Service bulletin 02-008-14
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10218201 |
| Published by NHTSA | 2022-08-22 |
| Manufacturer's number | 02-008-14 |
| Manufacturer's date | 2014-11-14 |
| NHTSA component | SUSPENSION; BACK OVER PREVENTION |
NHTSA's summary
Front End Clunk Noise When Coming To A Stop - Mexico Only This bulletin involves replacing both the left and right side front tension struts The customer may experience a front end clunk noise, coming from the tension strut bushing(s), when coming to a stop.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance, Suspension, Backup camera
| DODGE CHARGER | 2011, 2012 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 9003357 | 2024-01-02. Service bulletin. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA. |
|---|---|
| 02-007-14 | 2022-08-22. Service bulletin. Front End Clunk Noise When Coming To A Stop - Police Vehicles Only This bulletin involves replacing the left side or the right side or both side tension struts. Police vehicles with heavy duty suspension and rear wheel drive may experience a front end clunk noise, coming from the tension strut bushing(s), while coming to a stop. |
| 18-031-12 REV. A | 2022-07-25. Service bulletin. Flash: MIL Illumination P0108 - Manifold Absolute Pressure Sensor Circuit High This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that P0108 - Manifold Absolute Pressure Sensor Circuit High has been set active or stored.Updating the software will correct the condition listed above. |