Service bulletins for the 2010 Chevrolet Express
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1554 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Transmission and driveline are shown. Show all
| 02-07-30-052J | 2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN:AUTOMATIC TRANSMISSION:COOLING UNIT AND LINES. This informational bulletin provides technicians with information regarding automatic transmission oil cooler flow test essential tool J-45096 TransFlow®. |
|---|---|
| 06-00-89-026L | 2017-08-15. Service bulletin. SERVICE BRAKES; EQUIPMENT:ELECTRICAL; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM; EQUIPMENT:APPLIANCE:AIR CONDITIONER; POWER TRAIN:AXLE ASSEMBLY; EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM. This warranty administration bulletin provide policy information on a revised customer concern not duplicated/verified labor operation numbers and how to submit CCND. |
| PIP3119N | 2017-08-15. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CATALYTIC CONVERTOR; POWER TRAIN. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a Service Engine Soon Malfunction Indicator Lamp on at low mileage. Technician may find Diagnostic Trouble Codes P0420 and or P0430 stored. Technician should be advised that the catalytic converter efficiency Diagnostic Trouble Codes P0420 and P0430 are disabled for the first hour of engine run time to allow break-in of the catalytic converter. Technician will need to use a Tech2 to check the verify engine run time on the Engine Hour Meter in the Instrument Panel Cluster Data Display/Data 1 List in the scan tool match. If the engine run time is less than one hour, the battery may have been disconnected, or another vehicle power loss event may have occurred, during vehicle manufacturing. Technician will need to clear the Diagnostic Trouble Codes and perform a drive cycle. If the catalytic converter was replaced and the Diagnostic Trouble Codes set it may be a result of the engine run time restrictions no longer being in place since the vehicle is no longer new. Technician will need to clear the Diagnostic Trouble Codes and perform a drive cycle. |
| PIP4112M | 2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary Information communication provides information to the technician of a complaint of a sag or hesitation when accelerating. The concern is present when coasting at low speeds of less than 15 miles per hour and then aggressively applying the throttle, or after making a hard stop followed by an aggressive throttle. This is considered normal operation of the vehicle the throttle is delayed and opened slowly up to .7 seconds to help minimize driveline lash and clunking or will have approximately .5 seconds of zero torque to allow the transmission to shift to first gear. |
| PIP4112L | 2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary Information communication provides information to the technician of a complaint of a sag or hesitation when accelerating. The concern is present when coasting at low speeds of less than 15 miles per hour and then aggressively applying the throttle, or after making a hard stop followed by an aggressive throttle. This is considered normal operation of the vehicle the throttle is delayed and opened slowly up to .7 seconds to help minimize driveline lash and clunking or will have approximately .5 seconds of zero torque to allow the transmission to shift to first gear. |
| PIP4828A | 2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. This Preliminary Information communication provides information to the technician about vehicles that have a rough idle and/or momentary lack of power after cold starting the engine and immediately placing the transmission in gear. Technician should follow published Service Information diagnostics first. Dealer should communicate to the customer this condition is a normal operating characteristic of their vehicle. |
| PIP4138L | 2017-08-15. Service bulletin. EQUIPMENT:MECHANICAL; POWER TRAIN. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on, engine misfire, and/or engine noise. Technician may find Diagnostic Trouble Codes P0300-P0308. If published Service Information diagnostics does not isolate the cause of this concern technician should check for a worn camshaft lobe and/or lifter roller, a sticking valve, valve leakage, a broken valve spring, and a collapsed active fuel management lifter. |
| PIP5071 | 2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN. This Preliminary Information communication provides information to the technician about vehicle that has a squawk or grunt type noise when shifting from 2nd to 3rd gear. Technician should replace the 3-4 clutch Friction and Steel Clutch Plates along with the Apply Plate and Selective Backing Plate. |
| PIP5065 | 2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary Information communication provides information to the technician about vehicles that may have a ticking noise when driving above 30 miles per hour in third and fourth gear. Technician will need to replace the Reaction Carrier and the Low and Reverse Roller Clutch. |
