Service bulletin 9003418

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10224682
Published by NHTSA	2022-10-24
Manufacturer's number	9003418
Manufacturer's date	2017-08-02
NHTSA component	ENGINE AND ENGINE COOLING; BACK OVER PREVENTION; SERVICE BRAKES; WHEELS

NHTSA's summary

Rotor - Front 2 Piece For LA, LD SRT vehicles with the 2-piece Front Rotor (BR7 sales code), do NOT replace the rotor for a clicking noise occurring while turning at low parking lot speeds. Instead, remove front wheels and rotors and clean mating surfaces (wheel mounting face, rotor mounting faces (both sides), and hub mounting face) with a Scotch Brite Pad or equivalent, and reassemble. When installing wheel, MUST use clicker/torque wrench, set to 110 ft-lb (150 Nm).

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Brakes, Driver assistance, Engine, Wheels, Backup camera

Vehicles listed
DODGE CHALLENGER	2015, 2016, 2017
DODGE CHARGER	2015, 2016, 2017

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
9003357	2024-01-02. Service bulletin. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
08-233-22	2023-01-17. Service bulletin. UDQ Radio Enhancements This bulletin involves inspecting and if required, updating the radio to software: 16.11. Customers may experience one or more of the following: Vehicle Finder feature on Sirius® Guardian inop. Excessive weather alerts. Radio freezes and resets after start-up. Navigation will not load when selected on the radio screen. Rear view camera does not display on the screen (unless the screen is blue which indicates a poor camera connection). Applications not launching from the app screen. USB port will not play music from a USB flash drive. Inaccurate location of the vehicle on the navigation map. Paired phones will not connect via wireless connectively. Radio screen will not dim with the thumb wheel when adjusting the cluster brightness. Map screen does not return after rear view camera clears. Performance Control&Performance Page app not performing as expected. Wireless connectively phone call audio too low (requires volume levels above 30 to be audible). Song information on radio screen doesn?t match the song playing. Navigation GPS says not available. Surround sound state not shown correctly. Responding to the Favorites notification does not go to that song. Compass not showing up. No sound or navigation when the radio is in customer mode. No SXM (Sirius XM) audio for channels 301 and above.
0500122	2023-01-09. Service bulletin. Front Click Noise at Low Speed Turns This bulletin involves installing a friction disc kit on both front hub bearing surfaces between the hub and rotor. The customer may comment on the following:When making a sharp turn at low speed (parking lot) maneuvers, a click noise is heard. Most of the time the noise can be heard if the windows are open.
2102016	2022-12-19. Service bulletin. Manual Transmission Shifter Noise This bulletin involves greasing or replacing the manual transmission rear shifter bushing. Customers may experience a clunk, squeak, or similar noise heard from center console area while shifting.
2103917	2022-10-24. Service bulletin. Flash: Transmission Diagnostic and Shift Enhancements This bulletin involves reprogramming the Transmission Control Module (TCM) with the latest available software. Customers may experience a less than desirable down shift during one or more of the following:3-2 coast-down shift. 2-1 coast-down shift. 6-5 coast-down shift. The following software enhancement is available for(6.4L Only):Reduce bumps felt on light to medium decel braking while coming to a stop. Bump could be described as a push, driveline clunk, or engine flare noise right after the 5-4 downshift. The vehicle speed may vary based on the rate of deceleration.
1807517	2022-10-24. Service bulletin. Flash: Powertrain Diagnostic and System Improvements This bulletin involves reprogramming of the Powertrain Control Module (PCM) with the latest software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following DTCs: P000B - Bank 1 Camshaft 2 Position Slow Response. P0016 - Crankshaft/Camshaft Timing Misalignment - Bank 1 Sensor 1. P0335 - Crankshaft Position Sensor Circuit. P0339 - Crankshaft Position Sensor Intermittent. P0441 - EVAP Purge System Performance. P0455 - EVAP System Large Leak. P2610 - PCM Internal Engine Off Timer Performance. P0456 - EVAP System Small Leak. P2299 - Brake Pedal Position/Accelerator Pedal Position Incompatible. Customers may also notice the following condition(s): Brief engine idle fluctuation while in hot ambient temperatures. A slight hesitation during light pedal application after engine cold start. Driveline noises. Engine stumble/hesitation on a very hard pedal acceleration from a dead stop. Transmission enhancements during low-speed braking turning maneuvers. False detonation (spark knock) detected during a wide-open throttle (LA Challenger Sales Codes ESH with DEC only). In addition, the following software enhancements are available: Reduce bumps felt on light to medium decal braking and coming to a stop. Launch spark improvement change from 35 MPH to 10 MPH. Reverse lock out speed change from 10 MPH to 3 MPH (Sales Code DEC only). Torque security calibration changes to desensitize brake throttle override entry conditions. Calibration changes to address engine speed undershoot/overshoot during clutch disengagement when coming to a stop (Sales Code DEC only). Start fuel and transient fuel calibration change for improved drivability robustness. Purge calibration changes for a more robust purge volume result at altitude. Individual Cylinder Fuel Control (ICFC) calibration changes for improved fueling offset accuracy.
0807017	2022-10-24. Service bulletin. UAQ Radio Enhancements This bulletin involves inspecting and if required, updating the radio software. Customers may experience the following:Navigation will not load when selected on the radio screen.
1807017	2022-10-24. Service bulletin. Flash: Powertrain Diagnostic and System Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. The following software enhancements are available:Reverse gear lock-out change from 16 kph (10 mph) to 4.8 kph (3 mph)(Sales Code DFC). PCM to allow transmission gear shifting in the limp-in mode rather than fixed gear(Sales Code DFE).
9003704	2022-09-26. Service bulletin. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
2303714	2022-09-26. Service bulletin. Wind Noise At The Left And/Or Right Door This bulletin involves repositioning the outer door mounted window seal flag. The customer may describe a wind noise at the left and/or right door.