WenmarOpen by Wenmar Pro

Service bulletins for the 2023 Ford Mustang Mach-E

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

184 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Equipment and accessories are shown. Show all

Bulletins, newest first
TSB 24-20582024-04-03. Service bulletin. STRUCTURE; EQUIPMENT. Some 2021-2023 Mustang Mach-E vehicles may exhibit a wind noise from the exterior mirror/A-pillar area when driving at or above 64 km/h (40 mph). This may be due to poor sealing of the lower mirror foam and the glass top run foam.. Some 2021-2023 Mustang Mach-E vehicles may exhibit a wind noise from the exterior mirror/A-pillar area when driving at or above 64 km/h (40 mph). This may be due to poor sealing of the lower mirror foam and the glass top run foam..
TSB 24-20342024-04-03. Service bulletin. EQUIPMENT:ELECTRICAL:INFOTAINMENT:SOFTWARE; ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL:INFOTAINMENT. 2021-2023 Mach-E vehicles may exhibit the drive mode default to normal mode while driving and <Drive Mode Not Available> message displays in the center display screen with or without Diagnostic Trouble Code (DTC) U0253 stored in the ABS module. This may be due to the software in the APIM.
SSM 522802024-03-05. Service bulletin. EQUIPMENT. Some 2021-2024 Mustang Mach-E, 2022-2024 E-Transit/F-150 Lightning vehicles may have diagnostic trouble code (DTC) P1A3C stored in the off-board charger controller module (OBCC). The P1A3C is commonly set due to an interruption of the direct current (DC) fast charging process and should be disregarded. All other DTCs stored in the OBCC are to be addressed using applicable publications and/or normal diagnostics found in Workshop Manual, Section 414-03B.
TSB 24-20022024-02-06. Service bulletin. VISIBILITY:REARVIEW MIRRORS/DEVICES; EQUIPMENT. Some 2021-2023 Mustang Mach-E vehicles built on or before 04-Dec-2023 may exhibit a wind noise from the exterior mirrors/A-pillar area when driving at or above 40 mph (64 km/h). This may be due to poor sealing of the lower mirror foam and the glass top run foam.
TSB 23-23882024-01-05. Service bulletin. EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES; EQUIPMENT. Some 2021-2023 Mach-E vehicles built on or before 29-May-2023 may experience an alarm activation even after the motion sensor function has been disabled through the pop-up menu at ignition off. This may be due to the software in the SYNC module (APIM). To correct the condition, follow the Service Procedure steps to reprogram the APIM. NOTE: The APIM software update that addresses the symptom listed in this bulletin may have been sent via Ford Power-Up software updates delivered over-the-air (OTA) to connected vehicles that have automatic updates enabled through the center display screen. Enter the vehicle identification number (VIN) in Professional Technician System (PTS) and check the OTA Dashboard under the Connected Vehicle tab for OTA update history. If an update to the APIM has successfully completed recently and the customer is reporting the symptoms are no longer present, this article may not apply.
OTAPU0907RAD ON2023-12-07. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; ELECTRICAL SYSTEM:SOFTWARE. Software Update 23-PU0907-RAD-ON for 2023 MACH E vehicles is now available. Quality Improvements include: - The customer will no longer lose their radio presets when the vehicle receives OTA updates. - Turns on AM Radio access
OTA SU6 P3MACHE2023-12-07. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT; ELECTRICAL SYSTEM:SOFTWARE. Software Update SU6 P3 for 2021-2023 MACH E vehicles is now available. Quality Improvements include: - Enable electric return of hood latch release actuator - Corrects erroneous "frunk service required" warning post OTA. - Corrects alarm going off during an OTA download . - improved interior windsheld fogging and heater performance when driving in freezing temperatures - Improved Cold DC Fast Charging and heat sharing/smart heating. - Removal of cause of chime related DTC set against AHU. - Hands-Free to BlueCruise text update. - Adds 3 chimes for Over Speeding situation. - Adds chime for speed limit change. - Adds text box "Hold for Speed Warning OFF" - Introduces a more aggressive series of hood ajar warnings/chimes that trigger at lower speed than the current implementation - The customer is instructed to exit the vehicle when a battery hazard is detected. - IPC software addressing traction control toggle, BLIS and ISA presonaliztion, MyTrip distance reset, Low Tire pressure incorrect reading, and PWM buzz noise elimination. - Provides Yield and No Entry graphic display for Traffic Sign recognition. - Removes Tollbooth Mode - Adds a "some display features may be temporarily unavailable" message to the SYNC screen when a SYNC update is installing. - Profiles (Enhanced Memory) will not be stuck as Guest - Improved "Ask on Exit" pop- up functionality - Selectable Drive Modes - prevent default to normal mode due to loss of communication with SYNC - Improved charge status indication feedback while plugged in.
TSB 23-23602023-12-05. Service bulletin. EQUIPMENT. This article supersedes TSB 21-2307 to update the Service Procedure. Some 2021-2023 Mustang Mach-E vehicles built on or before 29-Sep-2023 may experience a water leak into the liftgate. This may be due to water intruding past the seals on the liftgate mounted rear lamp assemblies. To correct the condition, follow the Service Procedure to seal the lamp cavities.
SAN-Vol1 I12023-08-16. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. The Service Awareness Newsletter is an informal communication that contains information that may not be presently available in a TSB, SSM, GSB, or other electronic communication. This article includes information on warranty, technical service tips and other service information.
