Service bulletin 02-007-14
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10218205 |
| Published by NHTSA | 2022-08-22 |
| Manufacturer's number | 02-007-14 |
| Manufacturer's date | 2014-11-14 |
| NHTSA component | BACK OVER PREVENTION; SUSPENSION; ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); WHEELS |
NHTSA's summary
Front End Clunk Noise When Coming To A Stop - Police Vehicles Only This bulletin involves replacing the left side or the right side or both side tension struts. Police vehicles with heavy duty suspension and rear wheel drive may experience a front end clunk noise, coming from the tension strut bushing(s), while coming to a stop.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance, Suspension, Wheels, Backup camera
| DODGE CHARGER | 2011, 2012, 2013, 2014 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 9003357 | 2024-01-02. Service bulletin. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA. |
|---|---|
| 9003704 | 2022-09-26. Service bulletin. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair. |
| CHRYSLER | 2022-09-15. Service bulletin. The customer may experience the blind spot monitor indicator in either outside mirror maybe flashing or on continuously. |
| 02-008-14 | 2022-08-22. Service bulletin. Front End Clunk Noise When Coming To A Stop - Mexico Only This bulletin involves replacing both the left and right side front tension struts The customer may experience a front end clunk noise, coming from the tension strut bushing(s), when coming to a stop. |
| 08-016-13 | 2022-07-25. Service bulletin. Flash: Indicator For The Blind Spot Monitor Is Flashing Or On Continuously This bulletin involves updating the Left and Right Blind Spot Sensor (LBSS/RBSS) software. Not find any DTC's. |
| 05-003-13 | 2022-07-25. Service bulletin. Front And/Or Rear Brake Noise (Squeal) This bulletin involves changing front and rear brake pads to correct a brake squeal noise. The customer may experience a squealing noise during braking coming from the front and/or rear of the vehicle. |
| 18-031-12 REV. A | 2022-07-25. Service bulletin. Flash: MIL Illumination P0108 - Manifold Absolute Pressure Sensor Circuit High This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that P0108 - Manifold Absolute Pressure Sensor Circuit High has been set active or stored.Updating the software will correct the condition listed above. |
| CHRYSLER | 2022-04-04. Service bulletin. The customer may experience the blind spot monitor indicator in either outside mirror maybe flashing or on continuously. |
| 18-094-16 | 2018-06-11. Service bulletin. Flash: Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience one or more of the following conditions: With the cluster set on metric units, they are unable to accurately increase or decrease the cruise control set speed using the resume or set buttons. Instead of changing vehicle speed by 1 kph when pressing the buttons, the vehicle speed will increase approximately 1.6 kph. Potential gear hunting during cruise operation at lower vehicle speeds 40-64 kph (25-40 mph). In addition, a small number of customers may experience certain symptoms/conditions or a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following Diagnostic Trouble Codes have been set: P1115 - General Temperature Rationality. P0456 - EVAP System Small Leak. P0441 - EVAP Purge System Performance. P2610 - PCM Internal Engine Off Timer Performance. P0300 - Multiple Cylinder Misfire. P0301 - Cylinder 1 Misfire. P0302 - Cylinder 2 Misfire. P0303 - Cylinder 3 Misfire. · P0304 - Cylinder 4 Misfire. · P0305 - Cylinder 5 Misfire. · P0306 - Cylinder 6 Misfire. · P0307 - Cylinder 7 Misfire. · P0308 - Cylinder 8 Misfire. · P0335 - Crankshaft Position Sensor Circuit. · P0122 - Throttle Position Sensor 1 Circuit Low. · P0123 - Throttle Position Sensor 1 Circuit High. · P0222 - Throttle Position Sensor 2 Circuit Low. · P0223 - Throttle Position Sensor 2 Circuit High. · P2299 - Brake Pedal Position / Accelerator Pedal Position Incompatible.** · P2096 - Downstream Fuel Trim System 1 Lean. (LC vehicles with Sales Code ESH with a manual transmission (Sales Code DEC). · P2097 - Downstream Fuel Trim System 1 Rich. (LC vehicles with Sales Code ESH with a manual transmission (Sales Code DEC). · P2098 - Downstream Fuel Trim System 2 Lean. (LC vehicles with Sales Code ESH with a ma |
| 08-030-14 REV. A | 2018-06-11. Service bulletin. Flash: RE2 RE3 RE4 RE6 RE7 RB4 RB5 RB6 RB4 Radio Enhancements This bulletin involves updating the radio?s software and Navigation if required. A customer may experience, one or more of the following conditions: Radio display screen shows ?Test Mode?. Navigation screen locks up or display will be blank. Navigation feature lockout disable (International Only). Navigation system resets intermittently. Translation improvements/corrections. System consistency and operational improvements for menu selections, month/date formatting, and Garmin translation functions. Radio system improvements during remote start operation. Unable to adjust radio volume using steering wheel switch intermittently. Second screen is blank when using split screen function. Some functionality for Japanese and Korean - keyboard, search, sort and jump. Unable to add contacts to the favorite list. Unable to dial the phone from the radio, while still able to dial from the phone. Unable to delete a cell phone number from the favorite list. More space available for phone book entries. BlackBerry support for playing songs. Reduce ticking noise during CD/USB pause and VR is silent between prompts. VR unable to transition from Non-navigation to navigation mode. Viod screen is displayed with navigation screen. Asian language translation added. Highlighted preset continues blinking. Takes more then one button press to select preset #10. Unable to adjust volume from steering wheel switches. Clock adjust pop up message displayed in English rather than current language. Can not connect to the phone after it has been disconnect. Teleprompter screen shows incomplete text. Some functionality for traffic & weather jump button. After changing a language and then selecting CDDA ?of? is displayed as a tracking number. In ?Set Date Year? only 3 digits are displayed. Split map view will not cancel. Map screen turns black when driving. When in Italian, the destination arrival text will overlap onto the |