WenmarOpen by Wenmar Pro

Service bulletin NTB15088

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10192651
Published by NHTSA2021-05-10
Manufacturer's numberNTB15088
Manufacturer's date2015-10-13
NHTSA componentSEATS; VEHICLE SPEED CONTROL

NHTSA's summary

SERVICE INFORMATION If you confirm there is a need to replace the slide window "INFORMATION" label on an Applied Vehicle for any reason (scratches, worn appearance, etc.): - Do not replace the slide window latch finisher. The "INFORMATION" label is available as a separate service part. - Follow the procedure on page 2 when replacing the label. See this bulletin for further detail.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Seats, Throttle and cruise control

Vehicles listed
NISSAN NV200 TAXI2014, 2015 (the catalog's model; the bulletin names a series or trim of it)

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
20161792016-04-25. Seats And Restraints

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
NTB19-071C2023-04-10. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB15042A2021-05-10. Service bulletin. SERVICE INFORMATION If the A/C compressor on an Applied Vehicle is being replaced for any reason, perform the following: 1. Evacuate the system?s refrigerant. 2. Record the amount evacuated (this will determine if step 4 applies). NOTE: Make sure your Robinair/Tech-Mate Air-Conditioning Machine # 48710 is calibrated. 3. Replace the compressor with the one listed in FAST or your electronic parts catalog. - Refer to the applicable Electronic Service Manual (ESM), section HAC-Heater & Air Conditioning System, for compressor removal and installation procedure. 4. If the amount initially evacuated was less than 600 grams (1.32 pounds), check for leaks and repair as needed. 5. Evacuate and charge the A/C system. - Ideal refrigerant charge amount: 700 grams (1.54 pounds) - Acceptable charge amount: 700 grams +/- 50 grams (1.54 pounds +/- 0.11 pounds) NOTE: Do not use the charge capacity value listed in NV200 Taxi ESMs. See this bulletin.
NTB14088B2021-05-10. Service bulletin. IF YOU CONFIRM: There is a noise (clunking, popping, or bumping) when the steering wheel is turned AND the noise is coming from the top of either front strut assembly. NOTE: The location of the noise can be determined by using Essential Tool J39570 (Chassis Ear), positioning a clamp on each front strut spring, and then turning the steering wheel back and forth. ACTION: Install a spacer in both the left front and right front strut assemblies where shown in this bulletin. - Refer to the Electronic Service Manual (ESM), section FSU- Front Suspension for removal and installation instructions. See this bulletin for further detail.