WenmarOpen by Wenmar Pro

Service bulletins for the 2011 Dodge Charger

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

152 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Backup camera are shown. Show all

Bulletins, newest first
90033572024-01-02. Service bulletin. BACK OVER PREVENTION. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
02-007-142022-08-22. Service bulletin. BACK OVER PREVENTION; SUSPENSION; ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); WHEELS. Front End Clunk Noise When Coming To A Stop - Police Vehicles Only This bulletin involves replacing the left side or the right side or both side tension struts. Police vehicles with heavy duty suspension and rear wheel drive may experience a front end clunk noise, coming from the tension strut bushing(s), while coming to a stop.
02-008-142022-08-22. Service bulletin. SUSPENSION; BACK OVER PREVENTION. Front End Clunk Noise When Coming To A Stop - Mexico Only This bulletin involves replacing both the left and right side front tension struts The customer may experience a front end clunk noise, coming from the tension strut bushing(s), when coming to a stop.
18-031-12 REV. A2022-07-25. Service bulletin. BACK OVER PREVENTION; ELECTRICAL SYSTEM; SERVICE BRAKES; EXTERIOR LIGHTING. Flash: MIL Illumination P0108 - Manifold Absolute Pressure Sensor Circuit High This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that P0108 - Manifold Absolute Pressure Sensor Circuit High has been set active or stored.Updating the software will correct the condition listed above.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.