| PIP4112N | 2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. This Preliminary Information communication provides information to the technician of a complaint of a sag or hesitation when accelerating. The concern is present when coasting at low speeds of less than 15 miles per hour and then aggressively applying the throttle, or after making a hard stop followed by an aggressive throttle. This is considered normal operation of the vehicle the throttle is delayed and opened slowly up to .7 seconds to help minimize driveline lash and clunking or will have approximately .5 seconds of zero torque to allow the transmission to shift to first gear. |
| PIP4828C | 2017-08-15. Service bulletin. POWER TRAIN; ENGINE. This Preliminary Information communication provides information to the technician about vehicles that have a rough idle and/or momentary lack of power after cold starting the engine and immediately placing the transmission in gear. Technician should follow published Service Information diagnostics first. Dealer should communicate to the customer this condition is a normal operating characteristic of their vehicle. |
| 14730 | 2017-02-02. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. 14730 - CUSTOMER SATISFACTION PROGRAM. CERTAIN VEHICLES, EQUIPPED WITH ENGINE RPO L96 (6.0L V-8) AND TRANSMISSION RPO MYD (6 SPEED AUTO), MAY HAVE A CONDITION IN WHICH HIGH DUTY CYCLE USE WHILE PULLING TRAILERS AND/OR VEHICLES (SUCH AS FLEET CUSTOMERS DRIVING CUT-AWAY MODELS WITH 16 FOOT BOXES) CAN EXCEED THE TARGET ENERGY INPUT TO THE CLUTCH. THIS MAY LEAD TO FASTER TORQUE CONVERTER CLUTCH FRICTION MATERIAL WEAR THAN EXPECTED. SOME OPERATORS OF VEHICLES WITH THIS CONDITION HAVE REPORTED A DRIVELINE VIBRATION OR SHUDDER FEELING. DEALERS ARE TO REPROGRAM THE TRANSMISSION CONTROL MODULE (TCM). |
| SB-16-NA-130 | 2016-08-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; EQUIPMENT. THIS INFORMATIONAL BULLETIN PROVIDES INFORMATION ON HOW TO INSPECT THE UPPER VALVE BODY TO DETERMINE THE CORRECT RPO USAGE TO CORRECT A CONCERN THAT AFTER INSTALLATION OF A REPLACEMENT UPPER VALVE BODY, THE TRANSMISSION MAY HAVE NO REVERSE AND NO 2ND GEAR DUE TO THE INSTALLATION OF THE INCORRECT UPPER VALVE BODY. |
| SB-03-07-29-004K | 2016-08-06. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION. THIS INFORMATIONAL BULLETIN PROVIDE INFORMATION ON THE OPERATING CHARACTERISTICS OF A MANUAL TRANSMISSION. |
| PI1344B | 2016-07-07. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. Some customers may comment that the vehicle has reduced acceleration at low speed and/or transmission is slipping from a launch. Technicians may find DTC P0751 set or stored in history. This condition may be caused by the Clutch Select Solenoid Valve 2 (359), located in the lower valve body, sticking in its bore resulting in a 4th gear start. Note: This condition can be very intermittent and difficult to duplicate. |
| SB-PIP-5059 | 2016-06-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. SUMMARY TO BE PROVIDED ON A FUTURE DATE. |
| PI0690B | 2016-06-09. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. SUMMARY TO BE PROVIDED ON A FUTURE DATE. |
| 14730 | 2016-06-02. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. SUMMARY TO BE PROVIDED ON A FUTURE DATE. |
| 14745 | 2015-05-11. Service bulletin. POWER TRAIN:CLUTCH ASSEMBLY. GENERAL MOTORS 2010-2014 CHEVROLET EXPRESS GMC SAVANA: INFORMATION ON TORQUE CONVERTER CLUTCH WEAR VEHICLES EQUIPPED 6.0L FLEXIBLE FUEL ENGINE AND 6 SPEED AUTOMATIC TRANSMISSION. *LJ SEE DOCUMENT SEARCH BUTTON FOR OWNERS LETTER*LJ |
| CSP-14730 | 2015-04-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. CHEVROLET/GMC: DRIVELINE VIBRATIONS OR SHUDDER FEELING ARE DUE TO FRICTION MATERIAL WEAR ON FASTER TORQUE CONVERTER CLUTCH WHEN PULLING TRAILERS AND/OR VEHICLES AND EXCEED TARGET ENERGY INPUT. MODEL 2010-14 EXPRESS, SAVANA. *PE |
| PI-0773 | 2014-07-19. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. CADILLAC/CHEVROLET/GMC/HUMMER/PONTIAC: THERE IS SLIPPING OR HAVE NO FOURTH, FIFTH OR SIXTH GEAR AND MALFUNCTION INDICATOR LAMP (MIL) WOULD BE ON, WITH DIAGNOSTIC TROUBLE CODE (DTC) P0796 FOUND AS ACTIVE. *PE |
| PI-0488 | 2011-08-01. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). GM: THE TRANSMISSION IS SLIPPING OR HAS NO FORWARD/REVERSE MOVEMENT. *RM UPDATED 4/16/12. *PE UPDATED 6/18/12. *PE UPDATED ON 7/09/2013. *KB |
| SB-10-04-17-001A | 2011-06-30. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. GM: 2010-2012 EXPRESS/SAVANA. THERE IS A TRANSMISSION FLUID LEAK AT THE REAR OF THE TRANSMISSION. THERE IS A MISSING PLUG. *RM |
| PI-0153B | 2011-06-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. GM: THERE IS A WHINE NOISE WHEN IN DRIVE OR REVERSE. THERE IS A BEARING PROBLEM IN THE TORQUE CONVERTER. *RM |
| PIE0095A | 2011-06-08. Service bulletin. POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT:SEAL. GM: THERE IS A VIBRATION WHEN DRIVING AT HIGHWAY SPEEDS AND THERE COULD BE A TRANSMISSION FLUID LEAK UNDER THE VEHICLE. *RM |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.