Service bulletin SSM 51950

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10243654
Published by NHTSA	2023-10-06
Manufacturer's number	SSM 51950
Manufacturer's date	2023-09-28
NHTSA component	POWER TRAIN; ENGINE AND ENGINE COOLING

NHTSA's summary

Some 2021-2023 F-150 vehicles equipped with a 3.5L PowerBoost engine may exhibit an illuminated powertrain malfunction (wrench) lamp with diagnostic trouble code (DTC) P084B stored in the powertrain control module (PCM)

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Engine, Transmission and driveline

Trouble codes named

P084B

Vehicles listed
FORD F-150	2021, 2022, 2023

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
2026311	2026-06-24. Powertrain
26V402000	2026-06-24. POWER TRAIN:AUTOMATIC TRANSMISSION
2025691	2025-12-12. Powertrain
25V863000	2025-12-12. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:PARK PAWL
2025414	2025-08-08. Powertrain
25V512000	2025-08-08. POWER TRAIN:AXLE HUBS
2025137	2025-03-14. Powertrain
25V169000	2025-03-14. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM)
2024492	2024-08-23. Engine
24V635000	2024-08-23. ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
SSM 55228	2026-10-12. Service bulletin. Some 2020-2026 Aviator/Explorer/F-150/Bronco/Ranger vehicles equipped with a 2.7L or 3.0L (non-diesel) engine may need the front engine cover removed and reinstalled for various reasons. The Workshop Manual (WSM), Section 303-01 Engine > Removal and Installation > Engine Front Cover service procedure has been updated to include a new essential special service tool (ESST) guide pin alignment tool (303-1790) that is used to align the engine front cover to the engine block, preventing the O-ring seal on the engine oil galley feed tube from getting damaged during installation.
TSB 26-2408	2026-09-30. Service bulletin. This bulletin supersedes 26-2309. Reason For Update: update the Model section to remove Aviator 10R80, update the Parts list to add 3.3L to W520514-S440, and add L1MZ-7Z490-G valve body separator plate for Aviator. Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: * Harsh 3-4, 4-5 upshifts * Harsh 5-3, 4-3 downshifts * Harsh reverse engagements These symptoms may be worse when cold. This may be due to the F clutch friction plates brinelling into the clutch and planetary container cylinder (7B177).
TSB 26-2395	2026-09-01. Service bulletin. This article supersedes 26-2287. Reason for update: update the labor operation numbers to add MT to operations C, F, G, H, J, K, L and M, and correct the part number LIMZ-4A015-B to L1MZ-4A015-B. Some of the vehicles listed in the Model statement above may exhibit at least one of the following conditions: Harsh engagement Delayed engagement Harsh shift Delayed shift Illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC)s P0751, P0752, P0756, P0757, P0761, P0762, P0766, P0767, P0771, P0772, P2700, P2701, P2702, P2703, P2704, P2705, P2707, P2708, P0729, P0731, P0732, P0733, P0734, P0735, P0736, P076F, P07D9, P07F6 and/or P07F7 stored in the powertrain control module (PCM) or transmission control module (TCM). This may be due to axial movement of the CDF clutch cylinder sleeve causing hydraulic circuit leaks. NOTE: If internal transmission service is required to address a concern detected with the CDF clutch cylinder following this article, technicians should carefully inspect and replace other transmission components and flush transmission fluid cooler only as ne
PT-26.13.13 F-150 Ltng	2026-08-18. Over-the-air update. 25C69 Recall remedy - Updates the Secondary On-Board Diagnostic Module C to provide for release of the Integrated Park Module slider in the event a bind condition occurs allowing park to be engaged
TSB 26-2360	2026-08-10. Service bulletin. Some of the vehicles listed in the Model Statement above may exhibit an intermittent extended crank with no relevant diagnostic trouble codes (DTCs) present. This may be due to various software parameters in the powertrain control module (PCM).
25M01	2026-08-04. Other. Customer Satisfaction Program 25M01 Certain 2021 Model Year F-150 3.0L Diesel Engine and 2020-2022 Model Year Super Duty with 6.7L Diesel Engine Nitrogen Oxide (NOx) Sensor Replacement, If Required After Dealer Evaluation Reference: Emissions Recalls 22E02, 22E04, 23E01, and 25E09
SSM55059	2026-08-03. Service bulletin. Some 2021-2023 F-150 vehicles equipped with a 3.5L PowerBoost engine, 2020-2026 Explorer vehicles equipped with a 3.3L hybrid engine, and 2020-2023 Lincoln Aviator vehicles equipped with a 3.0L EcoBoost hybrid engine may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P0A1E stored in the powertrain control module (PCM). The vehicle may be unable to enter electric-only drive modes as expected during normal drive cycles. This may be due to the belt integrated starter generator (BISG). For vehicles with this condition, follow the necessary Pinpoint Test in Workshop Manual (WSM), Section 303-06 for DTC P0A1E and repair the vehicle as directed. Note that previous replacement of the BISG does not negate the need for subsequent BISG replacements if directed to do so by the appropriate Pinpoint Test diagnostics. Engineering is investigating this BISG quality concern. Monitor PTS for updates regarding this investigation.
PT-26.11.3 F-150	2026-07-28. Over-the-air update. 25S75 Recall remedy -Powertrain Control Module update to introduce logic to prevent low pressure fuel pump binding and maintain fuel flow to the engine.
TSB 26-2294	2026-07-13. Service bulletin. This bulletin supersedes 26-2066. Reason for update: To remove "(2024 only)" from the Issue statement to include 2021-2025 vehicles that may exhibit a clicking sound coming from the gear shift lever. Some of the vehicles listed in the Model statement above equipped with a console GSM may exhibit at least one of the following conditions: * Clicking sound coming from the gear shift lever after it is placed and kept in reverse, neutral or drive position. * Gear shift lever stuck in park * Gear shift lever will not shift into park * Gear shift lever will not shift out of gear * Gear shift lever will not stow/unstow * Gear shift lever will move past the park position * Loose gear shift lever arm at pivot * Illuminated powertrain malfunction (wrench) indicator with DTCs P0929:77, P0929:00, P0929:07 and/or P0929:9A stored in the GSM This may be due to the GSM. Note: If the gear shifter lever will not shift into park, the transmission will automatically shift into park when the return to park function is triggered.
TSB 26-2304	2026-07-06. Service bulletin. This bulletin supersedes 25-2383. Reason for update: to add 2023-2026 F-150 2.7L vehicles. Some of the vehicles listed in the Model Statement may exhibit a vibration/shudder felt during light throttle tip in at highway speeds (8,9,10 gear) with no diagnostic trouble codes (DTC) present. This may be due to various software parameters in the powertrain control module (PCM).