Service bulletins for the 2007 Volkswagen Rabbit
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
318 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
| V871620 2005566 | 2018-01-08. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Update model and model year applicability. |
|---|---|
| TT 21-13-01 | 2017-12-14. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER. Tech Tips (Equipped with Turbocharged Engine Turbocharger Replacement Tip): If mechanical damage is found to the turbocharger (e.g. damaged compression wheel, loose or broken shaft), it is not enough to just replace the turbocharger. This document informs the procedure of checks for damage. |
| TT 37-11-05 | 2017-12-14. Service bulletin. POWER TRAIN. Tech Tips (Measure Value Block Request): If a request has been made for several MVBs from a DSG transmission, the test plan "Read measured values for obligation to report" can be selected. This function will retrieve all of the MVBs from the transmission which can be attached to a VTA ticket. This selection is available under Guided Functions or GFF when using VAS-PC, an example is shown below. |
| TT 90-06-56 | 2017-12-14. Service bulletin. EQUIPMENT:ELECTRICAL. Tech Tips (Clock Loses Time): This document informs of the procedure to preform if some customers comment that the clock is losing time. |
| V171302 2017813 | 2017-12-14. Service bulletin. ENGINE AND ENGINE COOLING. Technical Bulletin (Oil Consumption Measurement): Customer states oil consumption is higher than the Volkswagen oil consumption standard of up to 0.5 quarts per 600 miles, or 0.5 liters per 1000 km. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. This document informs of oil consumption tests to check a vehicles performance. |
| TT 00-13-02 | 2017-12-14. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Tech Tips (Technician Helpline Vehicle Check Sheets): When it becomes necessary to open a VW Technician Helpline VTA case while performing diagnosis for a diesel particulate filter, manual transmission repair, or turbocharger concern, it is recommended to complete the related worksheet/check sheet before calling. This document informs where Worksheets/Check Sheets are available on ServiceNet. |
| TT 90-11-10 | 2017-12-14. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. Tech Tips (Instrument Cluster Production Mode): During PDI, or after installation of a replacement cluster, ?Pro? may be displayed in place of the odometer. The high beam indicator may be flashing in the instrument cluster as well. This indicates the cluster is in Production mode. Production mode is not the same as ?Transport? mode. This document infroms of the difference between Production, and Transport mode. |
| TT 21-10-01 | 2017-12-05. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER. Tech Tips 92006-2014 Vehicles with 2.0T Gasoline Engine - N75 Solenoid Valve Diagnosis): When diagnosis on the above engine leads to the testing of the N75, please refer this document with graphical aid. The diagram shows which vacuum ports on the N75 valve should hold vacuum and which ones should not. Turbocharger fault codes P0299 and P0234 can be diagnosed using this test. |
| TT 45-09-03 | 2017-12-05. Service bulletin. STEERING. Tech Tips (Electro - Steering issues): If, after replacement of the steering rack, fault code 01309 008 is set in the ABS/ESP module only, follow the test plan in GFF for Driver Steering Recommendation (DSR) or channel 3 activation. If the test plan fails to clear the fault, follow the directions in this document |
| TT 57-10-11 | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM. Tech Tips (Comfort Module (J393) or BCM (J519) Replacement): This document informs If a comfort or body control module is replaced during normal diagnosis, make sure the factory mode has been switched OFF. This can be accomplished by selecting the test plan through GFF or through Vehicle Self Diagnosis in adaptation channel 99. Failure to deactivate factory mode will create a concern where the door locks will not lock and/or unlock with the switch and/or the remotes. |
| V171403 2017813 | 2017-12-05. Service bulletin. ENGINE. Technical Bulletin (Oil Consumption Measurement): Customer states oil consumption is higher than the Volkswagen oil consumption standard of up to 0.5 quarts per 600 miles, or 0.5 liters per 1000 km. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owners Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, the ambient temperature and road conditions. Further factors include the amount of oil dilution from water condensation or fuel residue and the oxidation level of the oil. This document discusses the "Fault Codes" necessary to diagnosis, and potential remedy of the issue. The fault codes for checking warranty coverage for servicing the vehicle are also available. |
| TT 20-06-101 | 2017-12-05. Service bulletin. ENGINE. Tech Tips (2.0L FSI (BPY) Engines - Low Fuel Pressure DTCs (P310B)): This document informs on how to check fuel pressure If you have a complaint of DTCs for the low side fuel pressure being out of specification |
| TT 48-10-04 | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM:WIRING. Tech Tips (with 1K0 Part Number J500 ? Replacement Steering Harness): If the steering rack is replaced on the above models for any reason, it is necessary to replace the steering harness as well. The new harness may be equipped with an extra connector. If all connections are made correctly, then it is necessary to remove that connector and tape the exposed wires back into the harness. Be sure to tape tightly in order to provide a water-tight repair. |
