Service bulletins for the 2011 Audi Q7
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1054 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| A911594 2036576- | 2017-10-25. Service bulletin. EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 91 number 14-28 dated March 6, 2014. MMI freezes or crashes and restarts when telephone address book is searched. This condition occurs because special characters (including symbols, emoticons, or map icons) are stored in the name field of a phonebook contact. |
|---|---|
| A971545 2023283- | 2017-10-25. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. Supersedes Technical Service Bulletin Group 97 number 10-02 dated April 23, 2010. A defective light bulb warning appears in the instrument cluster, but the side marker lights are functioning normally and DTCs are stored in the vehicle electrical system control module after the vehicle electrical system control module, J519, is replaced. Due to a change in the software, an additional adaptation must be performed when the vehicle electrical system control module is replaced. |
| A941561 2022410- | 2017-10-25. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 97 number 11-23 dated March 31, 2011. When the vehicle is in Coming Home mode, the right LED daytime running light is sporadically inoperative. The daytime running lights and fog lights operate correctly. The front fog lights and the left daytime running light work correctly. DTC 02746 (Right daytime running lamp bulb) with fault symptom 007 (Short circuit to ground) is stored in the vehicle electrical system control module. |
| A701544 2038029- | 2017-10-25. Service bulletin. STRUCTURE; VISIBILITY:SUN/MOON ROOF ASSEMBLY. Supersedes Technical Service Bulletin Group 70 number 14-39 dated August 11, 2014. Various squeaks and/or rattles are heard from the roof area on vehicles equipped with a panoramic sunroof. These noises can be created by the points of contact between the sunroof cover trim frame and the clips that retain it to the headliner. |
| A171555 2030197- | 2017-10-25. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 17 number 13-46 dated November 7, 2013. Customer complains of excessive oil consumption. Production solution is Crankcase pressure reduction starting with model year 2013. |
| A011507 2028344- | 2017-10-25. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 01 number 13-69 dated February 14, 2013. Noises and inconsistent engine operation after cold start during the catalyst heating phase. The customer may misinterpret these symptoms as engine misfiring. This bulletin applies only to non-diesel engines. |
| A171559 2030197- | 2017-10-25. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 17 number 15-55 dated February 9, 2015. Customer complains of excessive oil consumption. Crankcase pressure reduction starting with model year 2013. |
| A171558 2038119- | 2017-10-25. Service bulletin. EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 17 number 14-52 dated September 2, 2014. The message "Oil minimum warning, add one quart of oil" appears in the instrument cluster, but the oil level is above the minimum level (when measured with special tool T40178). There are no DTCs related to oil level stored in the ECM memory. The oil level sensor is defective. |
| A151526 2039995- | 2017-10-25. Service bulletin. ENGINE; POWER TRAIN. Rattling noises are heard from the timing chain drive for about 1-3 seconds after the first engine start of the day. The noises are caused by one of the upper chain tensioners. The noises do not lead to damage. Improved chain tensioner. |
| A941675 2024896- | 2017-10-25. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS. The healight switch holder is broken, which causes the healight switch assembly to be loose or fall into the dashboard. The rivets that hold the headlight switch holder in the dashboard can break if the headlight switch is bumped (by driver entering vehicle). |
| A971548 2013504- | 2017-10-21. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 97 number 10-15 dated October 20, 2010. Sporadic fault memory entries are stored in various control modules. Contacts may be widened (over 0.63 mm) if incorrect pins or incorrect methods for current flow tests are used. Either action may cause intermittent electrical connections, which can cause sporadic DTCs to be stored in various control modules. |
