WenmarOpen by Wenmar Pro

Service bulletins for the 2014 Nissan NV200

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

141 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
NTB03074J2021-05-10. Service bulletin. EXTERIOR LIGHTING. SERVICE INFORMATION Occasionally customers may notice water vapor or fog in the headlamps. The information, illustrations, and flow chart in this bulletin are provided to help you in determining if an incident for water/condensation in the headlamps is normal or not. Nissan?s new vehicle limited warranty does not cover physically damaged (cracked or broken) headlamps. All current headlamp assemblies are vented to the atmosphere (not sealed). - This is necessary to allow for expansion and contraction of air from temperature "variations" (warmer or colder) without damage to the headlamp. - Moisture in the air sometimes "travels" into and out of the headlamp assembly through these vents. - Certain environmental conditions may cause moisture to condense. - The fogging/cloudiness should disappear over time when the headlamp is in a dry environment. See this bulletin for further detail.
NTB160182021-05-10. Service bulletin. ELECTRICAL SYSTEM. IF YOU CONFIRM The MIL is "ON" with DTC P0603 (ECM BACK UP/CIRCUIT). ACTION 1. Confirm that the battery voltage is 11 volts, or more, with the ignition ON (engine OFF, not running). 2. Erase DTC 3. Perform DTC confirmation steps in the Service Procedure. 4. Confirm 1st trip DTC P0603 is not stored. NOTE: P0603 is often the result of low battery voltage, discharged battery or battery terminal disconnections. Please see this bulletin for furtner details.
NTB15093B2021-05-10. Service bulletin. VISIBILITY. SERVICE INFORMATION If the LINK-WIPER, NO 1 (drive link) on the wiper assembly needs to be replaced for any reason, a new part is available. If replacing the drive link, use the SERVICE PROCEDURE starting on page 2 to install the new part listed in PARTS INFORMATION. Please see this bulletin for further details.
NTB09081C2021-05-10. Service bulletin. VISIBILITY. SERVICE INFORMATION The purpose of this bulletin is to give Nissan dealers guidelines to help determine if windshield breakage is covered under warranty or is the customer?s responsibility. Nissan North America (NNA) is not responsible for damage to glass that is a result of objects striking or scratching the glass. However, NNA is responsible for manufacturing issues such as distorted glass and cracks that are due to improper installation or damage to the glass during vehicle assembly. NNA typically does not find any type of cracks in the windshield due to stress after the dealership PDI. See this bulletin for further detail.
NTB160122021-05-10. Service bulletin. LATCHES/LOCKS/LINKAGES. SERVICE INFORMATION The slide door operating cables for the handles and locks for the applied vehicles in this bulletin are now available as service parts. Refer to SERVICE PROCEDURE starting on page 2 for replacement procedure. See this bulletin for further detail.
NTB09022G2021-05-10. Service bulletin. ELECTRICAL SYSTEM. SERVICE INFORMATION Design and process changes have been made to improve battery voltage at dealer receipt. Our goal is to deliver vehicles to customers with a 12 volt battery in excellent condition. Proper dealership storage and maintenance of vehicle 12 volt batteries is essential to insuring good battery operating life and customer satisfaction. Dealers are responsible for maintaining vehicles in their inventory. 12 volt batteries in vehicle inventory should always be kept at a full charge to prevent excessive discharge during storage and so they are ready for delivery to customers at any time. See this bulletin for further detail.
NTB151042021-05-10. Service bulletin. EQUIPMENT. IF YOU CONFIRM * The key cannot be removed from the ignition. And/or * The Shifter will not move out of park. ACTION a. Adjust the key interlock cable. b. Adjust the stop lamp switch. NOTE: Nissan vehicle warranty does not cover incidentsdue to lack of vehicle maintenance and/or physical damage. Refer to the Nissan Assurance Products Resource Manual (APRM) for complete guidelines on warranty coverage. Please see this bulletin for further details.
NTB13028A2021-05-10. Service bulletin. VISIBILITY. SERVICE INFORMATION Windshield "foreign material" that is on the surface of the glass in some cases can be cleaned off with a very particular type and grade of steel wool. * Most any foreign material on the surface of the Windshield can be cleaned off by using #0000 super fine steel wool. >The #0000 grade super fine steel wool can be found in most hardware stores. Please see this bulletin for further details.
