WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Cadillac ATS

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1582 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
PIC5494H2017-08-15. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. This Preliminary Information communication provides information to the technician when the customer comments that their digital vehicle speed display is showing a different speed than the analog vehicle speed display. There may be up to 2 miles per hour difference between the digital and analog vehicle speed displays. This is a normal condition due to the calculation tolerances being different for the two driver viewing angles for the analog speedometer; it may also appear to increase the difference between both displays. No part replacement is required as this is a normal operating characteristic of the vehicle. For CTS vehicles built between April and June of 2011 or the 2013 ATS, SRX, XTS built before August 29 2012 may have a 3 mile per hour or more variation. The technician is to replace the instrument panel cluster for this concern.
PIC6086D2017-08-15. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; VISIBILITY. This Preliminary Information communication provides the technician with steps to resolve the issue of an oily substance that may be found on the inside windshield surface, and appears to be leaking from the rear view mirror area. Technician will remove the moisture sensor and clean the glass and mounting bracket with alcohol wipe. If the gel separates from the sensor the sensor will need to be replaced.
PIC5779H2017-08-15. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This Preliminary Information communication provides the technician with information on the proper washing of the bright aluminum moldings to avoid the moldings from getting damaged. It is recommended that a non-alkaline solution be used for preparation & washing of the bright aluminum moldings.
PIC5611E2017-08-15. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; BACK OVER PREVENTION: CAMERA SYSTEM. This Preliminary Information communication provides information to the technician about the rear view camera options on the vehicles equipped with rear view camera. The rear view camera brightness can be adjusted on some models while the transmission is in reverse and using the Menu or Select button. To turn off or on the guidelines in the rear view camera, use the radio display Config icon then Display, then the guidelines option.
PIP5507A2017-08-15. Service bulletin. FUEL SYSTEM, OTHER:DELIVERY:FUEL PUMP. This Preliminary information communicatesIn ambient temperatures 100F (37.7 C)degrees or higher, DTCs P2635 and/or P018B may set.The vehicle may also exhibit a hesitation or stalling condition.Excessively Hot and sustained ambient temperatures over 100F (37.7 C) degrees Mainly in TX, AZ, UT, NV, CA, NM (could be any state) causingVapor buildup in fuel feed line.Customers can be advised to utilize fuels with octane levels greater than 91, Refrain from extended idleing periods if possible, park vehicles in covered garage.Replacing the fuel pump will not repare this concern.
PIC6048G2017-08-15. Service bulletin. LANE DEPARTURE; ELECTRICAL SYSTEM; STEERING. This Preliminary Information communicates to thetechnician that some customers may comment on the operation of their haptic seat during a Lane Keep Assist event. Lane Keep Assist works differently than Lane Departure Warning. The Lane Keep Assist icon is solid amber, Forward Camera Module is actively commanding a torque to Electronic Power Steering. This means that the driver should also feel some feedback from the steering wheel. No Chimes or haptic in the seat. Lane Keep Assist icon is flashing amber; Forward Camera Module is actively commanding torque to Electronic Power Steering. This will also be accompanied with Lane Departure Warning chimes and haptic in the seat feedback based on the setting chosen in the vehicle settings. This will take place when the vehicle has crossed lane marking by (40 cm) or (15.75 in).
PI0844D2017-08-15. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This preliminary informational bulletin provides information on towing/transport recommendations for Cadillac ATS and CTS, to avoid vehicle damage.
PI0281F2017-08-15. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This preliminary informational bulletin provides information to dealership personnel which may be helpful when addressing underbody component corrosion with customers.
17-NA-1422017-08-15. Service bulletin. ELECTRICAL SYSTEM. This informational bulletin provides information on Wireless Charging Module Diagnosis.
17-NA-1362017-08-15. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS. This technical bulletin provides repair information to correct a customer or technician concern of the horizontal headlamp aim adjuster difficult or inoperative.
17-NA-1262017-08-15. Service bulletin. WHEELS:LUGS/NUTS/BOLTS/STUDS. This informational bulletin provides information on Non-Design Intent Wheel Lock Nuts and Lug Nuts.
