Service bulletin M120317

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10149266
Published by NHTSA	2018-11-26
Manufacturer's number	M120317
Manufacturer's date	2017-05-01
NHTSA component	ENGINE

NHTSA's summary

"?Primarily when vehicle is at altitudes higher than 1500m above sea level, and engine is at operating temperature, the idle is sporadically elevated (up to approx. 1200 rpm). MIL indicator is illuminated. Fault code 1E0001 - ""Idle speed control: Speed too high"" is stored in DME. CAUSE DME software error The DME software improvements come in 2 steps 1. Primary improvements with I-level XXXX-17-03-50x. 2. Additional minor improvements with I-level XXXX-17-07-50x (ISTA/P 3.62.0 - expected release July 6, 2017 or ISTA NEXT 4.06.1x -expected release June 23, 2017)."

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Engine

Vehicles listed
MINI CLUBMAN	2017
MINI COOPER	2014 to 2015
MINI COOPER	2017
MINI COOPER CONVERTIBLE	2016
MINI COOPER S	2014 to 2017

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
SIM010415	2022-07-05. Service bulletin. MINI Engine oil: repair order invoicing procedure - For covered repairs, effective with repair/claim dates on or after August 1, 2017 Warranties will only reimburse in exact quantities - the 1/10 liter "billing part numbers" for the applicable bulk engine oil (tanker or drum) that is needed after the completion of an engine repair (partial or full) or when an "Engine oil" maintenance service task is performed.
SIM640122	2022-07-05. Service bulletin. Mist formation on the windscreen inner surface may occur at departure or after MSA (automaticstart/stop). Acoustic abnormality in the area of the recirculated air flap (recirculation flap closing and opening several times). The above may occur individually or in combination.
M640221	2021-12-13. Service bulletin. Different air temperatures are felt from left to right out of the front fresh air grilles (air vents).
M010520	2020-09-14. Service bulletin. B46M ENVIRONMENTAL AIR CATALYST SENSOR - LTD WTY EXT TO 15 YEARS/150,000 MILES: Component/Issue-Specific Limited Warranty Extension For the eligible vehicles, MINI USA, a division of BMW of North America, LLC ("MINI USA") is extending the limited warranty for the engine radiator's Environmental Air Catalyst (EAC) sensor (shown) to: 15 years/150,000 miles as determined by the vehicle's original in-service date.
M130120	2020-06-15. Service bulletin. TANK VENTILATION AND MIXTURE CONTROL FAULTS STORED IN THE DME: The Engine Malfunction Warning is illuminated and one or more of the following faults are stored in the DME. All models: FC 191C02 - Fuel tank ventilation system 2nd discharge point: malfunction FC 195014 - Differential pressure sensor tank vent valve signal: fixed FC 118001 - Mixture control: mixture too lean FC 118401 - Mixture control: mixture too lean large deviation CAUSE Internal mechanical defect in the tank ventilation valve. The defect can also result in a very loud clicking noise when the valve is cycling.
M620119	2020-04-27. Service bulletin. CENTRAL INSTRUMENT PANEL LED SURROUND RING DOES NOT ILLUMINATE WHEN IGNITION IS TURNED ON: This Service Information Bulletin (Revision 2) replaces SI M62 01 19 dated January 2019.The central instrument's outer perimeter LED ring (arrows) does not illuminate when switching on the ignition or with the engine start-stop button. It only illuminates after direct actuation of a component (e.g. setting the temperature radio volume etc.). F57 shown; other models similar Software error in the Automotive Pixel Link driver (APIX driver). APIX is the serial high-speed Gigabit multichannel link that connects displays such as the LED ring with vehicle control modules.
M610220	2020-04-27. Service bulletin. CHECK CONTROL MESSAGES FOR BRAKE SUSPENSION AND AIR BAG SYSTEM MALFUNCTION: Multiple check control messages (CCM) can display for brake suspension and air bag system malfunction. The customer may also complain about any of the following: Engine can no longer be switched off Drive position (D) cannot be engaged on the gear selector switch (GWS) Reduction of steering assist After an engine emergency shut-off (either a prolonged long press; or 3 consecutive short presses of the Start/Stop button) and the vehicle going to sleep (identifiable by the lighting of the "Start/Stop button") everything resumes normal functionality and the CCM messages no longer appear. When performing a vehicle test the following diagnostic fault codes are stored in the BDC: CD0420 - "error of Flexray controller on Flexray bus" D91FF9 - "Flexray message data drivetrain 2 (DT_PT_2): Timeout" This message may be read out in the ZGM control unit or Body Domain Controller CAUSE Software in the Body Domain Control unit (BDC).
M220317	2020-04-27. Service bulletin. CREAKING NOISE FROM THE LOWER ENGINE AREA: This Service Information Bulletin (Revision 1) replaces SI M22 03 17 dated January 2018. During load reversal or taking off from a stop there is a creaking or droning noise heard from the lower engine area. CAUSE The bushing in the lower engine stabilizer link is working its way out of its aluminum housing thereby rubbing against the engine oil pan. The bushing in the lower engine stabilizer link (1) is working its way out of its aluminum housing. The aluminum housing starts to rub against the engine oil pan (2).
M640116	2020-03-16. Service bulletin. WATER INGRESS IN FOOTWELL AREA FROM A/C CONDENSATE DRAIN: This Service Information Bulletin (Revision 1) replaces SI M64 01 16 dated September 2016. The condensate drain hose is blocked by the heat shield - The condensate drain hose is not attached properly to the housing - The condensate drain hose was damaged during installation or previous repair.
M110120	2020-02-18. Service bulletin. MALFUNCTION INDICATOR LAMP IS ILLUMINATED WITH A CRANKSHAFT ADAPTION FAULT: When diagnosing an illuminated malfunction indicator lamp (MIL) and/or a different issue the following fault may also be stored in the Digital Motor Electronics (DME). Fault code Control module Fault code text 213A2B DME Increment wheel adaption faulty This situation is not associated with any drivability complaints and only affects vehicles built with a Factory I-level of 19-07-500 and later. An unfavorable DME diagnostic calibration may cause the fault code to be stored. In most circumstances this will cause the MIL to be illuminated.