| A971547 2034945- | 2017-10-21. Service bulletin. ELECTRICAL SYSTEM:WIRING; ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 97 number 13-40 dated November 26, 2013. The customer may report multiple warning lights are/were illuminated simultaneously. The warning lights may be sporadic, and may not be illuminated when the customer brings the vehicle to the workshop. CAN communication DTCs may be found in control modules. There is sporadic data disruption on the CAN bus wiring behind the dashboard, between the left (T46a) and right (T46b) 46-pin CAN disconnect plugs. |
| A941567 2027773- | 2017-10-21. Service bulletin. EXTERIOR LIGHTING. Supersedes Technical Service Bulletin Group 94 number 12-96 dated November 1, 2012. Part or all of the daytime running lights do not work on vehicles equipped with LED daytime running lights. For vehicles with halogen daytime running lights, refer to TSB 2017488: 94 Halogen Daytime running lights do not work. In the past, the daytime running light bulbs were a serviceable part. In this application, the LED strip cannot be replaced, and may have an associated control module. This TSB is for servicing information only. |
| A911588 2026390- | 2017-10-21. Service bulletin. EQUIPMENT:ELECTRICAL; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. When a phonebook with a large number of contacts is being downloaded, the MMI screen freezes Briefly after the initial Bluetooth connection (shortly after the phone is bonded to the vehicle), after the ignition is switched on (shortly after the phone automatically reconnects with the vehicle), and after the phonebook has downloaded. When the voice recognition system is used, a message appears in the MMI screen stating that the phone book is too large and that the voice recognition system cannot be used. When music is streamed to the MMI system with the Bluetooth A2DP connection, the music intermittently pauses or seems to skip. The condition goes away once the phonebook transfer is completed. The MMI uses a limited portion of the total memory to convert the name and phone number fields of downloaded contacts into a voice command (text to speech). Extensive processing takes place if too many letters are used in the first and last name fields or if numbers or special characters are entered. The remaining memory is dynamically assigned to different applications which can also affect the capacity of the voice command processing. The MMI does not respond until the process is completed or it may freeze if phonebook fields are too large or do not follow typical formatting. In addition, the text-to-speech capacity is exceeded and the voice recognition system is rendered inactive. |
| A911583 2030465- | 2017-10-21. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); ELECTRICAL SYSTEM:SOFTWARE. Supersedes Technical Service Bulletin Group 91 number 13-07 dated September 12, 2013. Group "A" complaints: Valid for vehicles with MMI software below version 566. Group "B" complaints: Valid for vehicles with MMI software at or above version 566 but below 715. Group "C" complaints: Valid for vehicles with MMI software at or above version 715 but not including 814. This bulletin only applies to vehicles with MMI3G+ Navigation (PR Number "7T6") and to vehicles with MMI3G+ Navigation, but without Audi Connect (PR Number "7T6" with additional PR code of "PND"). Continual improvements to MMI software provides solutions to issues experienced in the field. |
| A901554 2040593- | 2017-10-21. Service bulletin. STEERING:ELECTRIC POWER ASSIST SYSTEM; EQUIPMENT:ELECTRICAL. Customer reports that the ignition sporadically cannot be switched on. DTC 00456 (Access/start control module -J518- no communication) is found in several control modules or the access/start authorization control module, J518 (address word 05), identifies itself with implausible data can be found through guided fault finding (GFF). If no communication is possible, activate the bus by switching on the hazard warning lights. It should now be possible to carry out a diagnosis. If DTC 00288 (Steering column lock actuator-N360, faulty) is logged in the access/start authorization control module, J518 (address word 05), this bulletin does not apply. Proceed according to GFF. Incorrect software. |
| A871563 2010146- | 2017-10-21. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. Supersedes Technical Service Bulletin Group 87 number 14-54 dated August 28, 2014. There is an unpleasant, musty odor coming from the heating and ventilation system. The odor usually occurs when the vehicle has been sitting unused for five hours or more. The odor usually occurs within 20 to 60 seconds after the vehicle is started. Condensation, which is a normal condition in all A/C systems, can cause a musty odor. If the odor is noticeable in the vehicle when the engine is not turned on, the cause may be mold and mildew in the passenger compartment, and not be related to the A/C system. All other possible sources of the odor must be investigated before this bulletin can be performed. |
