Service bulletins for the 2017 Mazda CX-5
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
572 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| 01-008-18-3451 | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure. |
|---|---|
| MT-003-18 | 2018-04-23. Service bulletin. EQUIPMENT; AIR BAGS. The Workshop Manual has two-different airbag procedures, one for Standard Deployment and one for Two-Step Deployment. Standard Deployment is for Mexico spec vehicles and Two-Step Deployment is for US and Canadian spec vehicles. |
| MT-002-18 | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM. Some customers may complain about improper operation of the MAZDA CONNECT system when streaming music with audio source aha/Pandora/Stitcher/Bluetooth® and the same device is also connected to the USB port for charging. The concerns may include: Blank Screen and/or No Audio Sound, Phone will not charge, Blank Screen and/or No Audio Sound |
| SA-010-18 | 2018-04-23. Service bulletin. POWER TRAIN. Some customers may complain about an unusual thumping / rattling noise coming from the engine compartment. The noise is most pronounced under the following conditions: Engine at idle, Transmission in drive, Foot on the brake pedal, A/C OFF, Audio OFF. The noise may be caused by loose fitting heater hoses vibrating the heater hose bracket protector. |
| SA-009-18 | 2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. The navigation SD Card VIN-locks to a vehicle in the following conditions: 1. Vehicle odometer under 62 miles ? VIN-lock occurs with key ON for 3 minutes or longer. 2. Vehicle odometer over 62 miles ? VIN-lock occurs at key ON. Navigation SD Card Map Update Note: Mazda Toolbox navigation SD card map update can only be performed on a navigation SD card that is VIN-locked. See VIN-lock procecure below. |
| SA-008-18 | 2018-04-23. Service bulletin. EQUIPMENT. Some customers may complain about the MAZDA CONNECT center display cracking (spider cracking). The cracks are internal and cannot be felt by touch. This may be caused by a faulty center display. |
| SA-006-18 | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM. Some customer may complain about multiple warning lights illuminated. Additional symptoms may include: Engine will not turn OFF, Power Liftgate will not open, DSM HU/CM network test failure, Any of the following DTC?s stored: This may be caused by a loose G05 ground connection. |
| SA-005-18 | 2018-04-23. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. Some customers may complain about SIRIUSXM satellite radio does not show album art, artist biographies or station logos in the center display. This is a normal condition. |
| SA-003-18 | 2018-04-23. Service bulletin. TRAILER HITCHES. Some repair kits (p/n 0000-8E-R09) for Recall 1617K (2017 CX-5 - EQUIPPED WITH A GENUINE MAZDA ACCESSORY TRAILER - HITCH HARNESS) may contain an extra wire harness (shown below). The extra wire harness is not necessary for the repair and should be removed and discarded from the repair kit. Only the trailer side of the wire harness should to be used. |
| 09-016-18-3428 | 2018-04-23. Service bulletin. SEATS:FRONT ASSEMBLY:POWER ADJUST. Some customers may complain that the driver's seat does not automatically move to the programmed position when unlocking the driver's door with the remote transmitter unlock button (1), unless the button is pressed repeatedly (more than two times). NOTE: The symptom occurs when the instrument cluster is in sleep mode. Sleep mode occurs when ten (10) minutes or more have passed after the doors are locked with the remote transmitter or request switch. |
| 09-019-18-3450 | 2018-04-23. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This service bulletin provides information regarding the proper use of the driver's floor mat to avoid any potential interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage. Floor mat moves forward due to improper installation. Inappropriate floor mat (such as aftermarket, non-factory-equipped, or non-genuine) is used. Floor mat is stacked one on top of another. Use these points at your dealership to protect our mutual operations and to help ensure our customers' safety. |
| 09-014-18-3443 | 2018-04-23. Service bulletin. STRUCTURE. When encountering a vehicle with paint damage, refer to the "Mazda Pocket Paint Guide" to determine cause, prevention, remedy, and warranty coverage (if applicable). |
| 09-011-18-3448 | 2018-04-23. Service bulletin. EXTERIOR LIGHTING:TAIL LIGHTS; EXTERIOR LIGHTING:HEADLIGHTS. Some customers may complain of condensation/fog inside the front (headlamp/headlight) or rear (taillamp/taillight) combination lights. The recent new models have been fitted with a clear lens which can cause the symptom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural phenomenon that occurs when there is a fairly large temperature difference between the inside and the outside of the light housing. It is normal for very small water drops to appear incertain locations on the light units where the air is stagnant (condensation), making the lens look whitish (fog). This happens mostly in the corners and narrow spaces, and will typically clear during warmer ambient temperatures, or when the lights have been on for some time. |
