NHTSA recall 20V575000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 20V575000 |
| Manufacturer's number | 20C19 |
| Manufacturer | Ford Motor Company |
| Reported | 2020-09-23 |
| Owners notified | 2021-02-01 |
| Component | BACK OVER PREVENTION: SENSING SYSTEM: CAMERA |
| Units potentially affected | 620246 |
| Part numbers | JL3T-19G490-BD, JL3T-19G490-AD, JL3V-19G490-AC, LB5T-19G490-AC, LL1T-19G490-AA, JL1T-19G490-AC, LJ6T-19G490-AB, K2GT-19G490-AB, LJ7T-19G490-AC, JK4T-19G490-CB, LK4T-19G490-BC, LK4T-19G490-AC, JC3T-19G490-AC, JC3T-19G490-EB, K2GT-19G490-BB, FR3T-19G490-AF |
| Report | Annual report 3, for 2024 quarter 4 to 2025 quarter 3 |
|---|---|
| Filed with NHTSA | 2025-10-28 |
| Vehicles in the campaign | 620246 |
| Reported remedied | 509793 (82%) |
| Reported unreachable | 0 |
| Reported removed | 72 |
These are the manufacturer's totals for the whole campaign at the end of 2025 quarter 3, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.
What is wrong
Ford Motor Company (Ford) is recalling certain 2020 Ford F-150, F-250, F-350, F-450, F-550, Explorer, Mustang, Transit, Expedition, Escape, Ranger and Edge, and Lincoln Nautilus and Corsair vehicles. Due to a poor electrical connection, the rearview camera may intermittently display a blank or distorted image. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
What can happen
Reduced rearward visibility can increase the risk of a crash.
The remedy
Ford will notify owners, and dealers will replace the rearview camera, free of charge. The recall began November 17, 2020. Remedy became available on February 1, 2021. Owner notification letters were mailed on February 1, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 20C19.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
| 2020 FORD EDGE | |
|---|---|
| 2020 FORD ESCAPE | |
| 2020 FORD EXPEDITION | |
| 2020 FORD EXPLORER | |
| 2020 FORD F-150 | |
| 2020 FORD F-250 SD | Listed as a series or trim of this model. |
| 2020 FORD F-350 SD | Listed as a series or trim of this model. |
| 2020 FORD F-450 SD | Listed as a series or trim of this model. |
| 2020 FORD F-550 SD | Listed as a series or trim of this model. |
| 2020 FORD MUSTANG | |
| 2020 FORD RANGER | |
| 2020 FORD TRANSIT | |
| 2020 LINCOLN CORSAIR | |
| 2020 LINCOLN NAUTILUS |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 25N17 | 2026-03-27. Other. Advance Notice – Customer Satisfaction Program 25N17 Certain 2015-2025 Model Year Multiple Vehicle Lines Rear View Camera Replacement If Required After Dealer Evaluation |
|---|---|
| SSM 51778 | 2023-07-20. Service bulletin. Some 2020-2021 Escape built on/before 23-Nov-2021, 2021 F-150 built on/before 08-Oct-2021, 2021 Mustang Mach-E built on/before 29-Mar-2021, 2021 Expedition built on/before 05-Aug-2021, 2021 Explorer built on/before 27-Sep-2021 and 2020-2022 Edge may exhibit a concern of the audio system does not power on, no sound from audio speakers, chimes default to coming through the instrument cluster, no communication with audio control module (ACM) or digital signal processor (DSP) module, and/or diagnostic trouble code (DTC) U0184, U0237 and/or U0238. To correct the condition, perform a hard reset of the DSP by disconnecting the 12-volt battery. Reprogram the DSP module using the latest version of the appropriate Ford diagnostic scan tool. For claiming, use causal part 18B849 and any applicable labor operations in Section 10 of the Service Labor Time Standards Manual. |
| TSB 23-2154 | 2023-05-23. Service bulletin. 2021-2022 F-150 vehicles with 2.7L, 3.3L, 3.5L EcoBoost or 5.0L engines, 2020-2022 Transit vehicles with 3.5L Duratec/3.5L EcoBoost engines, 2021-2023 Bronco with the 2.3L or 2.7L engine having charging system diagnostics performed in the Workshop Manual (WSM) may experience the generator voltage desired (GENVDSD) parameter identification (PID) missing from the powertrain control module (PCM) PID list in the Ford Diagnosis And Repair System (FDRS) scan tool. This may be due to a software parameter in the PCM. To correct the condition, follow the Service Procedure to reprogram the PCM. |
