WenmarOpen by Wenmar Pro

Service bulletins for the 2017 Subaru Outback

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

397 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Lighting are shown. Show all

Bulletins, newest first
07-59-07R2025-01-03. Service bulletin. EXTERIOR LIGHTING; ELECTRICAL SYSTEM. This bulletin is for information purposes only.The bulletin adresses design changes of the headlamps and rear combination lamps, where moisture and or condensation may develop on the inside of the lamp lenses.
06-70-192019-05-28. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EXTERIOR LIGHTING; ELECTRICAL SYSTEM. This bulletin announces a change to the operating software included in the Vehicle Dynamic Control (VDC) Control Module and Hydraulic Unit (VDCCM&H/U) on the models listed above. This change is in response to a very small number of customer inquiries regarding the Hill Holder system?s indicator lamp blinking once along with a single tone (chirp)being heard when starting the engine using the key, push-button or with use of a remote engine start.
07-121-172018-05-29. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS; ELECTRICAL SYSTEM. MODELS WITH EYESIGHT ONLY. This bulletin provides a repair procedure to address DTC B2902 which may be stored erroneously due to a specification mismatch. This bulletin applies to a very limited number of early-production 2017 model year vehicles without the auto headlamp leveling (AHL) feature only. Having the incorrect control module installed has absolutely NO effect on normal headlamp system operation and does not cause any warning lamp(s) to illuminate. The repair involves replacing the headlamp control module.
07-131-182018-03-13. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING:BRAKE LIGHTS. This bulletin provides a measurement and adjustment procedure for the stop lamp switch. An improperly adjusted (or faulty) stop lamp switch can cause any of the DTCs listed above to set and result in the related system?s (e. g. VDC and/or EyeSight) warning lamp to illuminate.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.