WenmarOpen by Wenmar Pro

Service bulletins for the 2019 Ram 2500

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

776 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Suspension are shown. Show all

Bulletins, newest first
02-002-25 REV. A2025-09-17. Service bulletin. SUSPENSION. Shock And Strut Diagnosis And Replacement Guidelines Leaking, noisy, or weak shocks or struts.
02-002-252025-05-30. Service bulletin. SUSPENSION. "Shock And Strut Diagnosis And Replacement Guidelines Leaking, noisy, or weak shocks or struts. "
91002292023-10-30. Service bulletin. SUSPENSION. LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect.
08073202022-09-26. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); SUSPENSION; SUSPENSION:FRONT:SPRINGS:AIR SUSPENSION SYSTEM; ELECTRICAL SYSTEM. Flash: Air Suspension Control Module (ASCM) Updates This bulletin involves reprogramming the ASCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or moreof the following DTCs have been set: U0132 - Loss of Communication with Air Suspension Control Module. C15E1-97 - Left Rear Air Spring Intake - Component or System Operation Obstructedor Blocked. C220C-48 - Active Suspension Module Internal-Supervision Software Failure(2019 MY Only). C211B-92 - Ignition Run/Start Input-Performance Or Incorrect Operation(2019 MY Only). C156C-7A - Ride Height System Air Leak-Fluid Leak Or Seal Failure(2019 MY Only). In addition the customer may describe: Air spring deflated or ruptured. Right/left rear suspensions sits lower than the other side. During key ?On? or while driving, the ?service air suspension?light illuminates. Chime and "Service Air Suspension Immediately" message appeared in the clusterfor 5 seconds. Air suspension system is inoperable. Excessive operation or noise from air suspension system when vehicle is stationary(2019 MY Only). "Air Suspension Disabled" message when attempting Bed Lowering Mode (BLM)(2019 MY Only). Excessive compressor valve cycling following a cold start(2019 MY with Diesel engine only). Erroneous "Bed Low Achieved" message through the Instrument Panel Cluster (IPC), when requesting lowering, even though the truck didn'tphysically lower. Ride height changes/valve actuations without operator request on rough roads.
S19170000022022-09-26. Service bulletin. ELECTRICAL SYSTEM; SUSPENSION. ASCM U0132 Loss Of Communication With Suspension Control Module (IPC) DTC
08-175-212021-12-13. Service bulletin. SUSPENSION:REAR:SPRINGS:AIR SUSPENSION SYSTEM; ELECTRICAL SYSTEM; SUSPENSION; SUSPENSION:FRONT:SPRINGS:AIR SUSPENSION SYSTEM. Flash: Air Suspension Control Module (ASCM) Updates This bulletin involves reprogramming the ASCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following DTCs have been set:U0132 - Loss of Communication with Air Suspension Control Module. C15E1-97 - Left Rear Air Spring Intake - Component or System Operation Obstructed or Blocked. C220C-48 - Active Suspension Module Internal-Supervision Software Failure(2019 MY Only). C211B-92 - Ignition Run/Start Input-Performance Or Incorrect Operation(2019 MY Only). C156C-7A - Ride Height System Air Leak-Fluid Leak Or Seal Failure(2019 MY Only). In addition the customer may describe:Air suspension system is inoperable. During key ?On? or while driving, the ?service air suspension? light illuminates. Air spring deflated or ruptured. Right/left rear suspensions sits lower than the other side. Chime and "Service Air Suspension Immediately" message appeared in the cluster for 5 seconds. Excessive operation or noise from air suspension system when vehicle is stationary(2019 MY Only). "Air Suspension Disabled" message when attempting Bed Lowering Mode (BLM)(2019 MY Only). Excessive compressor valve cycling following a cold start(2019 MY with Diesel engine only). Erroneous "Bed Low Achieved" message through the Instrument Panel Cluster (IPC), when requesting lowering, even though the truck didn't physically lower. Ride height changes/valve actuations without operator request on rough roads.
S21210000102021-06-28. Service bulletin. SUSPENSION. Service 4WD Lamp On, 4WD System Does Not Work, 4WD Service Lamp Flashing, Front Axle Disconnect Does Not Engage Or Disengage
S1917000002 Rev.2021-05-24. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); ELECTRICAL SYSTEM; SUSPENSION. ASCM U0132 Loss Of Communication With Suspension Control Module (IPC) DTC
90020542021-03-22. Service bulletin. STEERING; SUSPENSION. If replacing the steering linkage or drag link inner tie rod assembly at the pitman arm on a vehicle built before Febuary 14 th, 2008, verify that the pitman arm part number is 68039930AA. The part number is embossed on the pitman arm.~If the pitman arm is not a 68039930AA, it must be replaced with a 68039930AA.~ Issue 2: For 2003 to 2007 MY only. If the OE steering linkage has been replaced with 52122362AA, 52122362AB, 52122362AC, 52122362AD, 52122362AE, or 52122362AF and pitman arm 68039930AA the following service parts are available.
