Service bulletin PIC6163A
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10113883 |
| Published by NHTSA | 2017-08-15 |
| Manufacturer's number | PIC6163A |
| Manufacturer's date | 2017-04-28 |
| NHTSA component | LATCHES/LOCKS/LINKAGES:HOOD:LATCH |
NHTSA's summary
This Preliminary Information communication provides information to the technician about vehicles that have several fasteners, located on either side of the hood latch, appear to be loose. Do not tighten, or otherwise move these two fasteners. These fasteners are part of the front fascia support bracket. They have a preset gap by design, and they have Loctite applied to the threads of the fastener so that this preset gap does not change.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Latches and locks, Hood latch
| CHEVROLET CAMARO | 2016, 2017 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| PIC6421 | 2020-12-14. Service bulletin. This Preliminary information communicates that a dealer may order a replacement hood latch and find that it comes with a three wire connector where the vehicle originally had a two wire connector on the hood latch. The technician is instructed on how to properly wire the new hood latch to the vehicle. |
|---|---|
| PIC6163C | 2020-12-14. Service bulletin. This Preliminary Information communication provides information to the technician about vehicles that have several fasteners, located on either side of the hood latch, appear to be loose. Do not tighten, or otherwise move these two fasteners. These fasteners are part of the front fascia support bracket. They have a preset gap by design, and they have Loctite applied to the threads of the fastener so that this preset gap does not change. |
| 16NA257 | 2018-05-07. Service bulletin. This technical bulletin provides a procedure to balance the folding top front latching mechanism and actuator motor to correct a condition of a "Top Not Secure" message being displayed on the DIC. |