| Dealer Letter - | 2017-10-21. Service bulletin. FUEL SYSTEM, OTHER:DELIVERY:FUEL PUMP. This document contains general information on the upcoming warranty extension on the high pressure fuel pump. |
| A941565 2012749- | 2017-10-21. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS. Supersedes Technical Service Bulletin Group 94 number 12-92 dated October 24, 2012. Condensation is visible on the inside of the headlight, taillight, fog light, side marker light, front turn signal, daytime running lights, or third brake light lens. |
| A911582 2029903- | 2017-10-21. Service bulletin. EQUIPMENT:ELECTRICAL; BACK OVER PREVENTION: CAMERA SYSTEM. Supersedes Technical Service Bulletin Group 91 number 12-42 dated June 20, 2012. The customer complains about the picture quality of rearview backup camera image in the MMI screen. The picture is fuzzy or distorted. The picture looks too bright, too dark, or opaque in certain areas of the image. The colors of the objects in the image are incorrect or slightly off. The guidelines used for parking are fuzzy, distorted, or pixelated when compared with the guidelines displayed on another vehicle?s MMI. |
| A661552 2035673- | 2017-10-21. Service bulletin. STRUCTURE:BODY. Supersedes Technical Service Bulletin Group 66 number 15-50 dated April 10, 2015. Customer may report hearing wind noise from the front door area when the vehicle is driven at highway speeds. After diagnosis, it is determined that the source of the wind noise is the exterior rear view mirrors. Throughout the development of the Audi Q5 and Audi Q7, various features have been added to the exterior rear view mirrors. The added features include the turn signal lamp, side assist lamp, perimeter lamp, etc. As the complexity of the exterior rear view mirror increases, the mirrors become more susceptible to wind noise. The two main sources of wind noise from the exterior rear view mirrors are: the seam surrounding the turn signal lamp and the seam at the mirror base. The modifications explained in the Service section of this bulletin will effectively mitigate the wind noise symptom for the customer. |
| A661550 2035673- | 2017-10-21. Service bulletin. STRUCTURE:BODY; VISIBILITY:REARVIEW MIRRORS/DEVICES:EXTERIOR. Supersedes Technical Service Bulletin Group 66 number 13-39 dated December 9, 2013. Customer may report hearing wind noise from the front door area when the vehicle is driven at highway speeds. After diagnosis, it is determined that the source of the wind noise is the exterior rear view mirrors. The two main sources of wind noise from the exterior rear view mirrors are: the seam surrounding the turn signal lamp and the seam at the mirror base. The modifications explained in the Service section of this bulletin will effectively mitigate the wind noise symptom for the customer. |
| A391515 2028902- | 2017-10-21. Service bulletin. POWER TRAIN. Supersedes Technical Service Bulletin Group 39 number 14-14 dated May 5, 2014. A squealing, howling, or whistling noise may be heard coming from under the vehicle. The condition is typically noticed when the vehicle is cold (normally below freezing) and is moving at speeds of 5 - 60 mph. The noise is from the intermediate bearing of the propeller shaft. |
| A191558 2036852- | 2017-10-21. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN. Cooling fans stay on after engine is turned off. The cooling fans may operate for up to 10 minutes after the engine is turned off. This function is mapped to specific driving patterns and vehicle operating modes (for example, DPF regeneration). This is normal operation, and no parts should be replaced. |
| A171561 2030197- | 2017-10-21. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 17 number 15-59 dated March 17, 2015. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owner's Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, the ambient temperature, and road conditions. Additional factors are the amount of oil dilution from water condensation or fuel residue, and the oxidation level of the oil. Under certain driving conditions, internal engine pressure conditions in the 3.0 TFSI engine can negatively influence the rate of oil consumption. This can occur while the vehicle is operated in city driving conditions. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.