WenmarOpen by Wenmar Pro

Service bulletins for the 2019 Ford Transit Connect

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

109 on file from NHTSA, as of 2026-10-19.

About U2100 on the 2019 Ford Transit Connect: what the code means, and the bulletins and recalls about the same components.

By type

By component

By trouble code

Only bulletins with trouble code: U2100 are shown. Show all

Bulletins, newest first
SSM 496902021-03-31. Service bulletin. ELECTRICAL SYSTEM. For 2018-2021 EcoSport/Expedition/Navigator, 2019-2021 Ranger/Transit Connect, 2020-2021 Escape/Explorer/SuperDuty/Transit/Aviator/Corsair, 2021 Bronco Sport/F-150/Mustang/Mach-E the Workshop Manual (WSM) diagnostics may direct to replace a module on vehicles that use Ford Diagnosis and Repair System (FDRS). First, an FDRS session must be created on the vehicle prior to removing the faulted module. Once the session is started, run the Programmable Module Installation and replace the module only when instructed by FDRS. Installing a new module prior to starting a scan tool session may result in incomplete module configuration with DTCs U2100, U2101 and/or U2200. Once a session has been started, continue to follow normal WSM procedures to repair the vehicle.
SSM 485162020-03-03. Service bulletin. ELECTRICAL SYSTEM; BACK OVER PREVENTION. SSM 48516 - 2019 Transit Connect - Intermittent Inoperative Rear Back Up Camera - Vehicles Built On Or After 09 Nov 2018 through 30 Jun 2019 Some 2019 Transit Connect vehicles built between 9-Nov-2018 and 30-Jun-2019 equipped with the connected HMI Radio (CHR) may experience the parking aid camera intermittently inoperative with diagnostic trouble code (DTC) U2100 present. This may be due to an audio front control module (ACM) software concern. To correct, verify that the parking aid camera is inoperative with the engine running, reverse gear engaged and vehicle speed under 6 mph/h 10 km/h. ACM software level number is H1BT-14G298-GR/hardware part number KT1Z-18C869-J. Diagnostic trouble code (DTC) U2100 is present. If all conditions are met, Replace the CHR with part KT1Z-18C869-R or higher. Replacing the parking aid camera is not necessary. If all situations are not met, continue with normal diagnosis. Refer to Workshop Manual Section 413-13.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.