WenmarOpen by Wenmar Pro

Service bulletin ITB22-041

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10227253
Published by NHTSA2022-12-06
Manufacturer's numberITB22-041
Manufacturer's date2022-11-23
NHTSA componentPOWER TRAIN

NHTSA's summary

DRIVE SHAFT BOOT SERVICE INFORMATION SERVICE INFORMATION If a Drive Shaft (Axle Shaft) Boot on an APPLIED VEHICLE is found to be leaking grease, AND There is no abnormal noise or obvious CV Joint risk due to water intrusion and/or complete grease loss, check for REPAIR KIT-DUST BOOT (cv Joint Boot Kit) availability. • If there is a REPAIR KIT-DUST BOOT (CV Joint Boot Kit) available for the vehicle being repaired, do NOT replace the axle. Install a new boot kit following the procedure in the ESM. o Refer to the ESM: TRANSMISSION & DRIVELINE > FRONT AXLE > REMOVAL AND INSTALLATION > FRONT DRIVE SHAFT BOOT o If the complete axle (drive shaft) is replaced when only a new boot is required, the over-repair may be charged back to the retailer. • If there is NOT a REPAIR KIT-DUST BOOT (CV Joint Boot Kit) available for the vehicle being repaired, refer to the ESM for further diagnostic information. IMPORTANT: When servicing vehicles with staked axle nuts, refer to ITB21-002 to prevent Drive Shaft thread damage.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Transmission and driveline

Vehicles listed
INFINITI Q402016
INFINITI Q502016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
INFINITI Q50 HYBRID2016, 2017, 2018 (the catalog's model; the bulletin names a series or trim of it)
INFINITI Q602016
INFINITI Q602017, 2018, 2019, 2020, 2021, 2022
INFINITI Q702016, 2017, 2018, 2019
INFINITI Q70 HYBRID2016, 2017, 2018 (the catalog's model; the bulletin names a series or trim of it)
INFINITI Q70L2019
INFINITI QX302017, 2018, 2019
INFINITI QX502016, 2017
INFINITI QX502018
INFINITI QX502019, 2020, 2021, 2022, 2023
INFINITI QX552022, 2023
INFINITI QX602016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
INFINITI QX60 HYBRID2016, 2017, 2018, 2019 (the catalog's model; the bulletin names a series or trim of it)
INFINITI QX702016, 2017
INFINITI QX802016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
INFINITI rQ50 HYBRID2019

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
20243622024-06-21. Powertrain
24V4700002024-06-21. POWER TRAIN:DRIVELINE:DRIVESHAFT
20216132021-10-05. Powertrain

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
ITB24-0012024-03-08. Service bulletin. ENGINE SUPPORT TOOLS SERVICE INFORMATION A new Engine Support Tool, Engine Support Bracket, and CVT Transmission Jack Adapter are now available to allow the CVT to be removed from the APPLIED VEHICLES without having to remove the engine. The procedure in this bulletin is different from the procedure currently in the ESM, which will be updated with this information at a later date. Please refer to the SERVICE PROCEDURE in this bulletin for information on how to use these new tools: • Front Wheel Drive (FWD) – pages 4 - 25 • All Wheel Drive (AWD) – pages 26 - 52
ITB21-023B2024-01-09. Service bulletin. TRANSFER ASSEMBLY SEAL REPLACEMENT FOR AWD FRONT DRIVE SHAFT REMOVAL This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB17-001E2024-01-09. Service bulletin. FLUID LEAK CAUSED BY TRANSFER ASSEMBLY RIGHT SIDE DRIVE SHAFT OIL SEAL This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB23-0222023-08-08. Service bulletin. DTC P0744 STORED IN THE TCM IF YOU CONFIRM DTC P0744 (TORQUE CONVERTER) is stored as PAST or CURRENT in the TCM. ACTION Follow the SERVICE PROCEDURE in this bulletin to reprogram the TCM.
ITB13-055D2023-05-24. Service bulletin. CVT/TCM CALIBRATION DATA “WRITE” PROCEDURE This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB13-008D2023-04-04. Service bulletin. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB22-0392022-12-06. Service bulletin. VIBRATION DURING LIGHT OR MODERATE THROTTLE INPUT IF YOU CONFIRM A vibration during light or moderate throttle input between 20 – 40 mph, OR RPM flare / slip feeling / vibration during or immediately after a 2 – 3 upshift or 3 – 4 upshift with light or moderate throttle input. ACTION Replace the Torque Converter.
ITB12-072I2022-12-06. Service bulletin. ABNORMAL NOISE, VIBRATION AND/OR BINDING FEELING FROM REAR DIFFERENTIAL This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
ITB13-008C2022-10-07. Service bulletin. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
REVISION 2 QX602022-08-31. Service bulletin. CVT Warranty Extension UPDATE August 30, 2022 Please discard earlier versions of this bulletin. The announcement from June 2, 2022 has been revised to include: • The voucher program ID numbers provided in the FAQ section of this retailer announcement have been changed. The new voucher program ID numbers are: • INFINITI program ID: 22I2299CVT • Nissan program ID: 22N2299CVT