLESS TAILGATE NOT ABLE TO BE DEACTIVATED. Customer desires to have contactless tailgate opening and closing (Smart Opener) deactivated. Function not included in software released.
M6507172018-11-05. Service bulletin. EQUIPMENT. "NAVIGATION PRO (NBT EVO) MAP UPDATE NOT POSSIBLE, NAVIGATION DOES NOT START. A. Navigation system will not start at all or the ""Navigation system starts"" message is permanently displayed. B. While attempting to update the Navigation system's map, it will not update. Subfolder on internal Hard Disk Drive (HDD) is missing."
M6402172018-11-05. Service bulletin. EQUIPMENT. AIR CONDITIONING COOLING IS INSUFFICIENT. * With option code SA 530 air conditioning or SA 534 Automatic air conditioning Produced from 2/1/2016 through 9/30/2016. * A/C system contains little or no A/C refrigerant. Contaminants under O-ring seals have allowed refrigerant loss.
M6201172018-11-05. Service bulletin. ELECTRICAL SYSTEM. ERRONEOUS SERVICE INCLUSIVE CBS DISPLAY. After pre-delivery check or after instrument cluster exchange, MINI Service Inclusive is displayed although the vehicle does not feature the optional Service Inclusive coverage. Instrument Cluster display error

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.