Recalls that may apply to the 2017 Mazda Mazda3
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 23V487000 | 2023-07-14. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. Mazda North American Operations (Mazda) is recalling certain 2014-2018 Mazda3 and 2016-2021 CX-3 vehicles. The rearview camera image may not display properly by showing a flickering or distorted image. |
|---|---|
| 19V272000 | 2019-04-04. VISIBILITY:WINDSHIELD WIPER/WASHER. Mazda North American Operations (Mazda) is recalling certain 2016-2018 Mazda3 vehicles. A defective windshield wiper relay may cause the windshield wipers to become inoperative, reducing the driver's visibility. Built 2015-07-20 to 2017-07-18. |
| 2023391 | 2023-07-14. Visual System. Issue: On certain vehicles, a problem with the rearview camera connector could cause distortion or flickering of the rearview camera image. Note: This recall only affects hatchback (5-door) models. Safety Risk: A rearview camera image that doesn't display correctly could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: Mazda will notify owners by mail and advise you to take your vehicle to a dealership to inspect the rearview camera and install a seal for the wiring harness. The dealer will replace the rearview camera, if necessary. |
|---|---|
| 2019169 | 2019-04-04. Visual System. Issue: An electrical problem may cause the windshield wipers to stop working. Safety Risk: Windshield wipers that do not work could affect a driver’s visibility under certain conditions. This could increase the risk of a crash. Corrective Actions: Mazda will notify owners by mail and instruct you to take your vehicle to a dealer to replace the front body control module with an improved one. |
| 2017312 | 2017-06-22. Brakes. On certain vehicles equipped with hand-operated parking brakes, the rear brake caliper protective boot on the parking brake system may not perform as intended, causing the parking brake actuator shaft to corrode. Over time, the actuator shaft may become stuck in the brake caliper body which could lead to decreased parking brake holding force or cause the parking brake to drag while driving. Decreased parking brake holding force could cause the vehicle to roll away if parked on a slope which would increase the risk of injury and/or damage to property. Correction: Dealers will inspect and repair or replace the rear caliper assemblies as necessary. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.