Service bulletin NTB14088B

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10192550
Published by NHTSA	2021-05-10
Manufacturer's number	NTB14088B
Manufacturer's date	2015-04-01
NHTSA component	BACK OVER PREVENTION; STEERING; SUSPENSION; ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); SEATS; EQUIPMENT; WHEELS

NHTSA's summary

IF YOU CONFIRM: There is a noise (clunking, popping, or bumping) when the steering wheel is turned AND the noise is coming from the top of either front strut assembly. NOTE: The location of the noise can be determined by using Essential Tool J39570 (Chassis Ear), positioning a clamp on each front strut spring, and then turning the steering wheel back and forth. ACTION: Install a spacer in both the left front and right front strut assemblies where shown in this bulletin. - Refer to the Electronic Service Manual (ESM), section FSU- Front Suspension for removal and installation instructions. See this bulletin for further detail.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Driver assistance, Equipment and accessories, Seats, Steering, Suspension, Wheels, Backup camera

Vehicles listed
NISSAN JUKE	2013
NISSAN LEAF	2013, 2014, 2015
NISSAN NV200	2013, 2014, 2015
NISSAN NV200 TAXI	2014, 2015 (the catalog's model; the bulletin names a series or trim of it)
NISSAN SENTRA	2013, 2014

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
NTB13106E	2021-05-10. Service bulletin. SERVICE INFORMATION If the configuration of the Audio/Navigation unit has not been completed correctly, some of the symptoms that may occur are: * Intermittent or no back up camera operation * No steering wheel switch response to audio inputs * No volume response from volume knob * Volume very loud or very quiet and adjustment is overly sensitive * Equalizer is adjusted so that Bass control is at maximum all the time * DTC U1000 for AVM C/U could be present If the above symptoms occur: * Confirm the configuration of the Audio/Navigation unit is correct. NOTE: Correct configuration of the appropriate control unit will restore correct operation. Audio/Navigation unit configuration is outlined starting on page 2. See this bulletin for further detail.
NTB13088A	2021-05-10. Service bulletin. SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for: - Basic diagnosing of TPMS/LTPWS systems - Radio frequency interference causing a "No Data" (C1708, C1709, C1710, C1711) condition - Sensor leaks - Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration - Air pressure changes with altitude and ambient temperatures - Aftermarket tire sealers - Aftermarket wheels - Inflating/deflating tires with TPMS/LTPWS sensors See this bulletin for further detail.
NTB15068	2021-05-10. Service bulletin. IF YOU CONFIRM * A rattle noise inside the vehicle coming from the engine compartment or instrument panel and/or a brake pedal vibration is present at idle in drive. And * The engine room harness is in contact with the air filter assembly ACTION * Install a zip tie to secure the engine room harness to the driver?s side frame rail. Please see this bulletin for further information.
NTB12055E	2021-05-10. Service bulletin. IF YOU CONFIRM: Customers concern of a "clicking" noise coming from either left or right front/rear CV-type axles during take-off/acceleration. ACTION: Apply Molykote M77 grease (P/N 44003-7S000) to the hub bearing surfaces. NOTE: * Do not remove the axle from the hub or transmission for this bulletin * Refer to the Electronic Service Manual (ESM) for model specific torque specifications. - For 2007-2013 Versa and 2013 LEAF vehicles, see the Service Procedure torque specifications on page 4. See this bulletin for further detail.
NTB15060	2021-05-10. Service bulletin. SERVICE INFORMATION When servicing run flat tires or low profile tires: - Special equipment and procedures are required to avoid damage. - Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires. - TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. - To avoid such damage, ensure that the tire changer being used and the operator of the tire changer is capable of servicing run flat and low profile tires. - Operator?s manuals for such tire changers must be followed. See this bulletin for further detail.
NTB15032	2021-05-10. Service bulletin. SERVICE INFORMATION The 2014-2015 NV200 Taxi CVT is equipped with a fluid level gauge (dipstick). The dipstick and dipstick charging pipe enable the technician to quickly check, and if needed, add CVT fluid. Noise from the CVT can be caused by incorrect fluid level (fill amount). Make sure the CVT fluid level is checked correctly and is filled to the correct level. See this bulletin for further detail.
NTB14001C	2021-05-10. Service bulletin. IF YOU CONFIRM The vehicle has insufficient heat based on the "PTC Heater Specifications" on page 2. And The vehicle?s current EV/HEV software version for the "Vehicle Control Module" (VCM) is in "Table A" on page 8. * Refer to step 14 on page 8 in the SERVICE PROCEDURE to check current EV/HEV software version. NOTE: One or more of the following DTC?s below may be present: * B2773 PTC Heater Circuit 1 * B2774 PTC Heater Circuit 2 ACTION 1. Reprogram the VCM with CONSULT-III plus (C-III plus). 2. Replace the PTC heater. Please see this bulletin for further details.
NTB00042D	2021-05-10. Service bulletin. SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat-Mounted Side-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail.
NTB13031A	2021-05-10. Service bulletin. IF YOU CONFIRM: A creak type noise (like walking on a wood floor) coming from the rear brakes as the brake pedal is applied. - This noise is usually heard when applying the brake pedal at very low speeds i.e. parking lot speeds AND / OR - When applying the brake pedal while the vehicle is stopped. ACTION: Replace both rear wheel cylinders with those from the Parts Information table below. - Refer to the appropriate section of the Electronic Service Manual for the procedure to replace wheel cylinders. See this bulletin for further detail.
NTB11088B	2021-05-10. Service bulletin. SERVICE INFORMATION When replacing (exchanging) an A/V Control Unit, do not remove the Map SD Card. The Map SD Card is matched to the unit. If an A/V Control Unit is sent to Clarion without the Original Map SD Card, Clarion will NOT accept it. The A/V Control Unit will be sent back to the dealer. See this bulletin for further detail.