17-NA-1092017-08-15. Service bulletin. ENGINE. This technical bulletin provides a procedure to locate and repair the engine wiring harness if found chaffing against the water outlet bolt boss.
17-NA-1022017-08-15. Service bulletin. ELECTRICAL SYSTEM:WIRING. This technical bulletin provides a procedure to replace the active shutter wiring harness to correct the codes that may have set .
17-NA-0832017-08-15. Service bulletin. FORWARD COLLISION AVOIDANCE: ADAPTIVE CRUISE CONTROL. This technical bulletin provides a procedure to perform an update on the Radar Sensor Module to reduce possibilities of the Adaptive Cruise Control not working when there are no objects detected.
16-NA-3612017-08-15. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This informational bulletin explains possible normal condition of a flare from 1st to 2nd, even if the trans had been repaired for the flare and its still noticed.
16-NA-3552017-08-15. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. this informational bulletin provides Information on Using MyBuick, MyCadillac, MyChevrolet, and MyGMC Phone Applications to Control GM Accessory Remote Start Kits.
16-NA-1752017-08-15. Service bulletin. POWER TRAIN. This technical bulletin provides a procedure to flush and drain fluids for the transmission to eliminate a shake and/or shudder during a light throttle acceleration between 40 and 128 KM/H (25 and 80 MPH) at a steady state.
16-NA-1292017-08-15. Service bulletin. SUSPENSION; ENGINE; EQUIPMENT. This informational bulletin advises the technician not to change the crankshaft balancer if it has the illusion of a wobble or vibration appearance.
16-NA-0422017-08-15. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; EQUIPMENT:ELECTRICAL. ?
15-06-03-002F2017-08-15. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY; EQUIPMENT. This informational bulletin provides information on approved warranty part numbers for original equipment batteries
11-00-89-005K2017-08-15. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This warranty administration bulletin provides information on Dealer Empowerment Labor Operations and Customer Enthusiasm.
10-08-110-001F2017-08-15. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This informational bulletin provides information on proper use of floor mats.
03-06-03-004U2017-08-15. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. This warranty administration bulletin provides policy information on the requirements for battery testing and warranty replacements.
PIT5236G2017-08-15. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. This Preliminary Information communication provides information to the technician about vehicles that have a Diagnostic Trouble Code B101D stored in Telematics Communication Interface Control Module. Technician will check Global Warranty Management system for customer satisfaction program 15086 status. If the status of the customer satisfaction program 15086 was not completed follow the steps to get the Telematics Communication Interface Control Module replaced. If the status of customer satisfaction program 15086 is found completed contact General Motors Technical Assistance Center OnStar group for further assistance.
PIP5331B2017-08-15. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician that some vehicles may have rattle, tick, or knock type noise. If there are any drivability concerns they should be addressed prior to the following diagnostic progression. Technician will take a sound file or video with sound of the noise prior to dis-assembly. Technician may find this noise hard to isolate to one area in the engine. There are four different steps to take to diagnosis the concern. Technician will perform injector diagnosis to ensure there are no leaking injectors causing a noise due to excessive fuel in any one cylinder. Replace any out of specification injectors the reevaluate for the noise. Technician will remove the intake manifold and visually inspect for excessive carbon on the intake valve stems and top of the valve causing noise. If carbon is present then follow the latest version of PIP5029 to clean the valves or replace heads as needed. Technician will remove the cam cover of the affected bank (both if needed) to inspect for soft or spongy stationary hydraulic lash adjusters. Push down on the rocker end at the stationary hydraulic lash adjusters to test for soft or spongy. If soft or spongy stationary hydraulic lash adjusters are found, carefully remove the affected head and inspect the oil passage below the head gasket for debris. If debris is found, inspect the camshaft caps for wear or discoloration due to lack of oil. During inspection if wear or discoloration is found then replace the cylinder head assembly with camshafts. If there is no wear or discoloration, clean the oil passages and replace the head gasket. Technician will use chassis ears or a stethoscope; listen to the right and left side of the engine. Once the noise is isolated or if unable to isolate, remove the piston and rod assemblies from the affected bank(s) to inspect for either; a loose rod bushing in the rod, or a loose wrist pin in the bushing. If this is found, replacing the piston an

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.