Service bulletins for the 2017 Subaru Crosstrek
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
338 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| 01-168-09R | 2017-10-27. Service bulletin. EQUIPMENT. The purpose of this bulletin is to provide replacement key and immobilizer information along with an overview of the Subaru Lock Information web-site. |
|---|---|
| 15-204-16 | 2017-10-27. Service bulletin. EQUIPMENT; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This bulletin contains illustrations of exchange components and their manufacturer as well as a description of the proper exchange procedure. The exchange program policy can also be found in Sections 8.4.9 and 11.2.10 of your Claims Policies and Procedures Manual found in Subarunet. |
| 15-204-16R | 2017-09-14. Service bulletin. EQUIPMENT. This bulletin contains illustrations of exchange components and their manufacturer as well as a description of the proper exchange procedure. The exchange program policy can also be found in Sections 8.4.9 and 11.2.10 of your Claims Policies and Procedures Manual found in Subarunet. |
| 12-224-17R | 2017-09-14. Service bulletin. STRUCTURE:BODY:ROOF AND PILLARS. This bulletin provides a procedure for replacement of the black foam rubber insulating cushions for the roof rails. In rare cases, the cushion(s) may come loose and begin to protrude from under the roof rails where they contact the body. |
| 07-119-17 | 2017-09-14. Service bulletin. EXTERIOR LIGHTING. This Service Information bulletin announces a production method change to the rear combination lamp assembly. The application procedure of the anti-fog coating was changed to prevent a customer concern of visible drip marks (or streaks) appearing on the inside of the lamp lens. |
| 07-118-17R | 2017-09-14. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT:ELECTRICAL. Models with SRVD Only. This bulletin provides revised diagnostic and repair procedures to address DTC B2327 for the Subaru Rear Vehicle Detection (SRVD), Blind-Spot Detection (BSD) and Rear Cross Traffic Alert (RCTA) system on the applicable models listed above. Under very specific (rare) conditions, the radar function of the SRVD system may experience a communication error and cause the SRVD warning lamp to illuminate. In addition, under certain highway driving conditions, an improper signal calculation by the system may cause a Cancel Code B2328 to set which will also cause the SRVD warning lamp to illuminate. |
| 02-168-17 | 2017-09-14. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:BELTS AND ASSOCIATED PULLEYS; ENGINE. This Service Information bulletin announces a material change to the engine accessory drive / v-belt made to address customer concerns of a slipping belt (squeal or chirping) sound. |
| 02-166-17R | 2017-09-14. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin outlines design changes made to the upper oil pan assembly on FA and FB engines used on the models listed above. There have been isolated cases where the sealer used between the upper oil pan and the crankcase has become displaced resulting in engine oil seepage. Revisions made to the upper oil pan casting: * The mating flange thickness of the casting in the area identified as the cause for the seepage has been increased by 5.5mm. (See images provided in the Parts Information section below.) This thickness increase creates the need for a longer bolt to provide proper tightening and retention. * An additional mounting point has been added to the ribbing inside the casting to increase retention of the steel baffle plate and eliminate vibration. |
| 01-174-16 | 2017-08-14. Service bulletin. EQUIPMENT:ELECTRICAL; VISIBILITY:WINDSHIELD. This Service Information bulletin provides a guideline to use for placement of required or mandated windshield stickers (inside and / or outside) on vehicles equipped with EyeSight Driver Assist Technology and High Beam Assist (HBA) features. Examples of these types of stickers include: * Government facility / Military base access stickers * State-mandated Vehicle Safety Inspection and Emission Compliance stickers * Parking Permit Stickers The cameras used by both of these features require a clear, unobstructed "view" through the windshield for their proper operation. The illustration below shows the "Prohibited area" in gray. Any stickers mandated to be placed within the Prohibited area should be placed to the right of the EyeSight stereo camera and HBA camera, outside of the Prohibited area as shown in the illustration below. Viewed from inside the vehicle, the left edge of the sticker must be placed no more than 14 inches (slightly less is preferred as a "cushion" for measuring variation) from the right edge of the windshield as shown in the illustration and indicated by the box outlined in blue. Always consult state and local regulations applicable to windshield sticker placement. |
| 15-196-16R | 2017-08-14. Service bulletin. ELECTRICAL SYSTEM. ONLY 2016-2017MY: Those Models equipped with STARLINK Telematics. Provisioning is the process by which the DCM receives the subscription request and activates the related DCM features requested as outlined in the specific subscription contract. If provisioning is not successful then the DCM may remain in an inactive state and the requested services may not be activated for the customer. Field investigation has found that this may be a result of three possible conditions. * The DCM may be off the network due to vehicle storage or other network factors. * The DCM may be lacking power or ground due to some body side electrical concern. * The DCM may have an internal failure. |
| 15-204-16R | 2017-08-14. Service bulletin. EQUIPMENT:ELECTRICAL; EQUIPMENT ADAPTIVE/MOBILITY. This bulletin contains illustrations of exchange components and their manufacturer as well as a description of the proper exchange procedure. The exchange program policy can also be found in Sections 8.4.9 and 11.2.10 of your Claims Policies and Procedures Manual found in Subarunet. CONTENTS Within the terms of the Basic New Car Warranty and the one year Replacement Parts Warranty, the Exchange Program provides for replacement of a defective unit from the manufacturer. |
| 02-166-17 | 2017-08-14. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin outlines design changes made to the upper oil pan assembly on FA and FB engines used on the models listed above. There have been isolated cases where the sealer used between the upper oil pan and the crankcase has become displaced resulting in engine oil seepage. |
| 09-64-16 | 2017-08-14. Service bulletin. FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY. This Service Information bulletin announces a change to the shape of the rubber cap used on the flange nuts securing the sub-level sending unit to the fuel tank. In addition, two of the caps are now used in production instead of only one. This change was made to enhance productivity during vehicle assembly. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.