WenmarOpen by Wenmar Pro

Service bulletins for the 2017 GMC Yukon

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1580 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Transmission and driveline are shown. Show all

Bulletins, newest first
PIP4021D2019-03-11. Service bulletin. POWER TRAIN. This Preliminary Information communication provides information to the technician that a whine noise heard from the automatic transmission fluid pan hear with the the key on and engine off, or for up to one minute after the vehicle has been shut off should be deemed a normal characteristic.
PIP55762018-10-15. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION; POWER TRAIN. This Preliminary information communicatesSES lamp, setting DTC P0333 when shifting the Transmissionfrom park.DTC P0333 cansetdue to voltage from the Transmission park/neutral signal 1circuit bleeding into the knock sensor system circuits.If SI does not isolate the concern inspect the K20 ECM connector X2 looking for debris, connectorand or terminal concerns.
PIP3366C2018-08-20. Service bulletin. POWER TRAIN:TRANSFER CASE (4-WHEEL DRIVE); POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary information communicates to the dealer technician thatLight Duty Trucks equipped with automatic transmissions and 4 wheel drive may exhibit a condition of grinding/ratcheting type noise when shifting the automatic transmission into park while the transfer case is in 4 wheel drive low (4LO) range. Dealers technician's are advised this condition should be deemed a normal characteristic of 4WD low operation.
PIT5457C2018-08-06. Service bulletin. AIR BAGS; POWER TRAIN; STEERING; SUSPENSION; EQUIPMENT:ELECTRICAL; TRACTION CONTROL SYSTEM. This Preliminary Information communication provides information to the technician about vehicle with Service ABS and/or Traction control lights/message on, Service Power Steering System, Service Suspension System, and or Loss of communication with EBCM, SWPS, PSCM, and/or SCM. Technician may find Diagnostic Trouble Codes U0077, U0121, U0126, U0131, U0139, U0401, U0415, and/or U0428. Technician should remove the driver and passenger sill plate to gain access to the wire harness. If any open, damaged, or corroded wires should be repaired.
16-NA-1752018-06-11. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. This technical bulletin provides a procedure to flush and drain fluids for the transmission to eliminate a shake and/or shudder during a light throttle acceleration between 40 and 128 KM/H (25 and 80 MPH) at a steady state.
060089026N2018-06-04. Service bulletin. ELECTRICAL SYSTEM; VISIBILITY:SUN/MOON ROOF ASSEMBLY; STRUCTURE:BODY:DOOR; POWER TRAIN:TRANSFER CASE (4-WHEEL DRIVE); VISIBILITY:WINDSHIELD; ELECTRONIC STABILITY CONTROL (ESC). This warranty bulletin provides labor operation numbers for customer concerns that cant be duplicated.
PIE0405C2018-06-04. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. This engineering informational bulletin is requesting information from the field on vehicles that have the condition of a Torque Converter Shudder.
16NA1752018-06-04. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This technical bulletin provides a procedure to flush and drain fluids for the transmission to eliminate a shake and/or shudder during a light throttle acceleration between 40 and 128 KM/H (25 and 80 MPH) at a steady state.
080730026E2018-06-04. Service bulletin. POWER TRAIN. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped.
040730013D2018-06-04. Service bulletin. POWER TRAIN; ENGINE; EQUIPMENT. This informational bulletin provides information to dealership personnel on automatic transmission shift and engine drivability concerns and/or MIL ON due to aftermarket oil bath air filter use.
PIP4112R2018-05-21. Service bulletin. EQUIPMENT; POWER TRAIN; ENGINE. This Preliminary Information communication provides information to the technician of a complaint of a sag or hesitation when accelerating. The concern is present when coasting at low speeds of less than 15 miles per hour and then aggressively applying the throttle, or after making a hard stop followed by an aggressive throttle. This is considered normal operation of the vehicle the throttle is delayed and opened slowly up to .7 seconds to help minimize driveline lash and clunking or will have approximately .5 seconds of zero torque to allow the transmission to shift to first gear.
17-NA-0702018-05-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This Technical bulletin provides information on new software to correct a hesitation, chuggle, fishbite or roughness that can be felt in gear ranges 3rd - 6th gear V8 mode, TCC locked, low RPMs (1200 &-1300 when tipping into throttle to load engine.
17-NA-0662018-05-21. Service bulletin. POWER TRAIN. This warranty administration bulletin provide policy information for automatic transmission Oil Cooler Flush and flow test.
16-NA-1752018-05-21. Service bulletin. EQUIPMENT; POWER TRAIN. This technical bulletin provides a procedure to flush and drain fluids for the transmission to eliminate a shake and/or shudder during a light throttle acceleration between 48 and 104 KM/H (30 and 65 MPH) at a steady state.
PIP5248D2018-05-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015–0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that “mating” surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped.
17-NA-0662018-05-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This warranty administration bulletin provide policy information for automatic transmission Oil Cooler Flush and flow test.
080730035C2018-05-21. Service bulletin. POWER TRAIN. This bulletin provides information on the harmful effects of water or ethylene glycol in transmission fluid.
PIT5308C2018-05-21. Service bulletin. ELECTRICAL SYSTEM; FUEL SYSTEM, DIESEL; POWER TRAIN; ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that have remote start is inoperative, power lift gate Regular Production Option Code (TB5) is inoperative with the ignition off, Crank no start, Start and Stall, and vehicles equipped with the diesel engine, the blower motor may stay on after the engine is turned off. Technician may find Diagnostic Trouble Code P2537 and/or P129Dset. Technician will need to Use a voltmeter and check circuit 5985 at the Engine Control Module and Transmission Control Module. If no or low voltage is found, use the wiring diagram in Service Information and perform normal circuit diagnosis.
060089031E2018-05-21. Service bulletin. ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION. This informational bulletin provides information on OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification.
16NA3382018-05-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. This Bulletin provides guidelines for Dealers required to contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
16NA3382018-05-07. Service bulletin. POWER TRAIN. This Bulletin provides guidelines for Dealers to determine whether or not they need to contact the PQC for an engine, transmission or transfer case assembly replacement and information explaining the PQC process, Global Warranty Management Transaction submission, vehicle repair record retention and proper handling of assembly returns.
17336 02 (Bullet2018-05-07. Service bulletin. POWER TRAIN. 17336 02 - Special Coverage (Parts and Service Procedure Revised). On some vehicles, may have a condition where thermal cycling on the combination transmission fluid/oil and AC condenser cooler creates a crack that may allow refrigerant to escape. This condition consequently may deactivate the AC system which may cause potential customer annoyance. Dealers are to inspect the air conditioning condenser and replace if necessary. The repairs will be made at no charge to the customer.
PIE0419A2018-04-23. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION. This engineering informational bulletin ends the need for information from the field on vehicles that have the condition of Harsh, Delayed, and/or Improper Shifts.
PIE0405B2018-04-23. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. This engineering informational bulletin is requesting information from the field on vehicles that have the condition of a Torque Converter Shudder.
PIT5481C2018-02-21. Service bulletin. AIR BAGS; POWER TRAIN; ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); FUEL SYSTEM, DIESEL:STORAGE:TANK ASSEMBLY; STEERING; LANE DEPARTURE. This Preliminary Information communication provides information to the technician with additional information on the functionality of Lane Keep Assist.Starting with2016 model year Lane Keep Assist Regular Production Option Code (UHX) replaced Lane Departure Warning Regular Production Option Code (UFL). Lane Keep Assist is designed to assist the driver in keeping the vehicle from drifting out of a driving lane that has clearly identified markings. The electric power steering provides a gentle steering correction if a lane marking has been crossed and the driver has not actively responded.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.