Service bulletins for the 2016 Nissan Titan
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
304 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| PC466OL | 2021-05-10. Service bulletin. LATCHES/LOCKS/LINKAGES:TAILGATE:LOCK; ELECTRICAL SYSTEM. vehicles to install an electronic tailgate lock that should have been installed on the vehicle from the factory, but was not. |
|---|---|
| PC434OL | 2021-05-10. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. Nissan is conducting a voluntary service campaign on certain MY2016 Titan XD vehicles to install splash guards on vehicles that should be equipped with this accessory, but were shipped without the splash guards installed. |
| PC428OL | 2021-05-10. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. Nissan is conducting a voluntary service campaign on certain MY2016 Titan XD vehicles to install step rails on vehicles that should be equipped with this accessory, but were shipped without the step rails installed. |
| PC423OL | 2021-05-10. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. Nissan is conducting this voluntary service campaign on certain specific 2016 Titan XD vehicles to install a dual wall bedliner and a cargo tie down kit that should have been installed on the vehicle from the factory, but were not. |
| NTB11027B | 2021-05-10. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; TIRES. SERVICE INFORMATION Temporary tire Flat Spotting is common on New Dealer In-Stock vehicles that have not been occasionally moved. Flat Spotting can occur after the vehicle has been parked (not moved) for a few days, or longer. In most cases it is temporary. In extreme cases it can be permanent. Vehicles should be moved every 30 days, in one direction only, enough to rotate the tires 90° (see Figure 1). Moving vehicles as shown will prevent tire Flat Spotting. See this bulletin for further detail. |
| NTB16036A | 2021-05-10. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; ENGINE; ELECTRICAL SYSTEM. SERVICE INFORMATION This bulletin provides recommendations for proper engine operation in conditions where the ambient temperature is around or below 0°C (32°F). NOTE - These recommendations are also found in the vehicle Owner?s Manual. - Always use the correct engine oil for the prevailing conditions. - Use an engine block heater (if so equipped) when the ambient temperature is at or below -18°C (0°F). - Engine block heaters are used to assist with cold temperature starting. - Some engine block heaters will operate continuously while plugged into the correct voltage electrical outlet. IMPORTANT: DO NOT use the engine block heater in temperature conditions at or above 0°C (32°F). Doing so may cause damage to the engine block heater. See this bulletin for further detail. |
| NTB16037C | 2021-05-10. Service bulletin. ELECTRICAL SYSTEM; ENGINE. IF YOU CONFIRM The MIL is ON with one or more of the following DTCs stored: * P020A - F: Cylinder 1 - 6 Injection Timing * P021A - B: Cylinder 7 - 8 Injection Timing * P060C: Internal Control Module Main Processor Performance * P061B: Internal Control Module Torque Calculation Performance * P0605: ECM * P2048: Reductant Injector Circuit Low * P0299: Boost Pressure * P2263: Turbocharger Boost System Performance * P0401: Flow in the Exhaust Gas Recirculation (Insufficient) * P0402: Flow in the Exhaust Gas Recirculation (Excessive) * P2483: Exhaust Gas Temperature Sensor Circuit Intermittent 1/5 * P244D: Exhaust Temperature Too High For PF Regeneration * U0415: VDC CAN CIR2 * P2BAD: NOx Concentration Exceeded * P1C55: NOx Sensor 1/1 Intermittent * P1C56: NOx Sensor 1/2 Intermittent * P2201: NOx Sensor 1 and/or At times, when coming to a stop, the idle fluctuates with RPM dropping below 500 RPM. ACTION 1. Save Computer Data with CONSULT-III plus (C-III plus). 2. At step 6 of the reprogramming procedure, confirm this bulletin applies to the vehicle you are working on. 3. If this bulletin applies, continue with reprogramming procedure. 4. Write Saved Data with CONSULT-III plus. See this bulletin for further detail. |
| NTB15049H | 2021-05-10. Service bulletin. EQUIPMENT:ELECTRICAL; EQUIPMENT ADAPTIVE/MOBILITY. SERVICE INFORMATION The Applied Vehicles are equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active NissanConnectSM Services subscription, the TCU communicates with the NissanConnectSM Services Data Center to provide various security and convenience services. This bulletin contains important service procedures that must be performed properly in order to set-up and maintain the telematics system for the Applied Vehicles. See this bulletin for further detail. |
