Service bulletins for the 2025 Ford Ranger
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
74 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
| SSM 55228 | 2026-10-12. Service bulletin. ENGINE; UNKNOWN OR OTHER. Some 2020-2026 Aviator/Explorer/F-150/Bronco/Ranger vehicles equipped with a 2.7L or 3.0L (non-diesel) engine may need the front engine cover removed and reinstalled for various reasons. The Workshop Manual (WSM), Section 303-01 Engine > Removal and Installation > Engine Front Cover service procedure has been updated to include a new essential special service tool (ESST) guide pin alignment tool (303-1790) that is used to align the engine front cover to the engine block, preventing the O-ring seal on the engine oil galley feed tube from getting damaged during installation. |
|---|---|
| TCU-26.2.12.2.2 Mach E, F | 2026-09-21. Over-the-air update. UNKNOWN OR OTHER; ELECTRICAL SYSTEM. Quality improvements include: -Addresses a bug that may cause updates to fail |
| ECG-26.2.12.3 Bronco,Esca | 2026-09-11. Over-the-air update. UNKNOWN OR OTHER; ELECTRICAL SYSTEM. Quality improvements include: -ePrivacy enhancements |
| SSM 55100 | 2026-09-01. Service bulletin. SEATS; UNKNOWN OR OTHER. For Various Ford and Lincoln vehicles, if diagnostics lead to the replacement of the front seat cushion cover J-clips, lower-level service parts are now available. Use service part W709919-S901 if the J-clip is completely detached from the seat cover and W715386-S424 if the clip is still partially attached. It is not necessary to replace the seat cover if only the J-clip is separating from the cover. Refer to PTS Home > Technical Assistance > Technical Support Videos > Section 501- Body and Paint > Seat J-Clips. For claiming, use causal parts from list below and labor operations 63100A and 63100A5. Causal Parts for claiming: Bronco/Bronco Sport/Escape/Explorer/Expedition/Navigator: 7862900 or 7862901 F-150/F-Super Duty: 1562900 or 1562901 Ranger/Maverick: 6062900 or 6062901 |
| SSM 55118 | 2026-09-01. Service bulletin. ELECTRICAL SYSTEM; UNKNOWN OR OTHER; STRUCTURE:BODY. Some of the following vehicles: * 2023-2025 F-Super Duty built on or before 02-Feb-2025 * 2024-2026 Ranger/Bronco/Mustang * 2024-2025 F-150 built on or before 15-Jul-2025 * 2024-2025 Nautilus built on or before 16-Feb-2025 * 2025 Explorer/Aviator built on or before 01-Feb-2025 may exhibit all of the following symptoms: - "No Key Detected" message displayed on the instrument panel cluster (IPC). - Key fob does not work in the backup slot. - Remote keyless entry (RKE) (lock and unlock from the key fob) functionality will work to lock/unlock the vehicle. If the vehicle exhibits these symptoms, start the vehicle using both key fobs. If the no crank/no start condition with "No Key Detected" concern is present, reprogram both key fobs and retest. If the no crank/no start condition with "No Key Detected" is still present, replace the body control module (BCM). Refer to Workshop Manual (WSM), Section 419-10. For claiming, use causal part 15604 and labor operation MT55118SSM up to 1.8 hours. |
| SSM 55113 | 2026-09-01. Service bulletin. STRUCTURE:BODY; UNKNOWN OR OTHER; ELECTRICAL SYSTEM. Some 2024-2025 Ranger vehicles equipped with a cargo box power point plug may exhibit a condition where all interior/exterior power outlets/plugs are inoperative with diagnostic trouble code (DTC) B1330:9A stored in the body control module (BCM). This may be due to an inoperative light emitting diode (LED) in the cargo box power point plug. To correct the condition, replace the cargo box power point plug (service base part number 19A464). Refer to Workshop Manual (WSM), Section 414-05 > Removal and Installation > Alternating Current (AC) Power Outlet Socket > Cargo Box Power Point Plug. For claiming, use causal part 19A464 and labor operation MT19A464SSM up to 0.6 hours. |
| TSB 26-2372 | 2026-08-21. Service bulletin. UNKNOWN OR OTHER; ENGINE; ELECTRICAL SYSTEM. This bulletin supersedes 26-2301. Reason for update: to update the Pinpoint Tests referenced in Step 1. Some of the vehicles listed in the Model statement above may require the replacement of the ambient air temperature sensor for various concerns. DTCs P0071, P0072, and/or P0073 may be present in the powertrain control module (PCM). |
