WenmarOpen by Wenmar Pro

Service bulletins for the 2019 BMW X7

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

463 on file from NHTSA, as of 2026-10-19.

By type

By component

By topic

Bulletins, newest first
B5207202020-11-16. Service bulletin. SEATS:FRONT ASSEMBLY:SEAT HEATER/COOLER. SEAT HEATING NOT ACTIVATED WHEN ENGINE IS STARTED USING REMOTE STARTING SYSTEM: When preheating/precooling the vehicle via the remote starting system (Remote Engine Start), the seat heating on the driver's side is not activated.
B5206202020-11-16. Service bulletin. SEATS; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. HOLE IN LEATHER AT SIDE LOCK BOLT, 2ND ROW 60/40 SPLIT BENCH SEAT: There is a visible hole in the leather of the 2nd row of seats. The hole is located on the side lock bolt of the left rear seat backrest. The rear seat backrest in the 2nd row of seats can be folded down as follows: 40 - 20 -40 The fault pattern is only visible when the rear seat backrest is folded down. The hole in the seat cover is slightly larger than specified (2nd row of seats).
B3204202020-11-16. Service bulletin. ELECTRICAL SYSTEM; STEERING. GROANING NOISE DURING HEIGHT ADJUSTMENT OF THE ELECTRIC STEERING COLUMN: A groaning type noise is heard during the height adjustment.
B6403202020-10-19. Service bulletin. EQUIPMENT. CENTER CONSOLE / CUP HOLDER GETS HOT WHEN THE HEAT IS ON: The center console and front cup holder get noticeably too warm to the touch on long journeys with the interior "Heating on". The air ducts may not be properly connected, this allows heated air to leak out in this area. The foam material that seals between the ducts may be out of position, not held by the mounting adhesive and squashed allowing for an air leak.
B6113202020-10-19. Service bulletin. ELECTRICAL SYSTEM. SERVICE ACTION - CHECKING THE DUAL STORAGE SYSTEM AND REPLACE IF NECESSARY: In the event of an accident, the two-battery Dual Storage System (DSS) is disconnected from the electrical system via an internal relay. In some cases, the relay is stuck closed and a fault is set. In these circumstances: A crash shutdown of the DSS does not occur The power distribution box is supplied with power until the DSS is fully discharged.
B5205202020-10-19. Service bulletin. SEATS. BACKREST MISALIGNMENT OF 60/40 SECOND ROW SEAT: On vehicles equipped with the second row 60/40 split bench seats, the backrests may not properly align between the two seats.
B5112192020-10-19. Service bulletin. STRUCTURE. KIDNEY GRILL ACTIVE AIR FLAP FAULTS: A check control message or MIL (Malfunction Indicator Lamp) may be illuminated.
B3407202020-10-19. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC). SERVICE ACTION - REPLACE HYDRAULIC UNIT, DYNAMIC STABILITY CONTROL INTEGRATED: DSCi units which potentially have a faulty hydraulic valve were installed in the vehicles. The affected unitsmay activate a sporadic red-colored Check Control Message.
B3204202020-10-19. Service bulletin. STEERING. GROANING NOISE DURING HEIGHT ADJUSTMENT OF THE ELECTRIC STEERING COLUMN: A groaning type noise is heard during the height adjustment.
B3203202020-10-19. Service bulletin. STEERING. FAILURE OF THE ELECTRIC STEERING COLUMN ADJUSTMENT AT HIGHER CABIN TEMPERATURE: Electric steering column adjustment fails when interior cabin temperatures rise above 122 degrees F (e.g., parked outdoors on hot day). Faulty self-diagnosis of the steering column control unit.
B6624192020-09-14. Service bulletin. ELECTRICAL SYSTEM. REMOTE CONTROL IS NOT DETECTED: Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle may not start when placing the key against the steering column. Note: Opening, closing and starting via the BMW Digital Key or the Digital Key Card are not affected. Software error in the BDC (Body Domain Controller) module.
B6619192020-09-14. Service bulletin. ELECTRICAL SYSTEM. COMFORT ACCESS AND COMFORT GO NOT POSSIBLE: Vehicle cannot be unlocked/locked or started via Comfort Access. Remote control functionality is restored by pressing any of the key buttons or by removing and reinstalling the remote control key battery.
B6615192020-09-14. Service bulletin. LANE DEPARTURE. LANE DEPARTURE WARNING - STEERING INTERVENTION TOO STRONG: The steering intervention for Lane Departure Warning (LDW) is too strong (severe), which can create an uncomfortable feeling for the driver. Background: Steering intervention helps keep the vehicle in the lane if the system detects that a lane marking has been crossed. The steering intervention can be noticed on the steering wheel and can be manually overridden at any time. Software error in the KAFAS (camera-based driver assistance system) control unit.
B6515202020-09-14. Service bulletin. ELECTRICAL SYSTEM. HEAD UNIT RESETS WHEN NAVIGATION IS USED IN CERTAIN LOCATIONS: The head unit resets sporadically causing the CID to turn black and then starts up again after a short time with the message "Start navigation system". This only occurs during navigation guidance when the "3D building" function is used Software in the Head Unit High (HU-H3).
B6101202020-09-14. Service bulletin. ELECTRICAL SYSTEM. ACCESSORIES DO NOT POWER ON: Customer is not able to power accessories using the 12 volt power socket. Design change to reduce short circuits and blown fuses.
