WenmarOpen by Wenmar Pro

Service bulletins for the 2026 Mazda CX-5

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

75 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Body and frame are shown. Show all

Bulletins, newest first
09-025-262026-09-02. Service bulletin. STRUCTURE:BODY. DESCRIPTION Some vehicles may exhibit a rattling or knocking noise from the upper B-pillar trim area. The noise is due to insufficient anti-rattle treatment between the B-pillar, adjuster cover and adjuster knob. REPAIR PROCEDURE 1. Verify customer concern. NOTE: Replacing the B-pillar trim is a like-for-like part and will likely need the felt tape added.
SA-031-262026-05-05. Service bulletin. STRUCTURE:BODY; UNKNOWN OR OTHER. DESCRIPTION Some vehicles may require the replacement of a damaged VIN plate or vehicle certification label. To obtain a replacement VIN plate (bulkhead-mounted and visible through the lower-left area of the windshield), contact DAG (Dealer Assistance Group) using VIN Plate Request Form available on One Mazda. To obtain a replacement vehicle certification label (located on the B􀀀pillar or front door), contact your assigned DSM (District Service Manager) to place the order. If DSM contact information is not available, refer to the Dealer & Field Contact Directory.
SA-019-262026-04-03. Service bulletin. STRUCTURE:BODY; UNKNOWN OR OTHER. This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-045/22 12/06/22 and 07/12/22 NOTE: All vehicles with protective films applied to the piano black door garnishes of the following models are applicable to this Service Alert. DESCRIPTION The purpose of this Service Alert is to remind dealers to keep the protective films on the piano black door garnishes attached until just before delivering the vehicle to the customer. The protective films are attached on new vehicles when shipped from the factory in order to avoid being scratched during transportation and while in dealer stock. NOTE: Remove the protective films after cleaning the vehicle. • If any adhesive residue remains on the surface of the door garnish, attach the adhesive side of the protective film on the area again, and then peel it off to remove the residue. • Refer to the image below for the location of the protective films (4 sheets of films in each side).
SA-003-262026-02-03. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY. Customers may report that the liftgate does not open or unlatch (from closed or an ajar position). This may happen after a discharged battery or after charging a dead battery.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.