| SSM 55070 | 2026-08-11. Service bulletin. UNKNOWN OR OTHER; ELECTRICAL SYSTEM; STRUCTURE:BODY. Some 2024-2025 Ranger vehicles equipped with a cargo box power point plug may exhibit a condition where all interior/exterior power outlets/plugs are inoperative with diagnostic trouble code (DTC) B1330:9A stored in the body control module (BCM). This may be due to an inoperative light emitting diode (LED) in the cargo box power point plug. To correct the condition, replace the cargo box power point plug (service base part number 19A464). Refer to Workshop Manual (WSM), Section 414-05 > Removal and Installation > Alternating Current (AC) Power Outlet Socket > Cargo Box Power Point Plug. For claiming, use causal part 19A464 and claim M-time up to 0.6 hours. |
| 26E04 | 2026-08-03. Emissions. UNKNOWN OR OTHER; ELECTRICAL SYSTEM. NEW VEHICLE DELIVERY HOLD - Emissions Recall 26E04 Certain 2021-2025 Model Year F-150, Maverick, Mustang, Ranger, Expedition, Bronco Sport, Explorer, Bronco, Navigator, and Aviator Vehicles Powertrain Control Module Software Update |
| SSM 55031 | 2026-07-28. Service bulletin. UNKNOWN OR OTHER; FUEL/PROPULSION SYSTEM; ELECTRICAL SYSTEM. Some 2021-2026 Ford/Lincoln vehicles may exhibit various symptoms including but not limited to the auto start/stop system not operating as intended with a "Check Charging System" message in the instrument panel cluster (IPC) while the charging system is operating properly with no charging related diagnostic trouble codes (DTC) stored. This may be due to someone using an aftermarket programmer to change the body control module (BCM) configuration to disable the auto start/stop system or perform other unsupported programming modifications. To correct this condition on F-150 and Bronco vehicles, download and run the Ford Diagnosis and Repair System (FDRS) application titled "BCM-Charging System Configuration Correction". Running this application will determine if the BCM configuration was modified by the customer and if so, provide the option to return the configuration back to factory settings. For other vehicle models exhibiting concerns related to unsupported aftermarket BCM programming, submit a Technical Support Request (TSR) requesting support to revert the BCM configuration |
| SSM 55044 | 2026-07-27. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM. Some 2025-2026 Bronco/Ranger vehicles may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble codes (DTC) P2122, P2123, P2127, P2128, and/or P2138 stored in the powertrain control module (PCM). The vehicle may or may not exhibit a perceived lack of power intermittently. This may be due to an issue with the following connectors associated with the accelerator pedal position (APP) sensor circuits: -C115B -C175B -C2040 Replacement of the accelerator pedal may not resolve this concern. Perform a wiggle test of the connectors while the engine is at normal operating temperature. Perform a visual inspection of the connectors as well as a terminal fit test using the appropriately sized flex probe. Repair as necessary. Refer to Wiring Diagram Cell 005. If no concerns are found, refer to Workshop Manual (WSM), Section 310-02 for normal diagnostics. |
| SSM 55021 | 2026-07-21. Service bulletin. ELECTRICAL SYSTEM; UNKNOWN OR OTHER. Some 2025-2026 Bronco/Bronco Sport/Corsair/F-150/F-Super Duty/Maverick/Mustang/Mustang Mach-E/Ranger vehicles may exhibit a no audio/sound condition. This may be due to the software in the audio control module (ACM). To determine if it is a software concern, disconnect the vehicle's 12-volt battery cables for 10 minutes and reconnect. If the concern is still present, continue with normal diagnostics in Workshop Manual (WSM), Section 415-00 Information and Entertainment System > General Information > Diagnosis and Testing and repair as necessary outside of this article. If the no audio/sound concern is resolved, reprogram the ACM using the latest software level of the Ford Diagnosis and Repair System (FDRS). For claiming, use causal part 18C869 and labor operations 10654C, 12651D and 12651D4. |
| TSB 26-2269 | 2026-07-13. Service bulletin. ENGINE; ELECTRICAL SYSTEM; UNKNOWN OR OTHER. Some of the vehicles listed in the Model statement above may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) P0300 and/or P0316 stored in the powertrain control module (PCM) (with no other relevant DTCs present) during a cold start after a 3 to 8 hours cold soak. This may be due to the machining surface of the intake ports in the cylinder head. |
| TSB 26-2301 | 2026-07-01. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM. Some of the vehicles listed in the Model statement above may require the replacement of the ambient air temperature sensor for various concerns. DTCs P0071, P0072, and/or P0073 may be present in the powertrain control module (PCM). |
