Service bulletins for the 2016 Cadillac Escalade
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1826 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Automatic transmission are shown. Show all
| 17-NA-066 | 2023-07-25. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN. This service bulletin provides information for automatic transmission Oil Cooler Flush and flow test. |
|---|---|
| PIP5621C | 2022-10-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); POWER TRAIN. This Preliminary information communicates to the dealer technician that TAC recommends the utilization of the GDS2 software to aid in diagnosing automatic transmission concerns. TAC is requesting the GDS2 session logs be sent in before the dealer contacts TAC. |
| 21NA199 | 2022-02-14. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT:VALVES/VALVE BODY. This informational bulletin advises the technician to replace the TBV if the transmission has any type of repair even if no problem was found, to replace the tbv. |
| 15-NA-083 | 2021-09-07. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Recovery Process from a Controller Reprogramming Interruption |
| 06-00-89-031D | 2021-09-07. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN; ENGINE. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification |
| 990420002L | 2021-08-09. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION; POWER TRAIN:AUTOMATIC TRANSMISSION; EQUIPMENT. This service bulletin provides information on Driveline Clunk Noise and what is acceptable and what is considered normal operation. |
| 17336-02 | 2021-04-29. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. On some 2015-2017 model year Cadillac Escalade, Escalade ESV, Chevrolet Suburban, Tahoe, GMC Yukon and Yukon XL vehicles, may have a condition where thermal cycling on the combination transmission fluid/oil and AC condenser cooler creates a crack that may allow refrigerant to escape. This condition consequently may deactivate the AC system which may cause potential customer annoyance |
| 06-00-89-031D | 2021-04-20. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification |
| 15-NA-083 | 2021-04-20. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Recovery Process from a Controller Reprogramming Interruption During service reprogramming of the T87 TCM, some technicians may notice the TCM may fail during the reprogramming event and become unresponsive to the Service Programming System (SPS), unresponsive to the GDS2 tool. This bulletin addresses corrective actions to attempt to recover the module before declaring the TCM as a bad part and replacing. During reprogramming, an interruption can cause the module to lock up. A module reset may recover the TCM |
| 16-NA-175 | 2021-04-13. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:GEARS; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. SHAKE AND/OR SHUDDER DURING LIGHT THROTTLE ACCELERATION BETWEEN 40 AND 128 KM/H (25 AND 80 MPH) AT A STEADY STATE. |
| 150089004C | 2021-03-08. Service bulletin. SUSPENSION:FRONT:MACPHERSON STRUT; SUSPENSION:FRONT:SHOCK ABSORBER; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. This service bulletin provides technicians with updated information to help identify the differences between what is considered a fluid leak, and what is considered fluid seepage. |
| 060089031F | 2020-12-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. This service bulletin provides information on OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification. |
| 1308116001F | 2020-12-07. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION. The intent of this technical bulletin is to identify aftermarket ALDL or DLC interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them. |
| 16NA361 | 2020-09-28. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This informational bulletin explains possible normal condition of a flare from 1st to 2nd, even if the trans had been repaired for the flare and its still noticed. |
| PIT5206G | 2020-08-10. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION; SERVICE BRAKES; EQUIPMENT. This Preliminary Information communication provides information to the technician with the steps on diagnosing and repairing vehicles that may have unwanted grade braking, reduced engine power with no Driver Information Center messages ? Brake Pedal Override Feature ?, transmission busy or frequent shifting up or down, and Diagnostic Trouble Codes P057B, P057C, and/or P057D may or may not be set. Technician will use this preliminary information to find the brake pedal position data parameters in the scan tool, and also to provide some additional diagnostic help. These issues may be caused by an incorrect brake pedal position sensor input to the engine control module. Technician will verify with the scan tool if the engine control module has the correct parameters for the brake pedal position sensor. If an engine control module brake pedal position sensor relearn is performed, the truck may be temporarily repaired until the intermittent wiring issue between the engine control module and brake pedal position sensor occurs again. On 2014 and newer trucks inspect and repair any damage to X115 and X119. On the 2014 and previous trucks inspect and repair any damage to X205. |
| PIP5175D | 2020-08-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:GEARS; ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that may have a delayed engagement into drive, shudder at a launch, or the transmission is slipping when shifting into 1st, 2nd, 3rd or 4th gears. This may be due to loose stator support to pump cover bolts causing a leak at the stator support to pump cover gasket. Technician will check for the bolts to be loose. If any of the bolts are loose or the gasket is misaligned or leaking, the transmission pump cover must be replaced and the 1234 clutch plates should be inspected for being distressed and repaired as needed. |
| PIP5700 | 2020-02-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary information communicates to the dealer technician that the part numbers for the internal wiring harnesses for the 8 speed RWD transmissions are not listed in the Electronic Parts Catalog. Technicians are to refer to the information provided in this document to obtain the internal wiring harness part numbers by application. |
| PIP5531A | 2020-02-10. Service bulletin. ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015?0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that "mating" surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped |
| 080730026F | 2019-09-23. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped. |
| PIP5369C | 2019-06-03. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM:SOFTWARE. This Preliminary Information communication provides information to the technician about vehicles that have "Service 4 Wheel Drive" message on the Driver Information Center. Provides the technician with additional information to ensure that the TCCM contains the latest software released to address previous issues, also advises of default action changes. Calls out specific circuits to be inspected to help isolate intermittent codes. |
| PIP5337K | 2018-11-13. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. This Preliminary Information communication provides information to the technician to refer to bulletin 16-NA-175 to aid in addressing torque converter clutch shudder concerns. |
| PIP3366C | 2018-08-20. Service bulletin. POWER TRAIN:TRANSFER CASE (4-WHEEL DRIVE); POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary information communicates to the dealer technician thatLight Duty Trucks equipped with automatic transmissions and 4 wheel drive may exhibit a condition of grinding/ratcheting type noise when shifting the automatic transmission into park while the transfer case is in 4 wheel drive low (4LO) range. Dealers technician's are advised this condition should be deemed a normal characteristic of 4WD low operation. |
| 16-NA-175 | 2018-06-11. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. This technical bulletin provides a procedure to flush and drain fluids for the transmission to eliminate a shake and/or shudder during a light throttle acceleration between 40 and 128 KM/H (25 and 80 MPH) at a steady state. |
| 16NA175 | 2018-06-04. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This technical bulletin provides a procedure to flush and drain fluids for the transmission to eliminate a shake and/or shudder during a light throttle acceleration between 40 and 128 KM/H (25 and 80 MPH) at a steady state. |
| 16-NA-014 | 2018-05-21. Service bulletin. EQUIPMENT; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. Delayed Engagement After Sitting With Engine Off - Torque Converter Fluid Drain Back |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.