NHTSA recall 19V575000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 19V575000 |
| Manufacturer's number | 19C06 |
| Manufacturer | Ford Motor Company |
| Reported | 2019-08-05 |
| Owners notified | 2019-08-23 |
| Component | PARKING BRAKE; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL) |
| Units potentially affected | 13896 |
| Report | Quarterly report 8, for 2021 quarter 2 |
|---|---|
| Filed with NHTSA | 2023-03-21 |
| Vehicles in the campaign | 13896 |
| Reported remedied | 13695 (98%) |
| Reported unreachable | 1 |
| Reported removed | 0 |
These are the manufacturer's totals for the whole campaign at the end of 2021 quarter 2, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.
What is wrong
Ford Motor Company (Ford) is recalling certain 2020 Explorer and Lincoln Aviator vehicles. The Manual Park Release (MPR) cover may not be installed. In addition, the vehicles may be in Factory Mode, which disables warning alerts and does not display the transmission gear selected. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) numbers 114, "Theft Prevention" and 102, "Trans Shift Lever Seq/Starter Interlock/Trans Braking Effect."
What can happen
Without the cover, the MPR lever may be unintentionally moved, allowing the vehicle to roll away. Being in Factory Mode, the vehicle will not display warnings and/or gear selection on the instrument cluster. Both conditions increase the risk of a crash.
The remedy
Ford will notify owners, and dealers will inspect and, if necessary, install a MPR cover. Dealers will verify the instrument cluster is not in Factory Mode and clear any fault codes, free of charge. The recall began August 23, 2019. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19C06.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
| 2020 FORD EXPLORER | Built 2019-03-27 to 2019-07-24. |
|---|---|
| 2020 LINCOLN AVIATOR | Built 2019-04-10 to 2019-07-24. |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 52244 | 2024-02-14. Service bulletin. Some 2021-2023 F-150 vehicles equipped with a 3.5L PowerBoost hybrid engine, 2020-2023 Explorer vehicles equipped with a 3.3L hybrid engine and 2020-2023 Aviator vehicles equipped with a 3.0L hybrid engine may exhibit a malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P0A1E stored in the powertrain control module (PCM) and auto start/stop disabled. This may be due to a loose wiring connection to the belt integrated starter generator (BISG). The Workshop Manual (WSM) has recently been updated to provide new direction for DTC P0A1E. Refer to the WSM, Section 303-06 Starting System, Diagnosis and Testing, Starting System for applicable diagnosis. |
|---|---|
| SSM 51764 | 2023-07-03. Service bulletin. Some 2020-2023 Explorer/Aviator vehicles equipped with a 3.0L EcoBoost may exhibit an illuminated malfunction indicator lamp (MIL) and low oil pressure warning in the instrument panel cluster (IPC), with diagnostic trouble codes (DTC) P0521 and/or P0524 in the powertrain control module (PCM). This condition may be caused by an internal oil pressure leak. If pinpoint test E in the Workshop Manual (WSM) Section 303-01B directs you to the replacement of the oil pump, upon reassembly inspect that the main oil gallery tube (6718) is assembled and aligned properly on the back of the engine front cover. The engine oil gallery seal (00815) must be replaced any time the front cover is removed (per WSM Section 303-01B). The WSM front cover removal and installation procedure is in the process of being updated. |
| TSB 23-2176 | 2023-06-13. Service bulletin. Some 2020-2022 Explorer vehicles equipped with 2.3L engine and 10R60 automatic transmission may exhibit a delayed reverse engagement. This may be due to the software in the powertrain control module (PCM). To correct the condition, follow the Service Procedure to reprogram the PCM. |
| TSB 23-2120 | 2023-05-23. Service bulletin. Some 2018-2021 Expedition/Navigator and 2020-2021 Explorer/Aviator vehicles equipped with a 10R80/10R80 MHT or 10R60 may exhibit a momentary transmission neutral-out condition while in drive. Vehicle may also have diagnostic trouble code (DTC) P07E6 and/or P07E4 stored in the powertrain control module (PCM) or transmission control module (TCM) and/or a possible audible noise. This may be due to a leak in the park valve circuit. To correct the condition, follow the Service Procedure to inspect the park system hardware for wear or damage and replace the valve body separator plate with an improved valve body separator plate. |
