WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Chevrolet Camaro

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1709 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Automatic transmission are shown. Show all

Bulletins, newest first
21-NA-2452024-04-05. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:COLUMN SHIFT; POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:PARK PAWL; ELECTRICAL SYSTEM:ADAS:PARKING ASSIST:WARNING; POWER TRAIN. This service bulletin provides repair information to correct a customer concern of seeing a Shift to Park Message Displayed in DIC.
17-NA-0662023-07-25. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN. This service bulletin provides information for automatic transmission Oil Cooler Flush and flow test.
PIP5621C2022-10-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); POWER TRAIN. This Preliminary information communicates to the dealer technician that TAC recommends the utilization of the GDS2 software to aid in diagnosing automatic transmission concerns. TAC is requesting the GDS2 session logs be sent in before the dealer contacts TAC.
15-NA-0832021-09-07. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Recovery Process from a Controller Reprogramming Interruption
06-00-89-031D2021-09-07. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN; ENGINE. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification
990420002L2021-08-09. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION; POWER TRAIN:AUTOMATIC TRANSMISSION; EQUIPMENT. This service bulletin provides information on Driveline Clunk Noise and what is acceptable and what is considered normal operation.
06-00-89-031D2021-04-20. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification
15-NA-0832021-04-20. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Recovery Process from a Controller Reprogramming Interruption During service reprogramming of the T87 TCM, some technicians may notice the TCM may fail during the reprogramming event and become unresponsive to the Service Programming System (SPS), unresponsive to the GDS2 tool. This bulletin addresses corrective actions to attempt to recover the module before declaring the TCM as a bad part and replacing. During reprogramming, an interruption can cause the module to lock up. A module reset may recover the TCM
16-NA-1752021-04-13. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:GEARS; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. SHAKE AND/OR SHUDDER DURING LIGHT THROTTLE ACCELERATION BETWEEN 40 AND 128 KM/H (25 AND 80 MPH) AT A STEADY STATE.
150089004C2021-03-08. Service bulletin. SUSPENSION:FRONT:MACPHERSON STRUT; SUSPENSION:FRONT:SHOCK ABSORBER; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. This service bulletin provides technicians with updated information to help identify the differences between what is considered a fluid leak, and what is considered fluid seepage.
060089031F2020-12-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. This service bulletin provides information on OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification.
1308116001F2020-12-07. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION. The intent of this technical bulletin is to identify aftermarket ALDL or DLC interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them.
16NA3612020-09-28. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This informational bulletin explains possible normal condition of a flare from 1st to 2nd, even if the trans had been repaired for the flare and its still noticed.
PIP57002020-02-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary information communicates to the dealer technician that the part numbers for the internal wiring harnesses for the 8 speed RWD transmissions are not listed in the Electronic Parts Catalog. Technicians are to refer to the information provided in this document to obtain the internal wiring harness part numbers by application.
PIP5531A2020-02-10. Service bulletin. ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015?0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that "mating" surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped
080730026F2019-09-23. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped.
16-NA-1752018-06-11. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. This technical bulletin provides a procedure to flush and drain fluids for the transmission to eliminate a shake and/or shudder during a light throttle acceleration between 40 and 128 KM/H (25 and 80 MPH) at a steady state.
16NA1752018-06-04. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This technical bulletin provides a procedure to flush and drain fluids for the transmission to eliminate a shake and/or shudder during a light throttle acceleration between 40 and 128 KM/H (25 and 80 MPH) at a steady state.
17-NA-0992018-05-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This bulletin provides a procedure to replace the crankshaft balancer if found the cause of the customers concerns of noises or sparks.
16-NA-0142018-05-21. Service bulletin. EQUIPMENT; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. Delayed Engagement After Sitting With Engine Off - Torque Converter Fluid Drain Back
PIP5248D2018-05-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015–0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that “mating” surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped.
17-NA-0662018-05-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This warranty administration bulletin provide policy information for automatic transmission Oil Cooler Flush and flow test.
060089031E2018-05-21. Service bulletin. ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION. This informational bulletin provides information on OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification.
16NA3382018-05-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. This Bulletin provides guidelines for Dealers required to contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
GCUS-3-6962017-10-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. 33110 - Service Update. When a commanded shift occurs outside of the expected transmission turbine speed window limits, the commanded shift monitor requests a driver defaulted 8th gear state. The torque associated with the default action results in broken turbine shaft. The calibration window (based on output speed) for the safety monitor (P16F3) is smaller than the calibration window for the driver initiated TAP downshift speed limit checks. Dealers will reprogram the transmission control module.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.