| NTB16051 | 2021-05-10. Service bulletin. ENGINE; EQUIPMENT. IF YOU CONFIRM The vehicle is operated as follows: * After being parked indoors overnight and started for the first time (cold start), * and then before reaching operating temperature is driven outside in an ambient temperature below 0°F (-18°C). Then * A hesitation is present while accelerating that improves as engine temperature increases, and subsides when the engine reaches normal operating temperature. And/or * The vehicle is operated in ambient temperatures at orbelow32°F (0°C) and one of these codes are stored. * P202E - Reductant Injection Valve Circuit 1/1 * P218F - Reductant No Flow Detected * P22CE - TC Outlet Switching Valve Stuck Closed Please see this bulletin for further details. |
| NTB16048 | 2021-05-10. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE. IF YOU CONFIRM The MIL is ON with one or more of the following DTCs stored as current: P22A7, P229E, P221A. ACTION 1. Replace the Outlet NOx Sensor. 2. Confirm that ECM requires reprogramming. Refer to step 6 on page 7. If the ECM requires reprograming: a. Perform Save Computer Data with CONSULT-III plus (C-III plus). b. Reprogram ECM. c. Perform Write Saved Data. See this bulletin for further detail. |
| NTB13106E | 2021-05-10. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); STEERING; ELECTRICAL SYSTEM; BACK OVER PREVENTION. SERVICE INFORMATION If the configuration of the Audio/Navigation unit has not been completed correctly, some of the symptoms that may occur are: * Intermittent or no back up camera operation * No steering wheel switch response to audio inputs * No volume response from volume knob * Volume very loud or very quiet and adjustment is overly sensitive * Equalizer is adjusted so that Bass control is at maximum all the time * DTC U1000 for AVM C/U could be present If the above symptoms occur: * Confirm the configuration of the Audio/Navigation unit is correct. NOTE: Correct configuration of the appropriate control unit will restore correct operation. Audio/Navigation unit configuration is outlined starting on page 2. See this bulletin for further detail. |
| NTB16045 | 2021-05-10. Service bulletin. EQUIPMENT; POWER TRAIN. SERVICE INFORMATION IMPORTANT: If you confirm one or more of the following transmission DTCs are stored: P0729: 6GR Incorrect Ratio P0730: Incorrect Gear Ratio P0731: 1GR Incorrect Ratio P0732: 2GR Incorrect Ratio P0733: 3GR Incorrect Ratio P0734: 4GR Incorrect Ratio P0735: 5GR Incorrect Ratio P1734: 7GR Incorrect Ratio Before performing any transmission repairs: 1. Check all of the engine intake air ducting and make sure: - It is connected securely and correctly at the throttle body and all other connections. See Figures 1 and 2 on the page 2. - All clamps and connectors are secure and tight. - There are no leaks. 2. Perform DTC confirmation procedure to confirm the incident. - Refer to the Electronic Service Manual (ESM) for DTC confirmation procedures. See this bulletin for further detail. |
| NTB13099E | 2021-05-10. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM. SERVICE INFORMATION If the Audio Unit needs to be replaced in an Applied Vehicle for any reason: - Write down replacement Audio Unit's registration "code" . - Replace the Audio Unit as instructed in the Electronic Service Manual (ESM) and any applicable bulletins. - Register the replacement Audio Unit with Nissan Owner Services. NOTE: The Apps mode will not function if the Audio Unit serial number (registration code) is not registered. See this bulletin for further detail. |
| NTB09099A | 2021-05-10. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER; EQUIPMENT ADAPTIVE/MOBILITY. IF YOU CONFIRM A refrigerant leak at a refrigerant pipe/hose joint location. ACTIONS 1. Inspect the metal surfaces of the pipe/hose joint for damage or contamination. NOTE: Do not replace a refrigerant pipe, hose, or other A/C component if an o-ring seal will solve the leak incident, if it should occur. 2. If no damage is found to the joint metal surfaces, replace the O-ring seal. See this bulletin for further detail. |
| PC455 | 2021-05-10. Service bulletin. EQUIPMENT; ENGINE. Nissan is conducting a dealer inventory service action to torque the Engine Harness Ground to specification on 1,268 specific 2016 Titan XD vehicles. |
| PC438 | 2021-05-10. Service bulletin. EXTERIOR LIGHTING:TAIL LIGHTS. Nissan is conducting a dealer inventory service action to inspect and, if necessary, replace the rear combination lamp assembly on 2,602 specific 2016 Titan XD vehicles. |