| SSM 51032 | 2022-08-22. Service bulletin. Some 2020-2022 Explorer/Aviator vehicles may exhibit automatic transmission fluid (ATF) contamination in the engine cooling system due to the transmission cooler. If the cooling system becomes contaminated with ATF, the system must be flushed clear of the contamination after the source of the contamination has been repaired. It is generally not necessary to replace the following components due to ATF contamination in the cooling system: radiator, heater core, de-gas bottle, water pump, auxiliary water pump, coolant control valves, temperature sensors, thermostat, turbocharger, heat exchangers, tubes, gaskets/O-rings/seals (unless removed), or rubber coolant hoses (unless swollen). |
| SSM 50885 | 2022-06-30. Service bulletin. 2020-2022 Explorer/Aviator and 2021-2022 F-150 hybrid vehicles equipped with a 10R80 MHT require the Transmission Strategy Download application in the Ford Diagnosis and Repair System (FDRS) to be run after certain transmission or module repairs. The Transmission Strategy Download routine is failing in FDRS levels 32.5.3 and 32.5.4. The FDRS development team is working to resolve this in a future release of FDRS. In the meantime, uninstall FDRS from the computer using the select all function to remove all data and recordings. Reinstall the older FDRS version 31.6.5 using this url - http://www.fordservicecontent.com/Ford_Content/IDS/FDRS/FDRS_31.6.5.exe Once 31.6.5 is installed, download and run the Transmission Strategy Download application. |
| SSM 50622 | 2022-03-30. Service bulletin. Some 2020 - 2022 Explorer/Aviator/Police Interceptor Utility vehicles may display a distance to empty value in the instrument panel cluster (IPC) that does not correctly represent the actual fuel level of the vehicle. This may be due to excessive idling and/or a learned value in the powertrain control module (PCM) that is incorrect. To correct the condition, perform the PCM - Reset the Keep Alive Memory (KAM) application in the appropriate Ford diagnostic scan tool. For claiming, use Causal Part 12A650 and applicable labor times from Section 10 in the Service Labor Time Standards (SLTS) Manual. |
| TSB 21-2452 | 2022-01-01. Service bulletin. Some 2020-2021 Aviator vehicles equipped with a 3.0L PHEV powertrain may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) U0100, P1A42 and/or P1A43 stored in battery energy control module (BECM). This may be due to software in the PCM. To correct the condition, follow the service procedure to perform a coordinated flash on the powertrain control module (PCM), secondary on-board diagnostic module c (SOBDMC), anti-lock braking system (ABS) module, BECM, and battery charger control module (BCCM). |
| TSB 21-2434 | 2022-01-01. Service bulletin. Some 2020-2022 Explorer/Aviator/Police Interceptor Utility vehicles and 2021 F-150 vehicles equipped with a 10R80 MHT automatic transmission may exhibit a harsh/delayed engagement and/or a harsh/delayed shift with or without an illuminated malfunction indicator lamp (MIL) or diagnostic trouble codes (DTC) P0729, P0731, P0732, P0733, P0734, P0735, P0736, P076F, P07D9, P07F6, P07F7, P2700, P2701, P2702, P2703, P2704 and/or P2705 stored in the powertrain control module (PCM). This may be due to sticking valves in the main control valve body. To correct the condition, follow the Service Procedure steps to perform the PCM - Transmission Accelerated Main Control Break In routine for the appropriate clutch(s) and/or overhaul the main control valve body. |
| SSM 50170 | 2021-10-29. Service bulletin. Some 2020-2021 Navigator and 2020-2022 Aviator vehicles may exhibit a condition where the degrees do not appear in the SYNC screen when adjusting the climate control temperature. This may be due to the SYNC software installed in the accessory protocol interface module (APIM). Engineering is currently developing a software update that is expected in January 2022. Once the software update is available, it will be made available to customers who have enabled SYNC 3 Automatic Updates with their vehicle connected to a Wi-Fi network. Repair appointments should be scheduled for customers in February 2022 who do not receive Automatic Updates. Monitor OASIS for updates. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.