NTB160102021-05-10. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. IF YOU CONFIRM The A/C condenser has a crack and leak in the area shown in Figure 1. ACTION Replace the A/C condenser and the radiator core support lower. See this bulletin for further detail.
NTB150942021-05-10. Service bulletin. AIR BAGS. IF YOU CONFIRM The "air conditioning" (A/C) compressor clutch needs to be replaced. ACTION 1. Remove the A/C compressor assembly from the vehicle. 2. Inspect the A/C compressor refrigerant oil condition. * If the A/C compressor refrigerant oil is BROWN, replace the A/C compressor assembly. * If the A/C compressor refrigerant oil is LIGHT GREEN and does not have any foreign materials replace only the A/C compressor clutch. Please see this bulletin for further details.
NTB12099D2021-05-10. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). SERVICE INFORMATION: The Navigation (NAVI) SD Map Data Cards are not interchangeable between the two versions of NAVI units offered in Nissan vehicles that use this type of map data. * If the wrong SD Map Data Card is used, the NAVI will display an update screen (Figures 1 and 2, reference only) and will only accept Cancel. * If this screen is displayed, install the correct SD Map Data Card, found in table A on page 2, and the NAVI unit will return to correct operation. See this bulletin for further detail.
NTB150882021-05-10. Service bulletin. SEATS; VEHICLE SPEED CONTROL. SERVICE INFORMATION If you confirm there is a need to replace the slide window "INFORMATION" label on an Applied Vehicle for any reason (scratches, worn appearance, etc.): - Do not replace the slide window latch finisher. The "INFORMATION" label is available as a separate service part. - Follow the procedure on page 2 when replacing the label. See this bulletin for further detail.
NTB15042A2021-05-10. Service bulletin. SEATS; EQUIPMENT. SERVICE INFORMATION If the A/C compressor on an Applied Vehicle is being replaced for any reason, perform the following: 1. Evacuate the system?s refrigerant. 2. Record the amount evacuated (this will determine if step 4 applies). NOTE: Make sure your Robinair/Tech-Mate Air-Conditioning Machine # 48710 is calibrated. 3. Replace the compressor with the one listed in FAST or your electronic parts catalog. - Refer to the applicable Electronic Service Manual (ESM), section HAC-Heater & Air Conditioning System, for compressor removal and installation procedure. 4. If the amount initially evacuated was less than 600 grams (1.32 pounds), check for leaks and repair as needed. 5. Evacuate and charge the A/C system. - Ideal refrigerant charge amount: 700 grams (1.54 pounds) - Acceptable charge amount: 700 grams +/- 50 grams (1.54 pounds +/- 0.11 pounds) NOTE: Do not use the charge capacity value listed in NV200 Taxi ESMs. See this bulletin.
NTB13088A2021-05-10. Service bulletin. BACK OVER PREVENTION; WHEELS; SERVICE BRAKES; LANE DEPARTURE. SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for: - Basic diagnosing of TPMS/LTPWS systems - Radio frequency interference causing a "No Data" (C1708, C1709, C1710, C1711) condition - Sensor leaks - Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration - Air pressure changes with altitude and ambient temperatures - Aftermarket tire sealers - Aftermarket wheels - Inflating/deflating tires with TPMS/LTPWS sensors See this bulletin for further detail.
NTB14057A2021-05-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. SERVICE INFORMATION The information in this bulletin is provided to help ensure correct diagnosis and repair of fluid leaks. All fluid leaks, when properly diagnosed, should be repaired (whether under warranty or customer pay) to ensure proper vehicle operation. However, certain normal operating conditions can be misdiagnosed as a leak requiring repair. Unnecessary repair or replacement of parts in connection with incorrectly diagnosed "leaks" can negatively impact customer satisfaction, be time consuming and costly, and if not performed correctly can lead to future repairs. See this bulletin for further detail.
NTB12055E2021-05-10. Service bulletin. WHEELS; POWER TRAIN; EQUIPMENT; BACK OVER PREVENTION. IF YOU CONFIRM: Customers concern of a "clicking" noise coming from either left or right front/rear CV-type axles during take-off/acceleration. ACTION: Apply Molykote M77 grease (P/N 44003-7S000) to the hub bearing surfaces. NOTE: * Do not remove the axle from the hub or transmission for this bulletin * Refer to the Electronic Service Manual (ESM) for model specific torque specifications. - For 2007-2013 Versa and 2013 LEAF vehicles, see the Service Procedure torque specifications on page 4. See this bulletin for further detail.
