WenmarOpen by Wenmar Pro

Service bulletins for the 2022 Infiniti QX55

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

73 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
ITB21-008A2023-01-10. Service bulletin. SEATS. FRONT DRIVER AND/OR PASSENGER SEAT WILL NOT MOVE FORWARD This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB22-0412022-12-06. Service bulletin. POWER TRAIN. DRIVE SHAFT BOOT SERVICE INFORMATION SERVICE INFORMATION If a Drive Shaft (Axle Shaft) Boot on an APPLIED VEHICLE is found to be leaking grease, AND There is no abnormal noise or obvious CV Joint risk due to water intrusion and/or complete grease loss, check for REPAIR KIT-DUST BOOT (cv Joint Boot Kit) availability. • If there is a REPAIR KIT-DUST BOOT (CV Joint Boot Kit) available for the vehicle being repaired, do NOT replace the axle. Install a new boot kit following the procedure in the ESM. o Refer to the ESM: TRANSMISSION & DRIVELINE > FRONT AXLE > REMOVAL AND INSTALLATION > FRONT DRIVE SHAFT BOOT o If the complete axle (drive shaft) is replaced when only a new boot is required, the over-repair may be charged back to the retailer. • If there is NOT a REPAIR KIT-DUST BOOT (CV Joint Boot Kit) available for the vehicle being repaired, refer to the ESM for further diagnostic information. IMPORTANT: When servicing vehicles with staked axle nuts, refer to ITB21-002 to prevent Drive Shaft thread damage.
ITB12-072I2022-12-06. Service bulletin. POWER TRAIN. ABNORMAL NOISE, VIBRATION AND/OR BINDING FEELING FROM REAR DIFFERENTIAL This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB19-029D2022-11-12. Service bulletin. ELECTRICAL SYSTEM. TELEMATICS (IVC) SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin.
ITB22-025A2022-10-07. Service bulletin. ENGINE AND ENGINE COOLING; VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM. ROARING NOISE FROM THE ENGINE COOLING FAN ASSEMBLY AND THE A/C IS NOT COOLING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB13-008C2022-10-07. Service bulletin. POWER TRAIN. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
PC911 2022-23 QX2022-08-31. Service bulletin. TIRES; WHEELS. Tire Inspection ***** Retailer Announcement ***** INFINITI is conducting a quality action on 848 specific 2022-2023 QX50 and QX55 (J55) vehicles in connection with an on-going investigation. Retailers will inspect the tires and, if necessary, replace each tire that has a cut outer sidewall. Due to a manufacturing concern, which since has been corrected, the tires may have been damaged during vehicle assembly. Affected vehicles are subject to stop sale and are either currently in retailer inventory or assigned and in transit to the retailer. NOTE: Parts replaced under this quality action will be collected through the INFINITI Part Return Program to help with INFINITIY's continued investigation. If a Part Return Required Notification is received by the retailer, it is important for retailers to return the parts applicable specifically to the VIN and repair identified.
ITB12-072H2022-08-26. Service bulletin. POWER TRAIN. INFINITI AWD MODELS; ABNORMAL NOISE, VIBRATION AND/OR JUDDER FROM REAR DIFFERENTIAL This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB21-026A2022-08-26. Service bulletin. ELECTRICAL SYSTEM. SOFTWARE UPDATE FOR CLOCK INCORRECT This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB21-023A2022-08-26. Service bulletin. POWER TRAIN. TRANSFER ASSEMBLY SEAL REPLACEMENT FOR AWD FRONT DRIVE SHAFT REMOVAL This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB17-001D2022-08-26. Service bulletin. POWER TRAIN. FLUID LEAK CAUSED BY TRANSFER ASSEMBLY RIGHT SIDE DRIVE SHAFT OIL SEAL This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB22-0152022-06-03. Service bulletin. FUEL SYSTEM, GASOLINE. SERVICE INFORMATION FOR FUEL GAUGE INACCURATE WITH DTCS STORED IN ECM SERVICE INFORMATION If a fuel level sensor has been diagnosed as sending an incorrect level signal, and one or more of the following DTCs are stored in the ECM, do not replace the entire “Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly” (fuel pump assembly). The fuel level sensor can be replaced separately. • P0460 (FUEL LEV SEN SLOSH) • P0461 (FUEL LEVEL SENSOR) • P0462 (FUEL LEVL SEN/CIRC) • P0463 (FUEL LEVL SEN/CIRC) NOTE: Warranty claims referring to fuel level issues that result in the replacement of the entire fuel pump assembly will be charged back.