| NTB09131B | 2021-05-10. Service bulletin. FORWARD COLLISION AVOIDANCE; EQUIPMENT:OTHER:LABELS. SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement "Certification Label" or "VIN Plate / Label" may be needed. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. See this bulletin for further detail. |
| NTB16038AQAQAZQ | 2021-05-10. Service bulletin. POWER TRAIN; EQUIPMENT. SERVICE INFORMATION Anytime the 6AT (RE6R01A) transmission or its Transmission Control Module (TCM) is replaced an adjustment procedure must be performed using C-III plus. IMPORTANT: If the transmission adjustment is not performed, the transmission may have the following conditions: Poor shift quality, Improper shift timing, Engine RPM flares between shifts See this bulletin for further detail. |
| NTB15044B | 2021-05-10. Service bulletin. EQUIPMENT; FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP. SERVICE INFORMATION If the clip for the fuel filler cap tether becomes lost or is detached for any reason, it is no longer necessary to replace the fuel filler cap. The clip or "pin" is now available as a separate service part. NOTE - Do not replace the fuel filler cap if only the pin is needed. See this bulletin for further detail. |
| PC441 | 2021-05-10. Service bulletin. ELECTRICAL SYSTEM. Nissan is conducting a dealer inventory service action to update the Engine Control Module (ECM) software on 3,334 specific 2016 Titan XD vehicles. The software is being updated to refine the MIL illumination logic. |
| PC434A | 2021-05-10. Service bulletin. EQUIPMENT. Nissan has previously communicated instructions to dealers regarding specific vehicles in their inventory that may have been delivered without certain accessories. Nissan is delivering parts to those affected dealers to install the missing accessories on the vehicle. |
| PC428A | 2021-05-10. Service bulletin. EQUIPMENT. Nissan has previously communicated instructions to dealers regarding specific vehicles in their inventory that may have been delivered without certain accessories. Nissan is delivering parts to those affected dealers to install the missing accessories on the vehicle. |
| PC423B | 2021-05-10. Service bulletin. EQUIPMENT. Nissan has previously communicated instructions to dealers regarding specific vehicles in their inventory that may have been delivered without certain accessories. Nissan is delivering parts to those affected dealers to install the missing accessories on the vehicle. |
| NTB03074J | 2021-05-10. Service bulletin. EXTERIOR LIGHTING. SERVICE INFORMATION Occasionally customers may notice water vapor or fog in the headlamps. The information, illustrations, and flow chart in this bulletin are provided to help you in determining if an incident for water/condensation in the headlamps is normal or not. Nissan?s new vehicle limited warranty does not cover physically damaged (cracked or broken) headlamps. All current headlamp assemblies are vented to the atmosphere (not sealed). - This is necessary to allow for expansion and contraction of air from temperature "variations" (warmer or colder) without damage to the headlamp. - Moisture in the air sometimes "travels" into and out of the headlamp assembly through these vents. - Certain environmental conditions may cause moisture to condense. - The fogging/cloudiness should disappear over time when the headlamp is in a dry environment. See this bulletin for further detail. |
| NTB16014 | 2021-05-10. Service bulletin. EQUIPMENT; FORWARD COLLISION AVOIDANCE: SENSING SYSTEM: SONAR/ULTRASONIC. SERVICE INFORMATION When diagnosing the front sonar parking sensor for unwanted activation (e.g. sonar activates with no obstacle ahead), inspect the front license plate, front license plate frame and if equipped, the front license plate bracket. See page 2 for example photos. The front sonar parking sensor may activate if the front license plate is bent outward from its bracket (there is a gap between the license plate and the bracket) OR the front license plate frame is bent or loose and is hanging outward, away from the license plate and/or bracket (there is a gap between the license plate frame and the license plate and/or bracket) OR the bracket is loose and is hanging outward, away from the bumper (there is a gap between the bracket and the bumper). If any of these conditions are found, correct it by removing the gap (straighten the license plate, straighten and/or secure the license plate frame, or secure the bracket, as it applies). - Retest the operation of the front sonar parking sensor. If the issue is not resolved, go to ASIST and the related Electronic Service Manual (ESM) for further diagnosis. See this bulletin for further detail. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.