NTB150602021-05-10. Service bulletin. SERVICE BRAKES; WHEELS; BACK OVER PREVENTION; STEERING; EQUIPMENT. SERVICE INFORMATION When servicing run flat tires or low profile tires: - Special equipment and procedures are required to avoid damage. - Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires. - TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. - To avoid such damage, ensure that the tire changer being used and the operator of the tire changer is capable of servicing run flat and low profile tires. - Operator?s manuals for such tire changers must be followed. See this bulletin for further detail.
NTB150552021-05-10. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. SERVICE INFORMATION After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for emissions soon after ECM reprogramming. See this bulletin for further detail.
NTB15022A2021-05-10. Service bulletin. POWER TRAIN. IF YOU CONFIRM The engine cranks but does not start after an overnight or extended cold soak during below-freezing weather conditions, AND DTC U1000 is found stored in one or more systems. ACTION Connect/splice together specific wiring in the EGI harness as stated in the Service Procedure. NOTE - DO NOT replace the ECM if this incident should occur. See this bulletin for further detail.
NTB150352021-05-10. Service bulletin. LANE DEPARTURE. SERVICE INFORMATION If you confirm there is a need to replace the combination meter front cover (lens) on an Applied Vehicle for any reason (scratch, blemish, etc.): - Do not replace the entire combination meter assemby. The front cover of the combination meter assembly is available as a separate service part. - Refer to the Electronic Service Manual, section MWI-Meter, Warning Lamp & Indicator, for replacement information. See this bulletin for further detail.
NTB150322021-05-10. Service bulletin. BACK OVER PREVENTION. SERVICE INFORMATION The 2014-2015 NV200 Taxi CVT is equipped with a fluid level gauge (dipstick). The dipstick and dipstick charging pipe enable the technician to quickly check, and if needed, add CVT fluid. Noise from the CVT can be caused by incorrect fluid level (fill amount). Make sure the CVT fluid level is checked correctly and is filled to the correct level. See this bulletin for further detail.
NTB14088B2021-05-10. Service bulletin. BACK OVER PREVENTION; STEERING; SUSPENSION; ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); SEATS; EQUIPMENT; WHEELS. IF YOU CONFIRM: There is a noise (clunking, popping, or bumping) when the steering wheel is turned AND the noise is coming from the top of either front strut assembly. NOTE: The location of the noise can be determined by using Essential Tool J39570 (Chassis Ear), positioning a clamp on each front strut spring, and then turning the steering wheel back and forth. ACTION: Install a spacer in both the left front and right front strut assemblies where shown in this bulletin. - Refer to the Electronic Service Manual (ESM), section FSU- Front Suspension for removal and installation instructions. See this bulletin for further detail.
NTB10112E2021-05-10. Service bulletin. WHEELS. SERVICE INFORMATION For vehicles delivered to the dealers with wheel protector covers - Do not remove the wheel protector covers during Pre-Delivery Inspection (PDI) - Wheel protector covers help prevent cosmetic rotor corrosion. See this bulletin for further detail.
NTB150172021-05-10. Service bulletin. POWER TRAIN. IF YOU CONFIRM: One or a combination of the following: - The MIL is ON and DTC P0776 (PC SOLENOID B [Pressure Control Solenoid "B" Performance/Stuck Off]) is stored. - The customer states the vehicle lacks power when accelerating. - The customer states there is a slow or delayed engagement after shifting into Drive or Reverse. ACTION: 1. Compare the vehicle?s current TCM part number to the part number listed in Table A (see page 4). 2. If vehicle?s current TCM part number matches the part number listed in Table A, reprogram the TCM. See this bulletin for further detail.
NTB99060G2021-05-10. Service bulletin. EQUIPMENT. SERVICE INFORMATION NOTE - Failure to follow the procedures in this bulletin may result in the denial of a warranty claim. In an effort to protect the paint finish, Paint Guard Film (PGF) is applied on many new Nissan vehicles. Paint Guard Film is a temporary white plastic protective film that is applied by the factory to the horizontal painted surfaces of the vehicle. The PGF protects the paint finish during vehicle handling, transportation and storage from harmful elements such as acid rain, iron particles, bird droppings, tree sap and other environmental contaminants. NOTE - Paint Guard Film CANNOT remain on the vehicle for more than six months after the vehicle's manufacture date. PGF must be removed at the end of six months. See this bulletin for further detail.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.