Service bulletin SSM 46456
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10100045 |
| Published by NHTSA | 2017-05-22 |
| Manufacturer's number | SSM 46456 |
| Manufacturer's date | 2017-03-14 |
| NHTSA component | EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL |
NHTSA's summary
SOME 2017 F-SUPER DUTY VEHICLES EQUIPPED WITH A 6.7L ENGINE AND BUILT ON OR BEFORE 07-FEB-17 MAY EXHIBIT A ILLUMINATED MALFUNCTION INDICATOR LAMP (MIL) ON WITH DTC P06A6, P0193, P02E9, P0335, P0532 AND/OR P2454. THIS MAY BE DUE TO A CONCERN WITH THE REFERENCE VOLTAGE OR SIGNAL RETURN CIRCUIT OF THE CRANKSHAFT POSITION SENSOR (CKP) WIRING. INSPECT CKP SENSOR HARNESS CIRCUITS APPROXIMATELY 381MM(15 INCHES) FROM THE CKP SENSOR CONNECTOR FOR DAMAGE OR EVIDENCE OF BEING PINCHED. IF A WIRING CONCERN IS FOUND, REPAIR AS DIRECTED PER WIRING DIAGRAM SECTION 5. USE CAUSAL PART 12B637 AND UTILIZE APPLICABLE LABOR OPERATIONS FROM SECTION 10 OF THE SERVICE LABOR TIME STANDARDS (SLTS) MANUAL.
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Equipment and accessories, Labels and manuals
Trouble codes named
P0193, P02E9, P0335, P0532, P06A6, P2454
| FORD F-250 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
|---|---|
| FORD F-350 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-450 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-550 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-650 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-750 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 19V429000 | 2019-06-07. EQUIPMENT |
|---|---|
| 19V401000 | 2019-05-29. EQUIPMENT |
| 19V278000 | 2019-04-08. ENGINE; EQUIPMENT:ELECTRICAL |
| 2017276 | 2017-05-23. Accessories |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| SSM 52476 | 2024-05-03. Service bulletin. All accessory stick-on keyless entry keypads come with a wallet card containing the master code. If the accessory keypad was factory installed, this card will be placed in the glove box and should be handed to the vehicles owner during initial delivery. Unlike the integrated (wired) factory keypad, the accessory keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool. If the wallet card for an accessory keypad is lost, follow these steps to recover the code. Dealer Key Code access is granted through the Dealer Program Enrollment System (DPES); dealership management can authorize users. The authorized user must go to FMCDealer.com > Parts and Service > Parts Product Line Information > Keys/Entry Devices > Aftermarket Keyless Entry Keypad Code Access. Follow the instructions on the screen to obtain the master code for the accessory keypad. |
|---|---|
| 22M03 S1 | 2024-05-02. Service bulletin. Certain 2017-2020 Model Year Continental and Super Duty, 2018-2020 Navigator, 2020 Aviator, and 2020 Explorer Vehicles Replace Front and/or Side Cameras if Foggy |
| SSM 51947 | 2023-10-06. Service bulletin. Some 2015-2019 F-Super Duty and 2015-2020 F-150/Mustang vehicles may require replacement of the powertrain control module (PCM) for various reasons. While performing a programmable module installation (PMI) using the Integrated Diagnostic Service (IDS) scan tool, an error message may state: Configuration Failed, Would You Like To Retry? This may be due to improper module replacement steps. Make sure that the original module is installed in the vehicle, delete the vehicle session, then start a new vehicle session. Once the session starts, run the PCM PMI and install the new PCM only when the scan tool instructs. Finish the PMI by following the prompts given by IDS. If the original PCM is not available, it is possible to configure the module by running as-built programming on the PCM. When IDS asks to obtain part numbers or configuration data, select configuration data. |
| SSM 51937 | 2023-10-05. Service bulletin. Some vehicles equipped with power folding mirrors may exhibit power folding mirrors that are inoperative or exhibit a clicking sound. This may be due to the mirrors being manually folded in, during transportation, going through a car wash, bumped in a parking lot, or found during pre-delivery inspection (PDI). Prior to the replacement of any components, attempt to synchronize the mirrors by following the Power Mirrors Synchronization procedure. Refer to Workshop Manual (WSM) Section 501-09 Rear View Mirrors - General Procedures - Power Mirrors Synchronization. |
| SAN-Vol1 I1 | 2023-08-16. Service bulletin. The Service Awareness Newsletter is an informal communication that contains information that may not be presently available in a TSB, SSM, GSB, or other electronic communication. This article includes information on warranty, technical service tips and other service information. |
| SSM 51829 | 2023-08-14. Service bulletin. Some F-Super Duty and F-150 vehicles equipped with trailer tow mirror may exhibit various exterior rear view mirror functional concerns that require replacement after diagnosis. To properly determine if the defect is warrantable, cleaning and close inspection of the affected mirror may be required. To aid in proper warranty determination, the Rear-View Mirror Analysis general service bulletin (GSB) has been updated with a detailed cleaning procedure that should be followed prior to any inspection. New labor operations (17682ZZ or 17682ZZT) have been created that covers the cleaning and inspection process and may be used even if condition of failure is non-warrantable. Ford has inspected numerous returned parts and determined many cases are caused by damage which is unwarrantable and may be subject to chargeback. Refer to the latest version of the GSB on OASIS. |
| 22M03 | 2023-07-07. Service bulletin. Certain 2017-2020 Model Year Continental and Super Duty, 2018-2020 Navigator, 2020 Aviator, and 2020 Explorer Vehicles Replace Front and/or Side Cameras if Foggy |
| 20N04 S2 | 2023-06-06. Service bulletin. Certain 2017-2019 MY F250/F350 and all F450/550 vehicles Steering Linage Damper replacement. Reason for this supplement: Updated program terms, includes new mobile service repair assessment and updated owner letters with revised program terms. |
| TSB 23-2115 | 2023-05-04. Service bulletin. Some 2015-2020 F-150 and 2017-2022 F-Super Duty vehicles may exhibit a lack of heat or cooling from the cabin vents when the climate control settings are adjusted between hot and cold. This may be due to a stuck/binding temperature door within the climate control housing or binding/inoperative temperature door actuator. Diagnostic trouble code (DTC) B1081:07 may be present in the front controls interface module (FCIM) or heating ventilation and air conditioning (HVAC) module. To correct the condition, follow the Service Procedure to remove the climate control housing and replace the temperature door cam(s), lubricate the temperature blend door bearing surface, and apply flock tape to actuator to seal out debris. |
| SSM 51265 | 2023-01-06. Service bulletin. Some vehicles equipped with power folding mirrors may exhibit power folding mirrors that are inoperative or exhibit a clicking sound. This may be due to the mirrors being manually folded in, during transportation, going through a car wash, bumped in a parking lot, or found during pre-delivery inspection (PDI). Prior to the replacement of any components, attempt to synchronize the mirrors by following the Power Mirrors Synchronization procedure. Refer to Workshop Manual (WSM) Section 501-09 Rear View Mirrors - General Procedures - Power Mirrors Synchronization. |