SSM 517762023-07-12. Service bulletin. EQUIPMENT; BACK OVER PREVENTION: CAMERA SYSTEM. Some 2021-2023 Mustang Mach-E/F-150, 2022-2023 Expedition/Navigator and 2023 Corsair vehicles may exhibit a Driver Monitoring Camera Blocked message and/or DTCs B115E:97, B15E1:97 and/or B15E2:97 stored in the driver status monitor camera module (CMR). These DTCs should be disregarded unless it is a DTC with a status byte 8F. Other status bytes should be disregarded as they may be caused by a camera obstruction such as driver position, aftermarket devices or dust on the camera. To clear the DTCs, remove anything obstructing the view of the camera and light emitting diodes (LEDs), place the steering wheel in the center position and close the driver door. Connect Ford Diagnosis and Repair System (FDRS) and clear the DTCs. Turn the ignition off and wait 10 seconds. Turn the ignition on and wait 1 minute. Perform the CMR self-test and reevaluate if DTCs persist.
SSM 517272023-06-21. Service bulletin. LATCHES/LOCKS/LINKAGES; EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES; ELECTRICAL SYSTEM:SOFTWARE. Some 2021-2023 Mustang Mach-E vehicles built on or before 21-Apr-2023 may exhibit a false alarm activation and/or warning message in the FordPass application when the doors are locked. This may be due to the software in the door latch control module E (DCME), door latch control module F (DCMF), door latch control module G (DCMG) and/or door latch control module H (DCMH). To correct the condition, download and run the door control module software update application for each module one at a time using the Ford Diagnosis and Repair System (FDRS). For claiming, use causal part 58219A65 and applicable labor times in Section 10 of the Service Labor Time Standards (SLTS) Manual.
SSM 516742023-06-08. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL:INFOTAINMENT; ELECTRICAL SYSTEM:SOFTWARE. Some 2023 Mustang Mach-E vehicles built on 2-Mar-2023 and through 16-Mar-2023 may exhibit one or more of the following symptoms: My Trip display in center display screen does not reset to 0 after key cycle, assisted lane change graphics displayed incorrectly, MyKey creation fails on first attempt, hands on icon displayed during hands-free assisted lane change maneuver, excessive 12 volt battery drain. This may be due to the software calibration in the instrument panel cluster (IPC). To correct this condition, update the IPC software using the Ford Diagnostic and Repair Software (FDRS). For claiming, use part number 10849 and the applicable labor operations of Section 10 of the Service Labor Time Standards (SLTS) Manual.
TSB 23-21372023-05-24. Service bulletin. EQUIPMENT; LANE DEPARTURE: LANE KEEP: STEERING ASSIST. Some 2021-2023 Mustang Mach-E vehicles may exhibit various driver assistance system warning messages or inoperative features and/or Diagnostic Trouble Code (DTC) U3000:49 stored in the Image Processing Module A (IPMA) that will not clear and not be stored in the vehicle's history. DTC C1001:31 and/or U3000:89 may be stored in the IPMA, but may have recently been cleared and stored in the vehicle's history. This may be due to a connection issue between the IPMA Camera and the IPMA. To correct the condition, perform the following service procedure to repair the connection and reset the IPMA.
SSM 516102023-05-24. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. Some 2021-2023 Mustang Mach-E vehicles may experience minor damage to the high voltage battery (HVB) tray as a result of coming contact with road debris and/or other outside influences. Workshop Manual (WSM), Section 414-03A has been updated to include new topics for inspection, repair and replacement of the HVB tray. These new topics should be used to help determine severity of damage and an appropriate repair direction for the HVB tray. If inspection per the WSM determines that the HVB tray requires replacement, the HVB battery trays for standard and extended range have been released for service as a lower cost repair option. Standard range HVB tray - LJ9Z-10732-E. Extended range HVB tray - LJ9Z-10732-D. When an HVB tray is replaced, a new high voltage battery serial number label must be obtained as directed in the WSM and installed in the location indicated.
SSM 515892023-05-16. Service bulletin. EQUIPMENT:ELECTRICAL:INFOTAINMENT; EQUIPMENT:ELECTRICAL:INFOTAINMENT:SOFTWARE. Some 2021-2023 F-150/Mustang Mach-E/Edge vehicles may exhibit a concern of Android Auto unable to wirelessly connect and/or Android phones rebooting when connected to the vehicle via USB. This is due to a concern with the Google application on the customers device. Google has released a fix for these concerns. For Android phones not connecting wirelessly, request that the customer update their Android Auto version to 6.1 or later. For customers who's Android phone reboots when connected via USB, request that the customer update their Chrome application to 88.0.4324.181 or later. The customers service provider should be able to assist customers having difficulty updating their device. This is not a warrantable repair.
SSM 513152023-02-02. Service bulletin. EQUIPMENT:ELECTRICAL. Some 2021-2023 Mustang Mach-E vehicles may experience minor damage to the high voltage battery (HVB) tray as a result of coming contact with road debris and/or other outside influences. Workshop Manual (WSM), Section 414-03A has been updated to include new topics for inspection, repair and replacement of the HVB tray. These new topics should be used to help determine severity of damage and an appropriate repair direction for the HVB tray. If inspection per the WSM determines that the HVB tray requires replacement, the HVB battery trays for standard and extended range have been released for service as a lower cost repair option. Standard range HVB tray - LJ9Z-10732-E. Extended range HVB tray - LJ9Z-10732-D.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.