WenmarOpen by Wenmar Pro

Service bulletin SSM 48969

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10177701
Published by NHTSA2020-08-04
Manufacturer's numberSSM 48969
Manufacturer's date2020-07-10
NHTSA componentSERVICE BRAKES, HYDRAULIC

NHTSA's summary

Some 2020 Explorer/Aviator vehicles may exhibit a perceived lack of power brake assist or extended brake pedal travel at initial vehicle start up with diagnostic trouble code (DTC) C0047:64 stored in the anti-lock brake system (ABS) module. The vehicle may also exhibit an illuminated ABS, Advance Trac, and/or red brake warning lamp, and possible Advance Trac Fault message displayed. This may be caused by the software in the ABS module. To correct the condition, reprogram the ABS module using the latest software level of the appropriate Ford diagnostic scan tool. For claiming, use causal part 2005 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Brakes

Trouble codes named

C0047

Vehicles listed
FORD EXPLORER2020
LINCOLN AVIATOR2020

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
23V1990002023-03-24. PARKING BRAKE:ELECTRICAL; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM)
20193912019-08-09. Brakes
19V5750002019-08-05. PARKING BRAKE; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL)

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
TSB 23-21202023-05-23. Service bulletin. Some 2018-2021 Expedition/Navigator and 2020-2021 Explorer/Aviator vehicles equipped with a 10R80/10R80 MHT or 10R60 may exhibit a momentary transmission neutral-out condition while in drive. Vehicle may also have diagnostic trouble code (DTC) P07E6 and/or P07E4 stored in the powertrain control module (PCM) or transmission control module (TCM) and/or a possible audible noise. This may be due to a leak in the park valve circuit. To correct the condition, follow the Service Procedure to inspect the park system hardware for wear or damage and replace the valve body separator plate with an improved valve body separator plate.
SSM 513742023-03-04. Service bulletin. Some 2020-2021 Escape/Bronco Sport/Explorer and 2020-2021 Corsair/Aviator vehicles equipped with electric brake booster (EBB) built on or before 1-Aug-2022 may exhibit an illuminated anti-lock brake system (ABS) warning indicator and stability-traction control warning indicator with diagnostic trouble code (DTC) U3000:96 erroneously stored in the ABS module. This condition occurs during connection or power interrupt to the EBB module. If this code is stored and the ABS system has been reassembled, clear the DTC code using Ford Diagnosis and Repair System (FDRS) scan tool and check for recurrence. If the DTC persists, perform normal diagnostics. Refer to the Workshop Manual (WSM), Section 206-09 Anti-Lock Brake System. For claiming use the causal part number 2C219 and applicable labor operations in Section 2 of the Service Labor Time Standards.
SSM 512612023-01-06. Service bulletin. Some Ford and Lincoln vehicles may exhibit noise when the brakes are applied. When diagnosing and repairing brake noise conditions, use the Workshop Manual (WSM) and the appropriate pinpoint test in section 206-00. The brake rotors should only be machined if directed by the WSM because one or more of the following conditions are present on the braking surface: scoring, excessive corrosion/rust or pitting, bluing/discoloration and/or heat spots. For additional information, refer to WSM section 206-00.
SSM 511202022-10-11. Service bulletin. Some Ford and Lincoln vehicles may exhibit noise when the brakes are applied. When diagnosing and repairing brake noise conditions, use the Workshop Manual (WSM) and the appropriate pinpoint test in section 206-00. The brake rotors should only be machined if directed by the WSM because one or more of the following conditions are present on the braking surface: scoring, excessive corrosion/rust or pitting, bluing/discoloration and/or heat spots. For additional information, refer to WSM section 206-00.
SSM 504722022-02-16. Service bulletin. Some 2021-2022 Bronco vehicles equipped with the 2.3L engine may exhibit a red brake warning lamp and/or brake system warning message in the instrument panel cluster (IPC) with a diagnostic trouble code (DTC) P050F in the anti-lock brake system (ABS) module and a firm brake pedal. This may be due to contamination in a brake booster vacuum line. To correct this condition, replace the vehicle's vacuum hose (MB3Z-2420-A). Refer to Workshop Manual (WSM), Section 206-09 for installation instructions. For claiming, use casual part 2420.
TSB 21-22932021-09-30. Service bulletin. Some 2020-2021 Explorer/Aviator hybrid vehicles may exhibit a brake pedal pulsation or vibration when the brakes are applied. The customer may state that the anti-locking brake system (ABS) system is activating without any indicators on the instrument panel cluster (IPC). This may be due to the regenerative braking software in the ABS module. To correct the condition, follow the Service Procedure Steps to perform a coordinated flash on the powertrain control module (PCM) and ABS module.
SSM 500642021-09-04. Service bulletin. Some 2013-2021 Ford and Lincoln vehicles may exhibit noise when the brakes are applied. When diagnosing and repairing brake noise conditions, use the Workshop Manual (WSM) and the appropriate pinpoint test in section 206-00. The brake rotors should only be machined if directed by the WSM because one or more of the following conditions are present on the braking surface: scoring, excessive corrosion/rust or pitting, bluing/discoloration and/or heat spots. For additional information, refer to WSM section 206-00.
20B512021-03-03. Service bulletin. In some of the affected vehicles, the Electric Brake Booster (EBB) may contain a cracked solenoid valve plunger that may break and move out of position. A dislocated valve plunger may lead to the driver experiencing any of the following symptoms: Hard brake pedal, over-braking condition, and if certain other conditions are present, longer brake pedal travel with an incremental increase in stopping distance that would be accompanied by a red brake warning indicator lamp on the instrument panel cluster
TSB 21-20302021-03-02. Service bulletin. Some 2020-2021 Explorer/Aviator/Police Interceptor Utility vehicles built on or before 24-Dec-2020 may exhibit an illuminated anti-lock brake system (ABS) warning indicator lamp with diagnostic trouble code (DTC) C0020 stored in the ABS module. It may not be necessary to replace the ABS module/hydraulic control unit (HCU) to resolve DTC C0020. This may be due to a poor ground connection and/or improper plating on the attachment bolts at G108. To correct the condition, follow the Service Procedure to replace and properly tighten the ground cable fasteners.
TSB 21-20172021-02-04. Service bulletin. This article supersedes TSB 20-2364 to update the production fix date. Some 2020 Explorer/Aviator/Police Interceptor Utility vehicles built on or before 24-Dec-2020 may exhibit an illuminated anti-lock brake system (ABS) warning indicator lamp with diagnostic trouble code (DTC) C0020 stored in the ABS module. It may not be necessary to replace the ABS module/hydraulic control unit (HCU) to resolve DTC C0020. This may be due to a poor ground connection and/or improper plating on the attachment bolts at G108. To correct the condition, follow the Service Procedure to replace and properly tighten the ground cable fasteners.