| 02-005-18-3444 | 2018-04-23. Service bulletin. SUSPENSION. Beginning with the CX-5, grip type front and rear stabilizer bushings have been incorporated for noise prevention purposes. If any type of grease or lubrication is applied to the bushings, it may create noise due to bushing slippage. |
| 00-001-18-3446 | 2018-04-23. Service bulletin. EQUIPMENT. Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. |
| 09-015-18-3445 | 2018-04-23. Service bulletin. SEATS. At PDI or when new vehicle is delivered, some customers may complain about wrinkles on the leather seat cushion and/or seat back surface. |
| 09-013-18-3434 | 2018-04-23. Service bulletin. SEATS. Some customers may complain about the driver and/or passenger rear side seat cushion trim (1) coming off the seat cushion frame. The front seat cushion trim (bottom rear) is attached to the seat cushion frame using a hook. The hook may slip out of the seat cushion frame due to insufficient strength. To eliminate this concern, a plastic tie-wrap has been added to increase the strength. |
| 09-010-18-3440 | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Some vehicles may experience the symptoms mentioned below, which can be fixed with the latest software update (Version 59.00.504 or later). NOTE: For 2016 CX-9 with version earlier than 59.00.441, the tachometer function will be removed from the Active Driving Display as part of Mazda's continuing efforts to improve safety and reduce driver distraction. Please explain this to the customer before updating the software. If the customer agrees, turn off the tachometer display on the AD-Display tab in MAZDA CONNECT Settings before performing the update. NOTE: If the customer has customized MAZDA CONNECT with something like a different background using unauthorized software, make sure they know the following information before updating MAZDA CONNECT to avoid any issues later on. |
| 01-006-18-3429 | 2018-04-23. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. When the engine is started for the first time after parking the vehicle overnight in cold conditions (below 32 degrees Fahrenheit / 0 degrees Celsius), some vehicles may exhibit a rough idle and/or the check engine light on with any of the following DTC(s) stored in memory. P0300 - Random misfire detected P0301 - Cylinder No.1 misfire detected P0302 - Cylinder No.2 misfire detected P0303 - Cylinder No.3 misfire detected P0304 - Cylinder No.4 misfire detected. This may be caused by frozen water accumulated in the main silencer, restricting exhaust flow. |
| 09-003-18-3405b | 2018-04-23. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). Some customers may complain that the Voice Recognition system does not recognize "Address" or "New Destination" navigation voice commands. This may be caused by faulty navigation SD card software. TheSD card has been updated to eliminate this concern. |
| 15-001-18-3369 | 2018-03-05. Service bulletin. FORWARD COLLISION AVOIDANCE: SENSING SYSTEM: CAMERA. Some customers may experience the following symptom relating to the Forward Sensing Camera (FSC)with DTC C1001:92 [Forward sensing camera (FSC) poor field of view] stored in memory.When the visibility out the windshieldis poor (i.e. fog or raining at night), the following warning lights mayilluminate. Master Warning Light High Bean Control Warning Light Lane-keep Assist System (LAS) Lane Departure Warning System (LDWS) Warning Light Smart Brake Support/Smart City Brake Support (SBS/SCBS) Indicator LightThis is caused by the control logic of the FSC being too sensitive. To correct this issue, the control logic ofthe FSC has been modified. |
| 09-003-18-3405a | 2018-03-05. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Some customers may complain that the Voice Recognition system does not recognize "Address" or "New Destination" navigation voice commands. This may be caused by faulty navigation SD card software. The SD card has been updated to eliminate this concern. |
| 09-003-18-3405 | 2018-03-05. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Some customers may complain that the Voice Recognition system does not recognize "Address" or "NewDestination" navigation voice commands. This may be caused by faulty navigation SD card software. TheSD card has been updated to eliminate this concern. |
| 09-002-18-3410 | 2018-03-05. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. After the installation of a new instrument cluster, the message "Fctry" or "Factory" is displayed instead ofthe odometer. This concern may also occur when a room fuse is installed in a new vehicle.Some new instrument clusters are in the factory mode setting. Factory mode cancellation is required.NOTE: The concern is applicable to Calsonic Kansei instrument clusters. Not all trim levels are affected.CX-3 shown:Vehicles having this concern should have their vehicle repaired using the following procedure. |
| 09-001-18-3387 | 2018-03-05. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). Some customers may experience the MAZDA CONNECT rebooting or the screen turning black during coldtemperatures. The concern occurs when the interior of the vehicle is cold and disappears when the interiorwarms up. This is caused by some for the MAZDA CONNECT navigation system SD cards beingmanufactured with improper hardware, resulting in a data reading error during cold temperatures. To correctthe concern, the SD card hardware has been changed. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.