Service bulletin 05154262A
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10140197 |
| Published by NHTSA | 2018-06-11 |
| Manufacturer's number | 05154262A |
| Manufacturer's date | 2016-08-10 |
| NHTSA component | WHEELS |
NHTSA's summary
Hub & Bearing Assy - Front For LA, LD SRT vehicles with the 2-piece front brake rotor (BR7 sales code), do NOT replace the front Hub & Bearing Assy for a clicking noise occurring while turning during low speed parking lot maneuvers. Instead, remove front wheels and rotors and clean mating surfaces (wheel mounting face, rotor mounting faces (both sides), and hub face) with a Scotch Brite Pad or equivalent, and re-assemble.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Wheels
| DODGE CHALLENGER | 2015 |
|---|---|
| DODGE CHARGER | 2015 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 05154262A | 2022-12-19. Service bulletin. Hub & Bearing Assy - Front For LA, LD SRT vehicles with the 2-piece front brake rotor (BR7 sales code), do NOT replace the front Hub & Bearing Assy for a clicking noise occurring while turning during low speed parking lot maneuvers. Instead, remove front wheels and rotors and clean mating surfaces (wheel mounting face, rotor mounting faces (both sides), and hub face) with a Scotch Brite Pad or equivalent, and re-assemble. |
|---|---|
| 9003418 | 2022-10-24. Service bulletin. Rotor - Front 2 Piece For LA, LD SRT vehicles with the 2-piece Front Rotor (BR7 sales code), do NOT replace the rotor for a clicking noise occurring while turning at low parking lot speeds. Instead, remove front wheels and rotors and clean mating surfaces (wheel mounting face, rotor mounting faces (both sides), and hub mounting face) with a Scotch Brite Pad or equivalent, and reassemble. When installing wheel, MUST use clicker/torque wrench, set to 110 ft-lb (150 Nm). |
| 300122 | 2022-10-17. Service bulletin. Charger Pursuit All Wheel Drive (AWD) Front Halfshafts |
| 0500415 | 2022-09-26. Service bulletin. Incorrectly installed front wheel speed sensor wire. |
| 08-104-14 | 2022-08-22. Service bulletin. RA2 And RJ2 Radio Software Enhancements This bulletin involves updating the radio's software. A customer may have experience one or more of the following: Backup camera screen may have static lines and/or shutters. The backup display may flash the previous image before displaying the current image. Can?t cancel compass calibration. When in compass calibration and the browse/enter button is pressed, Compass Calibration Failed will be displayed. Incorrect blind spot chime. After the audio was muted, audio doesn?t resume using Voice Recognition (VR). Information from disconnected USB flash drive is still displayed on the radio. VR session may not cancel using steering wheel switches. Back button on Integrate Center Stack (ICS) may not work at times. AM/FM is still audible when USB flash drive is plugged in. Radio screen may be black when powered up. When using steering wheel controls, the radio presets with start at preset 2 instead of preset 1. Unintentionally changing AM/FM stations when trying to scroll up or down a song list. This happens when a USB or Phone is plugged into the USB port.Improvements: iPhone functionality improvement to play music after ending calls. When SD card is used, phone lists will be properly displayed. New feature will not allow changes to settings in accessory mode. |
| 23-012-17 REV. A | 2022-08-08. Service bulletin. Wheel Liner Push Pin Fastener Replacement This bulletin involves replacing both wheel liner push pin fasteners at the front fenders. The customer may describe a rattle from the left, right or both, front wheel openings while driving. This condition is caused from one or both plastic front wheel liner fasteners loosening from their locations. |
| 9003655 | 2022-08-08. Service bulletin. Rear Axle Assembly If replacing Limited Spin Differential (LSD)/Anti-Spin Differential rear axles for any reason, the Mopar replacement axle will need the oil drained and re-filled with oil PN: 68083381AA (which contains updated friction modifier). This change was recently introduced in production to help address axle noise concerns being reported from the field while the vehicle is performing tight turning maneuvers. Failure to do so may result in a customer returning with noise complaints. NOTE: If the Mopar replacement axle serial number is past the following dates below for the corresponding axle part numbers, DO NOT DRAIN AND REFILL. The replacement axle will already have new fluid: Axle Part#: 53010668XX ? Serial # T03UG0047EXXXX Axle Part#: 53010669XX ? Serial # T03UG0047GXXXX Axle Part#: 68269917XX ? Serial # T03UG0037JXXXX Axle Part#: 05038703XX ? Serial # T03UG0047HXXXX Otherwise, perform the following repair procedure in the order given: 1. Follow standard rear axle installation procedure. Refer to the detailed service procedures available in DealerCONNECT> TechCONNECT under: Service Info> 03 - Differential and Driveline> Rear Axle> Installation>Standard Procedure>Rear Axle 2. Follow standard axle fluid drain/re-fill service procedure in TECHCONNECT. Refer to the detailed service procedures available in DealerCONNECT> TechCONNECT under: Service Info> 03 - Differential and Driveline> Rear Axle> Standard Procedure>Standard Procedure - Fluid Drain and Fill |
| 08-095-15 | 2022-08-08. Service bulletin. RA2 And RJ2 Radio Software Enhancements This bulletin involves updating the radio's software. A customer may have experience one or more of the following: ? Radio Display may freeze or go blank. ? Display shows multiple USB media song titles in the browse menu. ? Backup camera screen may have static lines and/or shutters. ? The backup display may flash the previous image before displaying the current image. ? Can?t cancel compass calibration. ? When in compass calibration and the browse/enter button is pressed, Compass Calibration Failed will be displayed. ? Incorrect blind spot chime. ? After the audio was muted, audio doesn?t resume using Voice Recognition (VR). ? Information from disconnected USB flash drive is still displayed on the radio. ? VR session may not cancel using steering wheel switches. ? Back button on Integrate Center Stack (ICS) may not work at times. ? AM/FM is still audible when USB flash drive is plugged in. ? Radio screen may be black when powered up. ? When using steering wheel controls, the radio presets with start at preset 2 instead of preset 1. ? Unintentionally changing AM/FM stations when trying to scroll up or down a song list. This happens when a USB or Phone is plugged into the USB port. Improvements: ? iPhone functionality improvement to play music after ending calls. ? When SD card is used, phone lists will be properly displayed. ? New feature will not allow changes to settings in accessory mode. |
| 05-004-15 | 2021-05-03. Service bulletin. Incorrectly installed front wheel speed sensor wire. |
| 9003206 | 2018-11-19. Service bulletin. Part Description: Wheel Issue Description: Wheel appears to have debris or film built up in black wheel pockets. Be sure to clean wheel first to see if film/debris can be removed before ordering new wheel.~ |