B5413192020-09-14. Service bulletin. VISIBILITY. FRONT ROLLER SUNSHADE LOOSE: The roller sunshade (aka sun protection or sunblind) of the front panoramic sunroof is bunching up during operation or may hang down and appear loose. This bulletin only applies to vehicles with an Alcantara headliner. The Alcantara material may be too thick to operate correctly in the panoramic sunroof frame.
B5112192020-09-14. Service bulletin. ENGINE AND ENGINE COOLING. KIDNEY GRILL ACTIVE AIR FLAP FAULTS: A check control message or MIL (Malfunction Indicator Lamp) may be illuminated, with one or more of the following faults stored: 138207- Active cooling damper control (AKKS), top: blockage at warm ambient temperature 21B043- Active cooling damper control (AKKS), top: blockage at all ambient temperatures 138222- Active cooling damper control (AKKS), above: positional deviation error detected at warm ambient temperature 138209- Active cooling damper control (AKKS), top: Control deviation at all ambient temperatures 13822B- Active cooling damper control (AKKS), top: Control deviation at all ambient temperatures 21B042- Active cooling damper control (AKKS), below: blockage at all ambient temperatures 138206- Active cooling damper control (AKKS), bottom, blockage at warm ambient temperature 138225-Active air-flap control, bottom: top limit position not detected 138224-Active air-flap control, bottom: bottom limit position not detected Multiple potential issues may be the cause, including: 1. Faulty active air flap(s) (Upper and/or lower) 2. Software error in the DME 3. Debris or blockages from outside influence (non-warranty) 4. Information error memory that does not require a repair 5. For G20 only- Detached lower active air flaps
B0902202020-09-14. Service bulletin. ELECTRICAL SYSTEM. REMOTE SOFTWARE UPGRADE: For BMW, Remote Software Upgrade (RSU) is the next consequent step with regard to digitalization and customer satisfaction. With the introduction of RSU, customers now can update the vehicle software by themselves.
B0902182020-09-14. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; ELECTRICAL SYSTEM. NEW ECU VALIDATION NEEDED AFTER REPLACING CERTAIN CONTROL MODULES: With introduction of the new Headunit HU-H3 (MGU Media Graphics Unit), there is a new protection mechanism against tampering. If one or more of the following components needs to be replaced, the secure connection between them must be re-established: MGU TCB Telematic Communication Box (ATM-02) RSE Rear Seat Entertainment and/or KOMBISP18 instrument cluster Prior to re-establishing this connection, an electronic certificate must be created in the BMW backend for importing into the Vehicle. After the replacement of one of the mentioned Modules, the Control Module needs a valid certificate for it to communicate with the other Modules.
B6512202020-08-31. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. BMW CONNECTEDDRIVE APPS ARE NO LONGER AVAILABLE AFTER PROGRAMMING: After programming vehicle with "20-03" software, BMW ConnecedDrive apps are no longer available in the head unit. Software in the Head Unit High (HU-H3).
B6507092020-08-31. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. NAVIGATION SYSTEM - REPORTING MISSING OR INCORRECT ROADMAP DATA: Do not replace parts and do not program the vehicle. Roads can change by up to 15% every year. To ensure the best navigation experience, we do everything in our power to create the best maps. Your reports help us to detect changes in your area and keep future versions of our maps as accurate as possible. Therefore, a road map error or missing data must be reported directly to the map supplier.
B6201192020-08-31. Service bulletin. EQUIPMENT:ELECTRICAL. INSTRUMENT CLUSTER AND ONBOARD COMPUTER INTERMITTENTLY INOPERATIVE: The audio source, radio station, or music track cannot be changed using the MFL. Normal functionality may possibly return after a sleep cycle or a battery reset. This affects vehicles with: Integration level S18A-18-11-5xx Live Cockpit Professional (option code 6U3) including the instrument cluster High 4.1. While the Kombi is not working properly the rest of the system is working properly. The customer can still use the Central Information Display (CID) for items such as entertainment settings, Driver Experience settings, etc, utilizing the I drive controller. The telephone functions are not affected. Unfavorable software at system start-up.
B5221192020-08-31. Service bulletin. SEATS. SEAT OPERATIONAL CHANGES AS OF 7/2019 I-LEVEL FOR G05/G07: Flashing LED in trunk mounted switch pack.
B5204202020-08-31. Service bulletin. SEATS. SOFTWARE UPDATE FOR SEAT CHECK CONTROL MESSAGES: There is an operating failure with various Check Control (CC) messages displayed regarding seat adjustment of the second and third row of seats.
B3405172020-08-31. Service bulletin. SERVICE BRAKES, HYDRAULIC; WHEELS. TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: Ticking noise coming from front wheel while cornering without brakes applied, noticeable at low speeds. The vehicle must be moving.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.