WenmarOpen by Wenmar Pro

Service bulletins for the 2022 Infiniti QX60

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

119 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Body and frame are shown. Show all

Bulletins, newest first
ITB09-063C2026-04-29. Service bulletin. STRUCTURE:BODY. CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Infiniti by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
ITB26-0042026-04-29. Service bulletin. STRUCTURE:BODY. FRONT FASCIA POPPING OUT NEAR HEADLAMP IF YOU CONFIRM The Front Bumper Fascia is detaching from the fender under the headlamp on one/or both sides. ACTION Refer to the SERVICE PROCEDURE in this bulletin to: 1. Remove the Front Bumper Fascia. 2. Replace the affected Headlamp Bracket. 3. Replace the affected Front Bumper Fascia Side Bracket. 4. Reinstall the Front Bumper Fascia, with Betaseal (or equivalent) adhesive between the Front Bumper Fascia and the affected side Front Bumper Fascia Side Bracket.
ITB25-0082025-06-04. Service bulletin. STRUCTURE:BODY. EXCESS DUST ENTERING CABIN WHILE DRIVING ON DIRT ROADS IF YOU CONFIRM That while driving on dirt roads with all doors and windows closed, that there is excessive dust intrusion into the vehicle’s cabin that is settling on the inside of the doors. ACTION Refer to the SERVICE PROCEDURE in the bulletin to: 1. Install Butyl Patches around the door seals of driver (LH) side and passenger (RH) side front and rear doors. 2. Install drain plugs into door drains of driver (LH) side and passenger (RH) side front and rear doors.
ITB23-0272023-12-08. Service bulletin. SEATS; STRUCTURE. POWER FOLDING 3RD ROW SEAT SYSTEM CALIBRATION SERVICE INFORMATION Obstructions such as unfolded headrests or objects left in the vehicle may prevent the power folding 3rd row seat from returning to the upright position under power: • Verify that the 3rd row seat headrests are folded forward. o If the 3rd row seat headrests are not folded forward, the headrests can contact the 2nd row seats and prevent the power folding 3rd row seat from returning upright. • Verify that the floor between the 2nd and 3rd row seats is clear of any obstructions. o If there are obstructions on the floor, clear the obstructions and try to move the seat upright. • If the 3rd row seat headrests are folded forward and there are no obstructions, perform system calibration before attempting to replace any parts. o Refer to the ESM: BODY INTERIOR > SEAT > BASIC INSPECTION > SYSTEM CALIBRATION > Work Procedure If the power folding 3rd row seat does not return upright under power after performing system calibration, refer to the ESM for further diagnosis.
ITB23-0252023-11-08. Service bulletin. VISIBILITY:SUN/MOON ROOF ASSEMBLY; STRUCTURE. GURGLING NOISE FROM MOONROOF AFTER IT RAINS IF YOU CONFIRM The client states they hear a gurgling / drip / drain noise from the moonroof while driving in the rain. ACTION Follow the SERVICE PROCEDURE in this bulletin to replace the front driver (LH) and front passenger (RH) side moonroof drain tube grommets.
ITB23-018A2023-10-06. Service bulletin. STRUCTURE:BODY:DOOR; STRUCTURE. AUTOMATIC BACK DOOR PARTIALLY OPENS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB23-0242023-09-08. Service bulletin. STRUCTURE; VISIBILITY:SUN/MOON ROOF ASSEMBLY. NOISE FROM MOONROOF WHEN OPEN IF YOU CONFIRM Ticking / flutter / vibrating noise when the moonroof (sunroof) is open and the vehicle is traveling 35-50 mph. ACTION Follow the SERVICE PROCEDURE outlined in this bulletin to install a strip of soft foam in the sunroof opening. IMPORTANT: Do not replace the Wind Deflector to correct the noise concern
ITB23-0182023-06-07. Service bulletin. STRUCTURE. AUTOMATIC BACK DOOR PARTIALLY OPENS IF YOU CONFIRM The automatic back door will only open partially and then will change to “manual mode” when using the Intelligent Key, back door request button, or the interior dash button, OR Any one or combination of the DTCs listed below are stored in AUTO BACK DOOR ECU. • U2154-87 CAN Comm Circuit • B2417-15 Touch Sensor Circuit LH Open • B2416-15 Touch Sensor Circuit RH Open • B2426-25 Spindle Sensor LH • B2427-11 Spindle Sensor RH • B2437-13 Spindle Motor RH ACTION Replace the Automatic Back Door Control Unit.
ITB20-006C2023-03-07. Service bulletin. VISIBILITY; STRUCTURE. WINDSHIELD WIPER BLADE PERFORMANCE/DIAGNOSIS SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB13-007H2023-03-07. Service bulletin. VISIBILITY; STRUCTURE. REMOVING FOREIGN MATERIAL FROM THE WINDOW GLASS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB09-039J2023-03-07. Service bulletin. VISIBILITY; STRUCTURE. WINDSHIELD CRACKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB22-0342022-10-07. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE. POWER BACK DOOR INTERMITTENT OPERATION AND DTCS STORED IN AUTO BACK DOOR ECU SERVICE INFORMATION If you confirm the power back door does not operate or has intermittent operation, and any of the following DTCs are stored in the AUTO BACK DOOR ECU: • B2422-78 (Back Door Position Abnormal) • B2422-79 (Back Door Position Abnormal) • B2426-11 (Spindle Sensor LH) • B2426-13 (Spindle Sensor LH) • B2426-25 (Spindle Sensor LH) • B2427-11 (Spindle Sensor RH) • B2427-13 (Spindle Sensor RH) • B2427-25 (Spindle Sensor RH) • B242A-13 (Closure Motor) • B2436-11 (Spindle Motor LH) • B2436-13 (Spindle Motor LH) • B2436-19 (Spindle Motor LH) • B2437-11 (Spindle Motor RH) • B2437-13 (Spindle Motor RH) • B2437-19 (Spindle Motor RH) Refer to the information provided in this bulletin to determine if the back door stays’ (spindles’) wire harness connector (#4 and #10 in Figure 1) has a spread terminal.
ITB22-011A2022-10-07. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE. AUTOMATIC BACK DOOR INOPERATIVE This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB22-0112022-05-20. Service bulletin. STRUCTURE:BODY; ELECTRICAL SYSTEM. AUTOMATIC BACK DOOR INOPERATIVE SERVICE INFORMATION If you confirm the automatic (power) back door is inoperative (e.g., the door will not open, close, latch, etc.): • Refer to ASIST and the ESM for diagnostic information. • If further troubleshooting per the ESM is needed, note that the Automatic Back Door Control Unit only needs to be recalibrated per the Work Procedure in CONSULT if the following work is performed: o Removing and installing, or replacing the Automatic Back Door Control Unit o Removing and installing, or replacing the Automatic Back Door Spindle Unit o Removing and installing, or replacing the Back Door Assembly NOTE: Attempting to recalibrate the Automatic Back Door Control Unit while troubleshooting other components in the Power Back Door (PBD) system such as the hatch latch, electrical wiring harnesses, control buttons or touch sensors, can cause the recalibration to fail, which erroneously generates DTC B2428-54 (AUTOMATIC BACK DOOR CONTROL UNIT) and leads to unnecessary replacement of the Automatic Back Door Control Unit.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.