WenmarOpen by Wenmar Pro

Service bulletins for the 2017 Chrysler Pacifica

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

553 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
S2208000138 REV.B2025-07-09. Service bulletin. ELECTRICAL SYSTEM. Decreased Remote Start And RKE Range. Tire Pressure Sensors Values Are Not Displayed
91006142025-06-26. Service bulletin. ENGINE. ADJUSTER Valve Lash Customer's complaint may include a ticking noise coming from the engine. Technician's observations can refer to spongy or stuck hydraulic lash adjusters. Exhaust lash adjusters found with a "spongy" condition (compressible plunger) leading to the assumption of being defective/malfunctioning. EXHAUST lash adjusters are designed to be COMPRESSIBLE by hand. Intake lash adjusters found with a stiff or stuck condition (non-compressible plunger) leading to the assumption of being defective/malfunctioning. INTAKE lash adjusters are designed to be NON COMPRESSIBLE by hand. Do Not Replace EXHAUST lash adjusters when the following condition is present: should be compressible, but they will exert a reactionary spring force during compression and return to full expansion without a compression force. Do Not Replace INTAKE lash adjusters when the following condition is present: should feel very firm and difficult to compress. Once the correct functioning of the intake and exhaust lash adjusters is validated with the procedure above, refer to the Service Manual "HYDRAULIC LIFTER(S) NOISE DIAGNOSIS" procedure. After the corresponding service procedures from the Service Manual involving the Lash Adjusters have been conducted, refer to the detailed instructions in the Service Manual to diagnose and/or service any other component.
S25230000572025-06-26. Service bulletin. SEATS. 1st Row Armrest Not Holding Position, Being Broken, Being Too Low, Or Touching The Console.
S25230000502025-05-28. Service bulletin. POWER TRAIN; ENGINE; UNKNOWN OR OTHER. Vibration From Engine Or Powertrain. Powertrain Mounting Neutralization Procedure. Discussion: Service information is in the process of being updated to include powertrain mount installation best practices. The new procedure will neutralize the mounts to lessen or remove unwanted mount tension that can lead to vibration complaints.
9100498 Rev 32025-05-19. Service bulletin. ENGINE. 3.6L PSU Long Block Misfire DTC codes and/or rough idle and/or valvetrain noise. Refer to SOL # S2509000004. It is also important to confirm that the vehicle being repaired has the latest calibration/software update for oil pump operation mode (high pressure mode) during engine start up. RU, VF, WL & WD vehicles already include the latest oil pump mode in all 25MY and beyond. 24MY service releases are also available. JL & JT were updated as a running change in 24MY and beyond (08/15/24 & 08/19/24 respectively). 24MY service releases available. DT was updated starting 25MY and beyond. If the vehicle to be repaired is a 24MY vehicle with a service release available, please follow the released service procedures to update to the corresponding calibration/software.
S2423000026 REV.A2025-05-19. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY. Power Sliding Door Will Not Power Open And/Or Close Automatically.
1035252025-04-01. Service bulletin. UNKNOWN OR OTHER. HORN AND BRACKET - NONE
S2509000001 REV.A2025-04-01. Service bulletin. ENGINE. Engine Rattle Noise
21-025-252025-03-25. Service bulletin. POWER TRAIN. "Internal Transmission Wiring Connector Short and Motor A Bearing Failure Warranty Extension XE1 : Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0A3F - Drive Motor A Position Sensor 1 Circuit. ● P0A43 - Drive Motor A Position Sensor Circuit Intermittent. ● P0A45 - Drive Motor B Position Sensor 1 Circuit. ● P0C1A - Drive Motor B Torque Delivered Performance. Customers may also comment on the following: ● Vehicle is in limp mode. NOTE: Module flashes are also required for this Repair Procedure to be effective, the following modules are to be updated: ● Hybrid Control Processor (HCP). ● Auxiliary Hybrid Control Processor (AHCP) also known as the Power Inverter Module (PIM). REPAIR SUMMARY: **This bulletin involves servicing the transmission.**"
1040942025-03-24. Service bulletin. POWER TRAIN. ID-23-07 Rev. B (XE1) eFlite Si-eVT Transmission Repair – Certain 2017 - 2023 Chrysler Pacifica (RU)
91004712025-03-19. Service bulletin. UNKNOWN OR OTHER. "CANISTER Vapor -If an issue is detected with the Evaporative System Integrity Module (ESIM) Detector and not the Vapor Canister, only replace the ESIM Detector. -Before replacing the Vapor Canister due to Hard to Fill condition, replicate the condition at the Gas Station. If the condition is replicated, then check: 1) for kinked or pinched Clean Air Hose between the ESIM and the EVAP Air Filter; 2) for plugged EVAP Air Filter; 3) for kinked or pinched Vapor Hose between the Fuel Tank and the Vapor Canister. If the EVAP Filter is restricted, the replace the Filter. -Check if the Vapor Canister is flooded with fuel or the Recirculation Line has fuel. If fuel is found in the Vapor Canister or the Recirculation Line, then drop the Fuel Tank, remove the FDM Lock Ring to check if the internal Vapor Line is properly connected to the FDM Port. If the Vapor Line is not connected, then drain the fuel from the internal Vapor Line and properly connect to the FDM. Replace the Vapor Canister and the ESIM."
