WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Chevrolet Camaro

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1709 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Hood latch are shown. Show all

Bulletins, newest first
PIC64212020-12-14. Service bulletin. LATCHES/LOCKS/LINKAGES:HOOD:LATCH; ELECTRICAL SYSTEM:WIRING; STRUCTURE:BODY:HOOD. This Preliminary information communicates that a dealer may order a replacement hood latch and find that it comes with a three wire connector where the vehicle originally had a two wire connector on the hood latch. The technician is instructed on how to properly wire the new hood latch to the vehicle.
PIC6163C2020-12-14. Service bulletin. EQUIPMENT; STRUCTURE:BODY:HOOD; LATCHES/LOCKS/LINKAGES:HOOD:LATCH. This Preliminary Information communication provides information to the technician about vehicles that have several fasteners, located on either side of the hood latch, appear to be loose. Do not tighten, or otherwise move these two fasteners. These fasteners are part of the front fascia support bracket. They have a preset gap by design, and they have Loctite applied to the threads of the fastener so that this preset gap does not change.
16NA2572018-05-07. Service bulletin. LATCHES/LOCKS/LINKAGES:HOOD:LATCH. This technical bulletin provides a procedure to balance the folding top front latching mechanism and actuator motor to correct a condition of a "Top Not Secure" message being displayed on the DIC.
PIC6163A2017-08-15. Service bulletin. LATCHES/LOCKS/LINKAGES:HOOD:LATCH. This Preliminary Information communication provides information to the technician about vehicles that have several fasteners, located on either side of the hood latch, appear to be loose. Do not tighten, or otherwise move these two fasteners. These fasteners are part of the front fascia support bracket. They have a preset gap by design, and they have Loctite applied to the threads of the fastener so that this preset gap does not change.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.