23-032-202020-12-21. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; SUSPENSION:REAR. Noise From Rear of Cab Area While Driving Over Rough Roads or Bumps This bulletin involves inspecting and replacing the C-Pillar body mounts if needed. The customer may describe a rattling noise heard around the C-Pillar area or back of the cab, while driving the vehicle overrough or bumpy roads.
08-073-202020-09-28. Service bulletin. ELECTRICAL SYSTEM; SUSPENSION:REAR:SPRINGS:AIR SUSPENSION SYSTEM. Flash: Air Suspension Control Module (ASCM) Updates This bulletin involves reprogramming the ASCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or moreof the following DTCs have been set: U0132 - Loss of Communication with Air Suspension Control Module. C15E1-97 - Left Rear Air Spring Intake - Component or System Operation Obstructedor Blocked. C220C-48 - Active Suspension Module Internal-Supervision Software Failure(2019 MY Only). C211B-92 - Ignition Run/Start Input-Performance Or Incorrect Operation(2019 MY Only). C156C-7A - Ride Height System Air Leak-Fluid Leak Or Seal Failure(2019 MY Only). In addition the customer may describe: Air spring deflated or ruptured. Right/left rear suspensions sits lower than the other side. During key ?On? or while driving, the ?service air suspension?light illuminates. Chime and "Service Air Suspension Immediately" message appeared in the clusterfor 5 seconds. Air suspension system is inoperable. Excessive operation or noise from air suspension system when vehicle is stationary(2019 MY Only). "Air Suspension Disabled" message when attempting Bed Lowering Mode (BLM)(2019 MY Only). Excessive compressor valve cycling following a cold start(2019 MY with Diesel engine only). Erroneous "Bed Low Achieved" message through the Instrument Panel Cluster (IPC), when requesting lowering, even though the truck didn'tphysically lower. Ride height changes/valve actuations without operator request on rough roads.
PC-08.21.20192020-09-19. Service bulletin. SUSPENSION; STEERING. Pro Comp Performance Suspension has found instances on the 2019 Ram 2500 4WD that the drag link cannot be adjusted short enough to center the steering wheel. If you are experiencing this scenario, this TSB advises a corrective action to get the vehicle aligned properly.
90041572020-04-06. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); POWER TRAIN; SUSPENSION; ELECTRICAL SYSTEM. MODULE, Air Suspension, [SEB] For replacement of Air Suspension Control Module (ASCM) due to the following DTCs, please contact FCA Redacted Content to aid in root-cause prior to repair at FCA Redacted Content or FCA Redacted Content U0132 (Loss of Comm) U0421 (Implausible Data) C220C (Software Supervision) C15DE-72 (Exhaust Solenoid Actuator Stuck Open) If no response in 15 minutes, proceed with repair. As per STAR Online case S1917000002: Do not replace any components. First record the DTC?s by creating and saving a vehicle scan report with WiTECH under the reports tab. Next, attempt to reset the ASCM by removing the F50 20A ASCM fuse in the Power Distribution Center. Then reinstall the fuse. Using WiTECH check for DTC?s. If U0132, U0421, U0422 DTCs are now stored, clear them. Perform a short test drive. If the codes do not return do not repair. Condition is under investigation by engineering.
90041232020-01-21. Service bulletin. SUSPENSION. DJ D2 Air Suspension Related Components For an air suspension light or any air suspension concern on 2019 or 2020 MY DJ D2, please call Phil Cataldo at (248) 220-0559 or Yussimil Libera at (248) 550-6086. If no response in 15 minutes, proceed with repair. Please be sure to accurately document the events and conditions associated with these concerns.
90041572019-12-02. Service bulletin. ELECTRICAL SYSTEM; SUSPENSION. MODULE, Air Suspension, [SEB] For replacement of Air Suspension Control Module (ASCM) due to the following DTCs, please contact Santiago De La Rosa to aid in root-cause prior to repair at (248) 635-0819 or santiago.delarosa@fcagroup.com U0132 (Loss of Comm) U0421 (Implausible Data) C220C (Software Supervision) C15DE-72 (Exhaust Solenoid Actuator Stuck Open) If no response in 15 minutes, proceed with repair.
08-041-19 REV. A2019-10-28. Service bulletin. SUSPENSION. Flash: Air Suspension Control Module (ASCM) Updates This bulletin involves reprogramming the ASCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following DTCs have been set:C220C-48 - Active Suspension Module Internal-Supervision Software Failure. C211B-92 - Ignition Run/Start Input-Performance Or Incorrect Operation. C156C-7A - Ride Height System Air Leak-Fluid Leak Or Seal Failure. In addition the customer may describe:Excessive operation or noise from air suspension system when vehicle is stationary. "Air Suspension Disabled" message when attempting Bed Lowering Mode (BLM). Excessive compressor valve cycling following a cold start(Diesel engine only). Erroneous "Bed Low Achieved" message through the Instrument Panel Cluster (IPC), when requesting lowering, even though the truck didn't physically lower. Ride height changes/valve actuations without operator request on rough roads.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.