WenmarOpen by Wenmar Pro

Service bulletins for the 2021 Ford Bronco

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

322 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Transfer case are shown. Show all

Bulletins, newest first
SSM 520362023-11-09. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; UNKNOWN OR OTHER; POWER TRAIN:TRANSFER CASE (4-WHEEL DRIVE). Some 2021-2023 Bronco vehicles equipped with 4x4 with part time engagement may exhibit a condition of the vehicle being stuck in neutral tow mode. This may be due to a concern with the all-wheel drive (AWD) module. Make sure the proper procedure is being followed to exit neutral tow mode by referring to the Owner's Manual > Towing Your Vehicle > Recreationally Towing Your Vehicle. Make sure the vehicle's battery is fully charged and then diagnose all diagnostic trouble codes (DTCs) in the AWD module. Refer to Workshop Manual (WSM), Section 307-07A. If diagnostics do not resolve the concern or there are no DTCs present in the AWD module, replace the transfer case and the AWD module. Refer to the appropriate section of the WSM. Once repair is complete, verify the vehicle's ability to successfully enter and exit neutral tow mode by cycling the vehicle in and out of neutral tow mode a minimum of two times, allowing the vehicle to enter sleep mode (key-off for at least 5 minutes) between each cycle. Inform customers that Ford is currently working on a software update to address this condition without a need
TSB 22-24472022-12-02. Service bulletin. POWER TRAIN:TRANSFER CASE (4-WHEEL DRIVE); UNKNOWN OR OTHER. Some 2021-2022 Bronco vehicles may exhibit an illuminated powertrain malfunction (wrench) indicator and diagnostic trouble codes (DTCs) C05D9:19 and/or C05D9:99 stored in the all-wheel drive (AWD) module and inoperative AWD system. These DTCs maybe setting due to a low battery state of charge. To correct the condition, follow the Service Procedure to verify the battery condition and reprogram the AWD module.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.