Service bulletin TSB 26-2269
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 11034968 |
| Published by NHTSA | 2026-07-13 |
| Manufacturer's number | TSB 26-2269 |
| Manufacturer's date | 2026-07-08 |
| NHTSA component | ENGINE; ELECTRICAL SYSTEM; UNKNOWN OR OTHER |
NHTSA's summary
Some of the vehicles listed in the Model statement above may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) P0300 and/or P0316 stored in the powertrain control module (PCM) (with no other relevant DTCs present) during a cold start after a 3 to 8 hours cold soak. This may be due to the machining surface of the intake ports in the cylinder head.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Electrical system, Engine
Trouble codes named
P0300, P0316
| FORD BRONCO | 2025 |
|---|---|
| FORD EXPLORER | 2025, 2026 |
| FORD RANGER | 2025 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2026411 | 2026-08-26. Engine |
|---|---|
| 26V548000 | 2026-08-25. ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL |
| 26V532000 | 2026-08-13. ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL |
| 2026356 | 2026-07-20. Electrical |
| 26V468000 | 2026-07-20. ENGINE; ELECTRICAL SYSTEM:WIRING:FRONT UNDERHOOD |
| 2026258 | 2026-05-27. Engine |
| 26V343000 | 2026-05-27. ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL |
| 2026190 | 2026-04-15. Electrical |
| 26V238000 | 2026-04-14. STRUCTURE:INTERIOR PANELS:SUN VISOR; ELECTRICAL SYSTEM |
| 26V205000 | 2026-03-31. ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| SSM 55228 | 2026-10-12. Service bulletin. Some 2020-2026 Aviator/Explorer/F-150/Bronco/Ranger vehicles equipped with a 2.7L or 3.0L (non-diesel) engine may need the front engine cover removed and reinstalled for various reasons. The Workshop Manual (WSM), Section 303-01 Engine > Removal and Installation > Engine Front Cover service procedure has been updated to include a new essential special service tool (ESST) guide pin alignment tool (303-1790) that is used to align the engine front cover to the engine block, preventing the O-ring seal on the engine oil galley feed tube from getting damaged during installation. |
|---|---|
| SSM 55220 | 2026-10-12. Service bulletin. Some 2024-2026 Nautilus and 2025-2026 Explorer/Aviator/Expedition/Navigator vehicles may experience Android Auto connection or general Bluetooth pairing concerns for both Android and IOS after an APIM software update. This may be due to the APIM software. To temporarily correct the issue:<br /><br /> * For Android Auto related issues: Clear Android Auto app storage in the center display screen. Vehicle Settings > Settings > Apps > Android Auto > Clear Storage. <br /> * For general Bluetooth connectivity issues: Clear Contacts Storage app storage in the center display screen. Vehicle Settings > Apps > Uncheck hide system apps > Contacts Storage > Clear Storage.<br /><br /> If the condition persists, perform a master reset from the center display screen, remove the vehicle from the phone, then re-pair the device.<br /><br /> If the condition continues to persist, refer to Workshop Manual (WSM), Section 415-00 for normal diagnostics and repair as necessary outside of this article.<br /><br /> If the condition is resolved, inform customers that engineering is currently working on a permanent solution |
| SSM 55208 | 2026-09-30. Service bulletin. Some 2024-2026 F-150, 2025 Explorer/Aviator, 2025-2026 Expedition/Navigator, or 2026 F-Super Duty vehicles may exhibit diagnostic trouble code (DTC) U211B:43:48 stored in the body control module (BCM) when performing a Self-Test. This DTC sets due to an internal BCM timing issue during the self-test process. This specific code has no customer impact and does not cause any drivability concerns or warning messages. Clearing DTC U211B:43:48, reprogramming the BCM, or replacing the BCM is unlikely to prevent this DTC from setting. This DTC does not trigger a condition covered under warranty. Note: This guidance only applies to U211B with the specific failure byte 43 in status 48. Any other trusted real-time operation network (TRON) DTCs or different failure bytes associated with U211B are still applicable and technicians must follow Workshop Manual (WSM) normal diagnostics for those DTCs. |
| TSB 26-2380 | 2026-09-29. Service bulletin. This article supersedes TSB 25-2575 to update the Parts list to add the applicable body wiring harnesses and underbody shield bolts. Some vehicles listed in the Model statement above may exhibit a "Sta-bar Disconnect Service Required" message in the instrument panel cluster (IPC) with any of the following diagnostic trouble codes (DTCs) stored in the chassis control module (CHCM): C103A, C1A99, C1B03, C1B07, C1B14 and/or B1A67. This may be due to water intrusion in the stabilizer bar wiring harness connector. |
| SSM 55172 | 2026-09-21. Service bulletin. Some 2025 Aviator/Explorer/Police Interceptor Utility vehicles may exhibit a "Steering Assist Fault Service Required" message and diagnostic trouble codes (DTC) C1110:56 and/or U3000:96 stored in the power steering control module (PSCM) after programming. This may be due to a calibration mismatch in the PSCM which has been resolved in the Ford database. If DTC C1110:56 is stored in a replacement PSCM after completing programmable module installation (PMI), start a new session using the latest software version of the Ford Diagnosis and Repair System (FDRS) scan tool then run the "PSCM - Programmable Module Installation (PMI)" application again. When FDRS asks if the original module is installed, select "No". If DTC C1110:56 is stored in the original PSCM after performing the PSCM configuration, start a new session using the latest software version of the FDRS scan tool, then download and run the "PSCM - Power Steering Control Module (PSCM) Software Update" application. To clear DTC U3000:96 from the PSCM, download and run the "PSCM - Reset the Power Steering Control |
| TCU-26.2.12.2.2 Mach E, F | 2026-09-21. Over-the-air update. Quality improvements include: -Addresses a bug that may cause updates to fail |
| IPMA-26.22.8.3.7 Expl&Avi | 2026-09-14. Over-the-air update. 26S21 Recall remedy Infotainment system update to prevent rearview camera image interruptions |
| ECG-26.2.12.3 Bronco,Esca | 2026-09-11. Over-the-air update. Quality improvements include: -ePrivacy enhancements |
| BCM-26.DC Explorer | 2026-09-11. Over-the-air update. Quality improvements include: - Enables the Open On Approach feature on Platinum trim vehicles |
| SSM 55131 | 2026-09-02. Service bulletin. Some 2025-2026 Aviator/Explorer/Expedition/F-150/Mustang Mach-E/Nautilus/Navigator vehicles may exhibit the hands-free BlueCruise feature intermittently/consistently unavailable when BlueCruise is active and when traveling in a "Blue Zone". Speed sign recognition may also be inaccurate. If there are no active relevant diagnostic trouble codes (DTC) present and the issue persists after multiple key cycles and if the BlueCruise System Health Check passes, download and run the "TCU - Reset Telematics Control Unit (TCU) Module" application using the latest software level of the Ford Diagnosis and Repair System (FDRS). If the condition is resolved, inform customers that this may be a temporary fix and engineering is currently working on a solution expected in Q4 2026. Monitor Professional Technician System (PTS) for additional information and schedule service appointments for customers once the repair becomes available. For claiming, use causal 14G229 and labor operations 12651D and 12651D4. If the condition persists after a test drive, refer to Workshop Manual (WSM), Section 419-03B for normal |