ITB22-0062022-03-12. Service bulletin. ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:12V/24V/48V BATTERY. BATTERY QUICK CHARGE NOTICE SERVICE INFORMATION When charging the vehicle’s 12 volt battery with the high amperage quick charge function, the ignition should never be ON, or turned ON, while charging. Attempting to start the vehicle, or turning the ignition ON, while using the high amperage quick charge could potentially damage the fuel pump control module. • Only turn the ignition ON when either the ESM or a technical service bulletin service procedure states to do so, and only while using a battery maintainer or smart charger set to reflash mode, or a similar setting. • Battery voltage should not exceed 16V during a reprograming operation.
ITB13-044J2022-03-12. Service bulletin. FUEL SYSTEM, OTHER; ENGINE AND ENGINE COOLING. EVAP LEAK DTC P0442, P0455, P0456 INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB13-006C2022-03-12. Service bulletin. ELECTRICAL SYSTEM. CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB10-029B2022-02-09. Service bulletin. ELECTRICAL SYSTEM. CAN COMMUNICATION CODES – DIAGNOSTIC TIPS AND GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB03-074P2022-01-08. Service bulletin. EXTERIOR LIGHTING. HEADLAMP, FOG LAMP, OR REAR COMBINATION LAMP FOGGING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB21-0262022-01-08. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. SOFTWARE UPDATE FOR CLOCK INCORRECT IF YOU CONFIRM One or more of the following occurs: • The clock resets to 1:00. • The clock changes 4-6 hours ahead of actual time. • Set Clock Manually icon is grayed out. ACTION 1. Confirm that the Infotainment software version is not 4710. See Check Software Version on page 3. 2. If the Infotainment software version is not 4710, perform Update AV Control Unit starting on page 5. 3. Manually set the clock time and date to complete the infotainment update.
ITB17-033C2022-01-08. Service bulletin. EXTERIOR LIGHTING. CLEANING FRONT OR REAR COMBINATION LAMP ASSEMBLIES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB03-051P2022-01-08. Service bulletin. EXTERIOR LIGHTING. HEADLAMP, FOG LAMP, OR REAR COMBINATION LAMP FOGGING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB21-0252021-12-08. Service bulletin. EQUIPMENT:ELECTRICAL. DTC C1A17-49 STORED IN LASER/RADAR SERVICE INFORMATION If DTC C1A17-49 (ICC SENSOR MALF) is stored in LASER/RADAR in the “PAST” column: • Erase the DTC. • DO NOT replace any parts. If DTC C1A17-49 (ICC SENSOR MALF) is stored in LASER/RADAR in the "CURRENT" column, refer to the applicable ESM for instructions.
ITB20-006B2021-12-08. Service bulletin. VISIBILITY:WINDSHIELD; VISIBILITY:WINDSHIELD WIPER/WASHER. WINDSHIELD WIPER BLADE PERFORMANCE/DIAGNOSIS SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB21-0212021-10-13. Service bulletin. STRUCTURE. REAR HATCH INOPERATIVE OR NOISE WHEN OPENING/CLOSING IF YOU CONFIRM The client states that either the rear hatch is inoperative, or the rear hatch closes after opening only a small amount, AND DTC B2426-23 SPINDLE SENSOR LH and/or DTC B2427-23 SPINDLE SENSOR RH is stored, AND/OR There is a growling type noise from the rear hatch area when opening/closing the rear hatch. • DTC B2426-23 SPINDLE SENSOR LH and/or DTC B2427-23 SPINDLE SENSOR RH may also be stored. NOTE: If any DTC other than B2426-23 and/or B2427-23 is stored, this bulletin does not apply. ACTION Replace ONLY the spindle unit that is confirmed to be setting one of the DTCs listed above and/or causing the growling noise. Do NOT replace both spindle units when diagnosis leads to replacement of only one. HINT: Rear hatch spindle units are not hydraulic systems. If a rear hatch spindle unit appears to be leaking, this is normal drainage of water (rain, car wash, condensation) and design intended water management. Do not replace spindle units for suspected leaking.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.