| BCM-26.5.3 Ranger | 2026-06-30. Over-the-air update. ELECTRICAL SYSTEM; EXTERIOR LIGHTING. 26S29 Recall remedy: -Updates the Body Control Module to remove sun visor light operation in case of a short |
| TSB 26-2297 | 2026-06-29. Service bulletin. UNKNOWN OR OTHER; ELECTRICAL SYSTEM. Some of the vehicles listed in the model statement above equipped with SYNC4 may experience a blank center display screen or black center display after welcome animation. The rear-view camera will still function when shifting the vehicle to reverse under these conditions. |
| SSM 54902 | 2026-06-09. Service bulletin. POWER TRAIN. For 20202026 vehicles equipped with the 10R60 transmission, a new Transmission Clutch Circuit Leak Test has been introduced in the Ford Diagnosis and Repair System (FDRS). This test utilizes the pressure and vacuum transducer (PVT) when available. Workshop Manual (WSM) updates related to this diagnostic procedure are planned for release in Q4 2026. The new test improves the accuracy of detecting leaks within transmission fluid circuits and replaces the previous air check method. The previous air check procedure has been shown to produce a high rate of false positives, which may lead to unnecessary repairs when no actual leak is present. Accordingly, the air check procedure is not to be used for diagnosing internal transmission hydraulic leaks or as justification for transmission replacement. |
| 26B08 | 2026-06-05. Other. POWER TRAIN. Certain 2025 Bronco/Ranger and 2025-2026 Explorer/Aviator 4-wheel drive vehicles equipped with a 10R60 transmission. Transmission Replacement |
| 26B04 | 2026-06-05. Other. POWER TRAIN. Certain 2025 Model Year Bronco and Ranger Vehicles All Wheel Drive Module Replacement |
| SSM 54857 | 2026-05-26. Service bulletin. FUEL/PROPULSION SYSTEM. 2020-2026 Explorer/Escape/Corsair, 2021-2026 Bronco Sport/Bronco, 2022-2026 Maverick, 2024-2026 Mustang/Ranger/Nautilus vehicles equipped with a 2.0L or 2.3L EcoBoost engine may require removal of the turbocharger wastegate control actuator linkage for various reasons. The Workshop Manual (WSM), Section 303-04 Fuel Charging and Controls - Turbocharger - 2.0L/2.3L EcoBoost > Removal and Installation > Wastegate Control Actuator Linkage service procedure been added. In addition, the wastegate actuator rod (9E408), associated retention springs (9342) and retaining clips (00817) have been released as lower-level components to complete the repair without replacing the entire turbocharger wastegate actuator assembly. |
| SYNC-26.2.3.11.1 Ranger | 2026-05-15. Over-the-air update. UNKNOWN OR OTHER; ELECTRICAL SYSTEM. Quality improvements include: -Resolves SiriusXM disk memory usage |
| TSB 26-2185 | 2026-05-14. Service bulletin. ELECTRICAL SYSTEM; UNKNOWN OR OTHER. This bulletin supersedes 25-2621. Reason for update: add 2026 model year vehicles and Transit, update the causal part number (15604), update the Service Procedure, update the service labor operations for 2023 F-Super Duty, and add service labor operations for Transit. Some vehicles listed in the Model statement above may exhibit a no crank/no start condition where the customer cannot start their vehicle. The vehicle may also exhibit a "No Key Detected" message displayed on the instrument panel cluster (IPC), and no key fob works in the back up slot. The remote keyless entry (RKE) functionality will work to lock/unlock the vehicle. |
| SSM 54804 | 2026-05-14. Service bulletin. UNKNOWN OR OTHER; ELECTRICAL SYSTEM. Some 2025-2026 Ranger vehicles built on or before 21-Apr-2026 and equipped with a 12-inch instrument panel cluster (IPC) display may exhibit a condition where the IPC backlight and shift indicator remains illuminated after the vehicle is turned off. This may be due to the software in the IPC. To correct the condition, using the latest software level of the Ford Diagnosis and Repair System (FDRS) scan tool, download and run the "IPC - Instrument Panel Cluster (IPC) Software Update" application. For claiming, use causal part 10849 and labor operations 12651D and 12651D4. |
| PCM -26.20.0 Ranger | 2026-05-01. Over-the-air update. POWER TRAIN. Quality improvements include: -Powertrain Control Module calibration update to address a potential false warning light |
| 26P04 | 2026-04-30. Other. POWER TRAIN. Recommended Repair Prior to Sale Customer Satisfaction Program 26P04 Certain 2025 Model Year Bronco and Ranger Vehicles with 2.7L Engine Setting Diagnostic Trouble Code (DTC) P04DB Powertrain Control Module Software Update |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.