Service bulletins for the 2015 GMC Sierra
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
3109 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Driver assistance are shown. Show all
| PIT4322P | 2024-03-18. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC). This Preliminary Information communication provides information to the technician about vehicles that have an unwanted Stability Activation and/or a Service Stability message on the Driver Information Center. Technician may find a Diagnostic Trouble Code C0710. Technician should inspect for vehicles modifications before any in-depth diagnostics are performed. |
|---|---|
| 15NA082B | 2024-02-12. Service bulletin. BACK OVER PREVENTION. Clunking Noise from Front of Vehicle During Turns and/or Bumps |
| 15NA082 | 2024-02-12. Service bulletin. BACK OVER PREVENTION. Clunking Noise from Front of Vehicle During Turns and/or Bumps |
| PIT5386J | 2024-01-29. Service bulletin. BACK OVER PREVENTION; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that are found to have a back-up alarm inoperative during the Pre-Delivery Inspection. On trucks equipped with the Back Up Alarm (RPO 8S3), the alarm will be intentionally left disconnected from the assembly plant. Technician will reroute the harness and plug it in. |
| PIT4322G | 2023-12-26. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC). Unwanted Stability Activation and/or C0710. |
| 140604004 | 2023-12-11. Service bulletin. BACK OVER PREVENTION; ENGINE AND ENGINE COOLING. Various Engine Noises During Cold Start and Warm Engine Operation |
| 140604003 | 2023-12-11. Service bulletin. FUEL SYSTEM, DIESEL; FUEL SYSTEM, GASOLINE; BACK OVER PREVENTION. Identifying Non-GM ECM Calibration Use and Power-Up Hardware Detection in Duramax® Diesel Engines Using GDS 2 |
| PIT5277C | 2023-12-04. Service bulletin. BACK OVER PREVENTION. No Audio Except Chime Distorted Or Inoperative Rear Camera -No Audio- Displayed On Audio Page In DIC. |
| PIT5277A | 2023-12-04. Service bulletin. BACK OVER PREVENTION. No Audio Except Chime Distorted Or Inoperative Rear Camera -No Audio- Displayed On Audio Page In DIC. |
| PIT5277 | 2023-12-04. Service bulletin. BACK OVER PREVENTION. No Audio Except Chime Distorted Or Inoperative Rear Camera -No Audio- Displayed On Audio Page In DIC. |
| PIT5272 | 2023-12-04. Service bulletin. BACK OVER PREVENTION. Whistle Noise From Inside Vehicle. |
| PIT4322G | 2023-11-20. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC). Unwanted Stability Activation and/or C0710. |
| PIP5395G | 2023-08-21. Service bulletin. BACK OVER PREVENTION; FUEL SYSTEM, GASOLINE. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have rattle or ticking noise that is louder inside the vehicle than outside. The noise may also sound like a lifter tick. If the noise is heard best at the fuel line and the sound will be real loud with a stethoscope. The fuel line will need to be replaced. |
| PIT4322N | 2023-03-13. Service bulletin. AIR BAGS; ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC). This Preliminary Information communication provides information to the technician about vehicles that have an unwanted Stability Activation and/or a Service Stability message on the Driver Information Center. Technician may find a Diagnostic Trouble Code C0710. Technician should inspect for vehicles modifications before any in-depth diagnostics are performed. |
| PIT5386H | 2023-02-13. Service bulletin. BACK OVER PREVENTION; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that are found to have a back-up alarm inoperative during the Pre-Delivery Inspection. On trucks equipped with the Back Up Alarm (RPO 8S3), the alarm will be intentionally left disconnected from the assembly plant. Technician will reroute the harness and plug it in. |
| PIC6053B | 2022-11-21. Service bulletin. LANE DEPARTURE; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that the radio will lose audio except warning chimes and become inoperative after using Siri. The concern may be corrected by an ignition cycle. If the radio continues to be inoperative please contact General Motors Technical Assistance for further direction. |
| 070601016G | 2022-06-13. Service bulletin. BACK OVER PREVENTION. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement. |
| PIT4322M | 2022-02-14. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC). This Preliminary Information communication provides information to the technician about vehicles that have an unwanted Stability Activation and/or a Service Stability message on the Driver Information Center. Technician may find a Diagnostic Trouble Code C0710. Technician should inspect for vehicles modifications before any in-depth diagnostics are performed. |
| PIT5386G | 2022-02-14. Service bulletin. BACK OVER PREVENTION; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that are found to have a back-up alarm inoperative during the Pre-Delivery Inspection. On trucks equipped with the Back Up Alarm (RPO 8S3), the alarm will be intentionally left disconnected from the assembly plant. Technician will reroute the harness and plug it in. |
| PIT5698B | 2021-09-13. Service bulletin. ELECTRICAL SYSTEM:ADAS:BLINDSPOT:SENSORS. This Preliminary information communicates additional information on how a LIN bus operates and diagnostic tips when working on a LIN bus. |
| PI1187C | 2021-09-07. Service bulletin. FORWARD COLLISION AVOIDANCE: SENSING SYSTEM: CAMERA; BACK OVER PREVENTION; VISIBILITY:REARVIEW MIRRORS/DEVICES:INTERIOR. Information on Inside Rear view Mirror and Camera Loose |
| PIT5403H | 2021-06-14. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); SUSPENSION. This Preliminary Information communication provides information to the technician with the steps to diagnosis and repair vehicles with various handling, vehicle dynamics concerns, noises from the suspension or underbody, or issues related to damaged suspension components. Before any in-depth diagnostics are performed, be aware that various issues could occur if the vehicle has been modified and inform the customer the conditions noted may not be covered under warranty. Technician will inspect for installed aftermarket suspension components. Also inspect for improperly adjusted torsion bars. |
| PIT4322L | 2021-06-14. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC). This Preliminary Information communication provides information to the technician about vehicles that have an unwanted Stability Activation and/or a Service Stability message on the Driver Information Center. Technician may find a Diagnostic Trouble Code C0710. Technician should inspect for vehicles modifications before any in-depth diagnostics are performed. |
| PI1187C | 2021-04-21. Service bulletin. VISIBILITY:REARVIEW MIRRORS/DEVICES; ELECTRICAL SYSTEM:ADAS:DRIVER MONITORING:CAMERA/SENSOR. Information on Inside Rear View Mirror and Camera Loose Some customers may comment that the inside rear view mirror or front camera is loose or that the mirror/camera mounting bracket is loose or has fallen off. If a vehicle is encountered with the above condition, do not attempt to reinstall the bracket onto the windshield. The above listed vehicles have a revised bracket design that is not serviceable. It is necessary to replace the windshield glass assembly. The bracket comes installed on the new glass assembly. Refer to Windshield Replacement in SI. |
| PIT5386F | 2021-02-16. Service bulletin. ELECTRICAL SYSTEM; BACK OVER PREVENTION. This Preliminary Information communication provides information to the technician about vehicles that are found to have a back-up alarm inoperative during the Pre-Delivery Inspection. On trucks equipped with the Back Up Alarm (RPO 8S3), the alarm will be intentionally left disconnected from the assembly plant. Technician will reroute the harness and plug it in. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.