| TSB 23-2082 | 2023-04-04. Service bulletin. Some 2020-2022 F-Super Duty vehicles equipped with a 6.7L engine may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC) P0315, P054F, P054E, P2A00, P2A01, and/or P02ED stored in the powertrain control module (PCM). This may be due to the software in the PCM. To correct the condition, follow the Service Procedure to reprogram the PCM and the transmission control module (TCM). |
| SSM 51391 | 2023-03-04. Service bulletin. Some 2020-2021 Explorer vehicles with 2.3L engine may exhibit a lack of heat from the passenger side vents of the vehicle when using the climate control. When diagnosing for insufficient, erratic or no heat from passenger side vents, perform Workshop Manual (WSM) pinpoint (PPT) tests K, and referred pinpoint tests G/H, and/or AE as applies. If WSM PPT tests are inconclusive, replace heater core per WSM Section 412-00. |
| SSM 51263 | 2023-01-06. Service bulletin. Some 2015-2023 F-150, 2017-2022 F-Super Duty, and 2019-2023 Ranger vehicles may exhibit dust ingress into the cabin through the doors or air extractors. This may be due to the climate control system being in recirculation mode as a result of the recirculation button being on or automatic strategies for heating/cooling efficiency. To minimize dust ingress when driving in off-road or secondary road conditions, make sure that all doors and windows are fully closed and the climate control system is switched to defrost on and the instrument panel and footwell air vents are switched to off. Temperature and fan settings may be adjusted as desired. Alternatively, max defrost can be activated which will adjust all settings automatically. Operating in defrost mode will keep constant air flow through the rear air extractors and other small areas, helping minimize dust ingress. |
| SSM 51254 | 2023-01-05. Service bulletin. Some 2020-2022 Escape/Corsair/F-53 Motorhome/F-59 Commercial Stripped Chassis, 2021-2023 F-650/F-750/E-Series, and 2021-2022 Bronco Sport vehicles may exhibit an intermittent no crank/no start condition and/or an intermittent blank instrument panel cluster (IPC)/SYNC touchscreen. This may be due to the software in the gateway module (GWM). To correct the condition, reprogram the GWM using the latest software level of the appropriate Ford diagnostic scan tool. For claiming use causal part 14F642 and the applicable labor operations of Section 10 of the Service Labor Time Standards (SLTS) Manual. |
| SSM 51248 | 2023-01-05. Service bulletin. Some 2015-2020 Edge, 2016-2018 MKX, 2019-2020 Nautilus, 2018-2021 Expedition/Navigator, and 2020-2021 Escape/Corsair/Explorer/Aviator vehicles may exhibit an inoperative power liftgate. This may be due to the rear gate trunk module (RGTM) software. To correct the condition, reprogram the RGTM using the latest software level of the appropriate Ford diagnostic scan tool. For claiming, use causal part 14B291 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual. |
| SSM 51169 | 2022-11-29. Service bulletin. Some 2020-2022 Aviator/Explorer Hybrid vehicles may experience a concern where the EV power flow does not display in the center display screen. This may be due to accessory protocol interface module (APIM) software. To correct the condition, run the APIM-SYNC Module (APIM) Standard Programming application using the latest software level of the Ford Diagnosis and Repair System (FDRS). For claiming, use causal part 14G371 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual. |
| TSB 22-2254 | 2022-07-01. Service bulletin. Some 2019-2020 Edge/F-150/Fusion/Continental/MKZ/Nautilus, 2019-2021 Mustang/Ranger/Transit Connect, 2020-2021 EcoSport/Escape/Expedition/Explorer/F-Super Duty/Aviator/Corsair/Navigator, 2021 Bronco Sport and 2020-2022 Explorer/Aviator vehicles with SYNC 3 may experience various SYNC performance related concerns. This may be due to the SYNC Software. To correct the condition, follow the Service Procedure to update the accessory protocol interface module (APIM) software. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.