Transport Canada recall 2013187
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2013187 |
| Manufacturer's number | 13S05 |
| Reported | 2013-05-29 |
| Component | Electrical |
| Notification type | Safety Mfr |
| Units potentially affected | 393 |
What is wrong
On certain vehicles, insulation on the engine block heater power cord may become damaged if the cord is handled during very cold days (temperatures below -20C). This could create an electrical shock hazard, which could result in personal injury. Correction: Dealers will replace the block heater cord.
| 2013 LINCOLN MKZ |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| TSB160031 | 2021-12-20. Service bulletin. 2.0L GTDO - Illuminated MIL with DTC p2096 - Built on 09/01/2012 and through 08/01/2013 |
|---|---|
| LTR3756 | 2021-12-20. Service bulletin. 49 CFR Part 579.5 Monthly Communications - January 2016 |
| 16-0075 | 2020-12-07. Service bulletin. Some 2013 Escape, 2013-2014 Fusion and MKZ vehicles built on or before 11/9/2013 may exhibit a hard start, no start and/or a loss of engine RPM after refueling. Some vehicles may also exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P1450 and/or P0456 stored in powertrain control module (PCM) memory. |
| 16-0066 | 2020-12-07. Service bulletin. Some 2012-2016 vehicles equipped with a touchscreen navigation system and the language set to Arabic may exhibit a blank screen. This may be the result of the ribbon cables not being fully seated inside the front display interface module (FDIM) or an improper software configuration of the FDIM. |
| TSB 20-2386 | 2020-12-05. Service bulletin. Some 2013-2020 MKZ vehicles may need the exterior rear view mirror replaced. The replacement exterior mirror will have different wiring than the originally equipped mirror. Follow the Service Procedure steps below to modify the vehicle-side wiring harness to accept the replacement mirror wiring. |
| SSM 48858 | 2020-06-04. Service bulletin. Some 2012-2020 Ford and Lincoln vehicles equipped with a TCU may exhibit an inoperative remote start with a 'Vehicle Failed To Start' message when using MyFord Mobile/Ford Pass/Lincoln Way mobile applications. The cellular cloud systems will only allow two remote start requests from the MyFord Mobile/Ford Pass/Lincoln Way apps without a vehicle drive event occurring. If a third remote start request is received, a Vehicle Failed To Start message will be displayed quickly in the mobile app. Once the vehicle is driven, the remote start counter is reset and will allow remote start commands to be sent from the mobile app. If the remote start system is not functioning using the key fob, refer to Workshop Manual (WSM) Section 303-06 for further diagnosis. |
| SSM 48406 | 2020-01-08. Service bulletin. Some 2013-2016 MKZ vehicles equipped with adaptive headlamps may exhibit a Check Headlamp System fault message in the instrument panel cluster (IPC) after installation of a new right headlamp. Diagnostic trouble code (DTC) B1D65 may also be stored in the headlamp control module (HCM). This may be due to a quality issue with the right headlamp service part, which was corrected on headlamps built on and after 17-Oct-2019. In addition, some headlamps with Earlier build dates were reworked with corrective actions and may be installed. Reworked headlamp assemblies are identified by having a green dot on the box and/or a green paint mark on the headlamp near the part number label. For claiming, use the headlamp base number as the causal part and applicable labor from the Service Labor Time Standards (SLTS) Manual. |
| TSB 19-2390 | 2020-01-07. Service bulletin. Some 2015-2019 F-150, 2015-2020 Explorer, 2017-2019 F-Super Duty, 2017-2020 Continental, 2018-2020 Expedition/Navigator, 2016-2018 MKX, 2019-2020 Nautilus, 2020 Aviator/Corsair and 2013-2020 MKZ vehicles equipped with multi-contour seats may exhibit intermittent multi-contour seat operation and/or massage and lumbar adjust inoperative from the seat switch or SYNC screen with or without diagnostic trouble code (DTC) B1471, U024B, and/or U024C. This may be due to terminal fretting at the connector for the driver multi-contour seat module (SCMG) and passenger multi-contour seat module (SCMH). To correct the condition, follow the Service Procedure steps to replace the connectors and reroute the harness. |
| SSM 48263 | 2019-11-05. Service bulletin. Some 2013-2016 MKZs vehicles with Adaptive Headlamps may exhibit a Check Headlamp System fault message in the instrument panel cluster (IPC) after one or both headlamps were replaced. Diagnostic trouble codes (DTCs) B1D64 and/or B1D65 may also be stored in the headlamp control module (HCM). Confirm the headlamps illuminate normally, but do not attempt additional repairs at this time. Engineering is investigating, monitor OASIS for updates. The swivel function will remain inoperative until a corrective action becomes available. The headlamps will continue to function to fully meet all applicable lighting requirements. |
| SSM 48123 | 2019-09-06. Service bulletin. For Ford and Lincoln vehicles that require positive or negative battery terminal replacement, it is not necessary to replace the complete battery cable harness (14300 and 14301) for this concern. Positive battery cable clamp BT4Z-14450-AA and negative battery cable clamp BT4Z-14450-BA are available for this type of repair. Do not cut or shorten the battery cable, instead carefully remove the affected battery cable clamp and clean the cable end as necessary to preserve wire length. Some rework may be necessary for some vehicle environments. Bend the new positive battery cable clamp as needed and crimp it to the existing battery cable. Make sure to use heat shrink tubing over the battery cable to battery cable clamp connection. Obtain the heat shrink tube locally. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.