1040932025-03-19. Warranty extension. POWER TRAIN. D-23-07 Rev. B (XE1) eFlite Si-eVT Transmission Repair – Certain 2017 - 2023 Chrysler Pacifica (RU)
9100498 REV 12025-03-05. Service bulletin. ENGINE. 3.6L PSU Long Block Misfire DTC codes and/or rough idle and/or valvetrain noise. These conditions may be related to worn intake camshaft high lift lobe(s), and intake rocker arm(s) high lift slider. High mileage failure (10,000-60,000 miles). 1. Remove the valve cover(s) per the released service procedures. The use of a stethoscope or DTC specific cylinder misfire codes can help to locate the condition to the left or right bank. 2. Once it has been visually confirmed that there is wear on the high lift intake lobe(s) & rocker arm(s) slider, there is a special service kit for this type of repair which should be used, instead of replacing the complete engine/long block. This kit contains the parts required for the repair (intake cam, rocker arms, sealer and gaskets). Once it is confirmed that the repair will be done using the camshaft/Rocker arms kit, it is also important to confirm that the vehicle being repaired has the latest calibration/software update for oil pump operation mode (high pressure mode) during engine start up. RU, VF, WL & WD vehicles already include the latest oil pump mode in all 25MY and beyond. 24MY service releases are also available. JL & JT were updated as a running change in 24MY and beyond (08/15/24 & 08/19/24 respectively). 24MY service releases available. DT was updated starting 25MY and beyond. If the vehicle to be repaired is a 24MY vehicle with a service release available, please follow the released service procedures to update to the corresponding calibration/software update.
1032632025-03-04. Service bulletin. STRUCTURE:BODY. RESERVOIR - COOLANT
S25090000012025-02-22. Service bulletin. ENGINE. Engine Rattle Noise
91004982025-02-12. Service bulletin. ENGINE. "3.6L PSU Long Block Misfire DTC codes and/or rough idle and/or valvetrain noise. These conditions may be related to worn intake camshaft high lift lobe(s), and intake rocker arm(s) high lift slider. High mileage failure (10,000-60,000 miles). 1. Remove the valve cover(s) per the released service procedures. The use of a stethoscope or DTC specific cylinder misfire codes can help to locate the condition to the left or right bank. 2. Once it has been visually confirmed that there is wear on the high lift intake lobe(s) & rocker arm(s) slider, there is a special service kit for this type of repair which should be used, instead of replacing the complete engine/long block. This kit contains the parts required for the repair (intake cam, rocker arms, sealer and gaskets)."
S1408000384 REV.H2025-01-28. Service bulletin. ELECTRICAL SYSTEM. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS Related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
S25230000032025-01-16. Service bulletin. STRUCTURE:BODY. Door Latch, Handle And Ajar Additional Service Information.
21-001-252025-01-14. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN. "Internal Transmission Wiring Connector Short Warranty Extension XN1 This bulletin involves replacing the transmission. *Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs):** ● P0A3F - Drive Motor A Position Sensor 1 Circuit. ● P0A43 - Drive Motor A Position Sensor Circuit Intermittent. ● P0A45 - Drive Motor B Position Sensor 1 Circuit. ● P0C1A - Drive Motor B Torque Delivered Performance. Customers may also comment on the following: ● Vehicle is in limp mode. Module flashes are also required for this Repair Procedure to be effective, the following modules are to be updated: ● Hybrid Control Processor (HCP). ● Auxiliary Hybrid Control Processor (AHCP) also known as the Power Inverter Module (PIM "
S1408000384 REV.G2025-01-09. Service bulletin. ELECTRICAL SYSTEM. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
91004682024-12-20. Service bulletin. UNKNOWN OR OTHER. FUEL VAPOR CANISTER FILTER EVAP Fuel Filters are to be checked for restriction / blockage on a regular schedule as indicated in the Owner s Manual. If the Filter is restricted or blocked then replace the part. For customers that drive light duty trucks in extreme dusty and dirty road conditions, please reference information only TSB 25-009-24 for an available MOPAR Dual EVAP Filter kit that is customer paid.
S2223000036 REV.A2024-11-22. Service bulletin. ELECTRICAL SYSTEM. Reverse View Camera Inoperative After Recent Repair
999652024-11-01. Service bulletin. UNKNOWN OR OTHER. MODULE - INVERTER
1002092024-09-05. Warranty extension. UNKNOWN OR OTHER. Warranty Newsletter Volume 10 Issue 8_ID
03-008-242024-09-04. Service bulletin. WHEELS. "Updated Front Hub Nut Torque Specification There are no Customer Symptoms for this Information Only Technical Service Bulletin (TSB). "

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.