WenmarOpen by Wenmar Pro

Service bulletins for the 2017 MINI Clubman

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

139 on file from NHTSA, as of 2026-10-19.

By type

By component

Only bulletins with component: Steering are shown. Show all

Bulletins, newest first
M3101152021-08-09. Service bulletin. EQUIPMENT; STEERING; EQUIPMENT ADAPTIVE/MOBILITY. A groaning and/or squeaking noise from the front axle occurs when turning at low speeds or idle
M6102202020-04-27. Service bulletin. ELECTRICAL SYSTEM; STEERING; SUSPENSION; ENGINE; SERVICE BRAKES. CHECK CONTROL MESSAGES FOR BRAKE SUSPENSION AND AIR BAG SYSTEM MALFUNCTION: Multiple check control messages (CCM) can display for brake suspension and air bag system malfunction. The customer may also complain about any of the following: Engine can no longer be switched off Drive position (D) cannot be engaged on the gear selector switch (GWS) Reduction of steering assist After an engine emergency shut-off (either a prolonged long press; or 3 consecutive short presses of the Start/Stop button) and the vehicle going to sleep (identifiable by the lighting of the "Start/Stop button") everything resumes normal functionality and the CCM messages no longer appear. When performing a vehicle test the following diagnostic fault codes are stored in the BDC: CD0420 - "error of Flexray controller on Flexray bus" D91FF9 - "Flexray message data drivetrain 2 (DT_PT_2): Timeout" This message may be read out in the ZGM control unit or Body Domain Controller CAUSE Software in the Body Domain Control unit (BDC).
M3201142020-02-18. Service bulletin. STEERING:ELECTRIC POWER ASSIST SYSTEM; ELECTRICAL SYSTEM. Power-assisted Steering Intermittently Not Available at Engine Startup This Service Information Bulletin (Revision 1) replaces SI M32 01 14 dated October 2016. The power assisted steering is unavailable at start up/drive readiness. No communication with the Electric Power Steering (EPS).
M6101152018-12-10. Service bulletin. STEERING; EQUIPMENT:ELECTRICAL. This Service Information bulletin supersedes SI M61 01 15 dated February 2015. SUBJECT Noise from Steering Column Switch Center when Turning. The customer states that there is a grating or scraping noise when the steering wheel is turned. The noise comes from the area of the Steering Column Switch Center (SZL). When turning the steering wheel, the connection between the steering wheel and the SZL causes torsion stress, creating interference noise.
M3201162018-11-05. Service bulletin. EQUIPMENT; STEERING. "EPS INTERMITTENT ASSIST FAILURE, FC 4823FA. The steering assistance fails after several, consecutive parking maneuvers or sustained hold at the end stop. EPS assistance starts functioning again after a few minutes. And, Fault code 4823FA (""EPS control unit internally overload, reduction in steering assistance"") is stored in the EPS control module. EPS software error (overloading protection function over sensitivity)."
M3201142018-11-05. Service bulletin. STEERING; STEERING:ELECTRIC POWER ASSIST SYSTEM. The power assisted steering is unavailable at start up. No communication with the Electric Power Steering (EPS). Multiple possible fault codes. Cause: Electric Power Steering (EPS). Perform a vehicle test with ISTA to identify fault code entrie

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.