Service bulletin SSM 49038
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10177880 |
| Published by NHTSA | 2020-08-04 |
| Manufacturer's number | SSM 49038 |
| Manufacturer's date | 2020-07-30 |
| NHTSA component | BACK OVER PREVENTION; ELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY |
NHTSA's summary
Some 2020 F-Super Duty vehicles built on or before 26May-2020 equipped with a high mounted stoplamp camera, may exhibit various concerns such as poor image quality, flickering and/or intermittent blank screen. If a vehicle exhibits any of these conditions replace the high mounted stoplamp camera. Refer to Workshop Manual (WSM), Section 417-01. For claiming, use causal part 19G490 and applicable labor operations in Section 11 of the Service Labor Time Standards (SLTS) Manual.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance, Electrical system, Equipment and accessories, Backup camera
| FORD F-250 SD | 2020 (the catalog's model; the bulletin names a series or trim of it) |
|---|---|
| FORD F-350 SD | 2020 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-450 SD | 2020 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-550 | 2020 |
| FORD F-550 SD | 2020 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-650 SD | 2020 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-750 SD | 2020 (the catalog's model; the bulletin names a series or trim of it) |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 25V686000 | 2025-10-10. BACK OVER PREVENTION:SOFTWARE |
|---|---|
| 25V442000 | 2025-06-27. BACK OVER PREVENTION:SOFTWARE |
| 22V644000 | 2022-08-26. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA |
| 20V575000 | 2020-09-23. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 25N17 | 2026-03-27. Other. Advance Notice – Customer Satisfaction Program 25N17 Certain 2015-2025 Model Year Multiple Vehicle Lines Rear View Camera Replacement If Required After Dealer Evaluation |
|---|---|
| TSB 23-2082 | 2023-04-04. Service bulletin. Some 2020-2022 F-Super Duty vehicles equipped with a 6.7L engine may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC) P0315, P054F, P054E, P2A00, P2A01, and/or P02ED stored in the powertrain control module (PCM). This may be due to the software in the PCM. To correct the condition, follow the Service Procedure to reprogram the PCM and the transmission control module (TCM). |
| SSM 51263 | 2023-01-06. Service bulletin. Some 2015-2023 F-150, 2017-2022 F-Super Duty, and 2019-2023 Ranger vehicles may exhibit dust ingress into the cabin through the doors or air extractors. This may be due to the climate control system being in recirculation mode as a result of the recirculation button being on or automatic strategies for heating/cooling efficiency. To minimize dust ingress when driving in off-road or secondary road conditions, make sure that all doors and windows are fully closed and the climate control system is switched to defrost on and the instrument panel and footwell air vents are switched to off. Temperature and fan settings may be adjusted as desired. Alternatively, max defrost can be activated which will adjust all settings automatically. Operating in defrost mode will keep constant air flow through the rear air extractors and other small areas, helping minimize dust ingress. |
| TSB 22-2254 | 2022-07-01. Service bulletin. Some 2019-2020 Edge/F-150/Fusion/Continental/MKZ/Nautilus, 2019-2021 Mustang/Ranger/Transit Connect, 2020-2021 EcoSport/Escape/Expedition/Explorer/F-Super Duty/Aviator/Corsair/Navigator, 2021 Bronco Sport and 2020-2022 Explorer/Aviator vehicles with SYNC 3 may experience various SYNC performance related concerns. This may be due to the SYNC Software. To correct the condition, follow the Service Procedure to update the accessory protocol interface module (APIM) software. |
| SSM 49756 | 2021-05-03. Service bulletin. Some 2018-2021 vehicles supported by FDRS may not list a software update for a module under the SW Updates tab although an SSM or TSB is published for a software update. This may be due to the module already being at the latest software level. A later software level may have been programmed at the assembly plant, during a previous dealer visit or by an over the air (OTA) update for vehicles that have automatic updates enabled in the SYNC system settings. To review a vehicle's OTA update history, visit the Connected Vehicle > OTA Dashboard tab in OASIS. Information about the OTA Dashboard can be found on FMCDealer.com when performing a search on OTA History Job Aid. |
| TSB 20-2301 | 2020-10-01. Service bulletin. Some 2019 MKZ, 2019-2020 Mustang/Continental/Fusion/F-150/Transit Connect/ Ranger/Edge/Nautilus and 2020 Escape/Corsair/Aviator/Explorer/Expedition/ Navigator/F-Super Duty vehicles with SYNC 3 may experience various SYNC performance related concerns. To correct the condition, follow the Service Procedure. |
| SSM 49032 | 2020-08-04. Service bulletin. Some 2020 Corsair/Explorer/Super Duty vehicles built on or before 27-May-2020 and not equipped with a 360-camera system may exhibit various rear parking aid camera concerns such as poor image quality, flickering and/or completely inoperative. If a vehicle exhibits any of these conditions, replace the rear parking aid camera. Refer to Workshop Manual (WSM), Section 413-13. For claiming, use causal part 19G490 and any applicable labor operations in Section 11 of the Service Labor Time Standards (SLTS) Manual |
| SSM 48602 | 2020-04-02. Service bulletin. SSM 48602 - 2020 F-Super Duty - Incorrect Or Missing Factory Invoiced Accessory (FIA) Trailer Camera Tire Pressure Monitoring System (TPMS) Kits Some 2020 F-Super Duty vehicles were shipped with incorrect FIA trailer camera/TPMS kits and some vehicles ordered with the Trailer TPMS only kit did not ship with the kit. The only accessory trailer kit which can be used on 2020 vehicles is the Trailer Camera only kit HC3J-1A515-CC. Do not attempt to install kits (HC3J-1A515-AC or BC) with trailer TPMS. Vehicles equipped with fifth wheel prep pack and Pro Trailer Backup Assist should install the provided trailer yaw sensor kit 14G551 and plug the yaw sensor wiring into the 12-way bed connector. The trailer camera only kit that shipped with the vehicle can be installed as it connects to the bumper mounted 7/12 trailer connector provided. Follow Super Duty Owners Manual Park Aid section to display trailer Auxiliary Camera view. Trailer TPMS only kit is still unavailable. Monitor OASIS for updates. |