| Reference - Refl | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Quick Reference Update Guide: This document informs of the corresponding software/hardware and disc availability to the customer concerns about a vehicle |
| V001404 2010380 | 2017-12-05. Service bulletin. EQUIPMENT. Technical Bulletin (Squeaks, Rattles, Noise, Repair Materials): This doucment contains a list of components and applications developed to repair concerns of squeaks, rattles, noise and trim fit conditions. |
| V871402 2005566 | 2017-12-05. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. Technical Bulletin (HVAC, Unpleasant Odor): Condensation, which is a normal condition in all A/C systems, can cause a musty odor. If the odor is noticeable in the vehicle when the engine is not turned on, the cause may be mold and mildew in the passenger compartment, and not be related to the A/C system. All other possible sources of the odor must be investigated before this document can be performed. This document contains the procedure for the VW method to remove musty odors |
| V011407 2014603 | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Technical Bulletin This Technical Bulletin details the general process for carrying out a Software Version Management (SVM) software update for any Technical Bulletin (TSB) / Required Vehicle Update (RVU). |
| V011408 2014815 | 2017-12-05. Service bulletin. ENGINE. Technical Bulletin The use of contaminated gasoline, seasonal fuel changes (summer/winter fuel) or gasoline with a low content of deposit control additives may result in one or more of the following conditions: -Excessive accumulation of deposits on intake valves, intake manifold, fuel injectors and combustion chambers. -Engine runs rough after cold start. -Excessive engine cranking time. -Stumbles while driving. -Rough engine idle. -Loss of engine performance. -Poor fuel economy. This document informs of the procedure for the vehicle if it is diagnoised with poor quality gas |
| V871401 2005566 | 2017-12-05. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. Technical Bulletin (HVAC, Unpleasant Odor): Unpleasant odor is coming from Heating and Ventilation system. Odor mainly occurs after vehicle has been sitting (unused) at least 5 hours and within 20 to 60 seconds after vehicle is first started. Condensation is a normal characteristic in all A/C systems. If odor is noticeable continue to follow this document. Contaminants are effectively neutralized using the AIRCOMATIC? II Ultrasonic Climate System Cleaner (VAS 6189A) or AIRCOMATIC? III Ultrasonic Climate System Cleaner (VAS 6189B) and AIRCO-CLEAN? Ultrasonic HVAC Treatment (30208). All other cleaning methods are no longer permitted. This document discusses the "Fault Codes" necessary to diagnosis, and potential remedy of the issue. The fault codes for checking warranty coverage for servicing the vehicle are also available. |
| V941402 2011521 | 2017-12-05. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS. Technical Bulletin (Exterior Lights, Moisture Accumulation): Exterior light assemblies (headlights, taillights, fog lights, turn signals) are vented and may collect moisture on their inner surfaces, depending on humidity and other climatic changes. This document discusses necessary to diagnosis, and potential remedy of the issue. |
| V011705 2018652 | 2017-11-12. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. Update parts table. |
| TT 90-11-10 | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. Tech Tips (Instrument Cluster Production Mode): This document informs the procedure to remove the production mode setting when it is displayed in the instrument cluster. |
| V871506 2019947 | 2017-11-08. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER; ENGINE AND ENGINE COOLING. Technical Bulletin (Air Conditioning, Cleaning of the Refrigerant Circuit (U.S.Only)): In cases where an air conditioning system component (such as a compressor or other system component) has failed and debris from the compressor or component is circulated throughout the refrigerant circuit, the refrigerant circuit must be cleaned of any and all debris or damage to the replacement components will result. This document contains information on how to diagnose, and service this issue. |
| V871508 2005566 | 2017-11-08. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. Technical Bulletin (HVAC, Unpleasant Odor): Unpleasant odor is coming from Heating and Ventilation system. Odor mainly occurs after vehicle has been sitting (unused) at least 5 hours and within 20 to 60 seconds after vehicle is first started. This document contains information on how to diagnose, and service this issue. |
| V921502 2026253 | 2017-11-08. Service bulletin. VISIBILITY. Technical Bulletin (Windshield Wipers Streak or Smear): Windshield or rear window is streaked, has a snakeskin appearance, or the surface feels rough. To avoid unnecessary replacement of wiper blades, the condition and cleanliness of the windshield, rear window and wiper blades, should be checked first. This document contains information on how to diagnose, and service this issue. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.