Service bulletins for the 2019 Mazda CX-5
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
561 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| 01-004-23 | 2023-03-03. Service bulletin. ENGINE AND ENGINE COOLING. Some vehicles may have the check engine light on with DTC P0524:00 or P055F:00 stored in memory. Contamination in the engine oil may cause the engine oil solenoid valve to become stuck, resulting in improper operation of the oil pump and improper oil pressure. DTC P0524:00 (Engine oil pressure too low), DTC P055F:00 (Engine oil pressure malfunction). The control software of the PCM has been modified to eliminate this concern. In addition, the production process has been modified to reduce contamination in the engine oil solenoid valve, oil pump, spacer and oil filter. |
|---|---|
| 01-002-23a | 2023-03-03. Service bulletin. ENGINE AND ENGINE COOLING; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. Some vehicles may have coolant leaks at the cylinder head around the exhaust manifold (as shown below). There may be cracks at the stud bolt hole (1) or at the outside of the exhaust manifold flange (2) on the cylinder head. |
| 01-001-23a | 2023-03-03. Service bulletin. ENGINE AND ENGINE COOLING. Some customers may complain about a poor acceleration and rough idling or the CHECK ENGINE light ON with DTC P0301:00, P0302:00, P0303:00, P0304:00.NOTE: Only turbo engines are applicable; non-turbo engines are NOT applicable. In most cases, DTCs P030X stores, but sometimes not. Sometimes the CHECK ENGINE light does not recognize this engine concern. This is caused by the variable valve in the exhaust manifold seizing and causing the exhaust port to become hot and the exhaust valve seat to wear unevenly, resulting in compression leakage. To eliminate this concern, the design of the exhaust manifold has been modified. |
| 09-006-23 | 2023-02-02. Service bulletin. STRUCTURE. When encountering a vehicle with paint damage, refer to the "Mazda Paint Warranty Guide" to determine cause, prevention, remedy, and warranty coverage (if applicable). |
| 01-002-23 | 2023-02-02. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM; ENGINE AND ENGINE COOLING. Some vehicles may have coolant leaks at the cylinder head around the exhaust manifold (as shown below). There may be cracks at the stud bolt hole or at the outside of the exhaust manifold. Cracks may be caused by: - Deformation of the exhaust manifold during usage causing unexpected force to certain areas of the cylinder head. - Residual stress generated during production in the cylinder head material may be greater than expected. The external force from the exhaust system when driving over bumps may cause unexpected force to certain areas of the cylinder head. To eliminate this concern, the design of the exhaust manifold gasket and the cylinder head has been modified to reduce the force on the cylinder head. |
| 01-001-23 | 2023-02-02. Service bulletin. ENGINE AND ENGINE COOLING. Some customers may complain about a poor acceleration and rough idling or the CHECK ENGINE light ON with DTC P030X:00 (only turbo engines are applicable; non-turbo engines are NOT applicable). - In most cases, P030X is stored, but sometimes not. - Sometimes the CHECK ENGINE light does not recognize this engine concern. This is caused by the variable valve in the exhaust manifold seizing and causing the exhaust port to become hot and the exhaust valve seat to wear unevenly, resulting in compression leakage. To eliminate this concern, the design of the exhaust manifold has been modified. |
| SA-007/23 | 2023-02-02. Service bulletin. POWER TRAIN. The rear differential case could develop a crack in the case NOTE: This could affect new vehicles just delivered to the dealer as well as customer vehicles. This concern is caused when the sliding bearing in the coupling is seized and causes the coupling component to fit loosely. The pinion shaft head then contacts the differential case and causes a crack. |
| SA-003/23 | 2023-02-02. Service bulletin. SERVICE BRAKES. Some vehicles exhibit brake related concerns such as brake noise, brake judder or brake dragging. If you encounter a customer complaint for any one of these symptoms, refer to the following information to understand why symptoms may occur, and to better assist the customer in resolving their specific brake concern. |
| SA-001-23a | 2023-02-02. Service bulletin. EQUIPMENT:ELECTRICAL:INFOTAINMENT; EQUIPMENT. Some customers may complain about infotainment center display: - Ghost Touch - DTC B108E:04 may be stored (Touch screen operates by itself) - Surface Peeling - DTC B108E:04 may be stored - Spider Cracks - White dots IMPORTANT NOTE: DO NOT replace the infotainment center display assembly. Low cost repair kits are available to repair the infotainment center display screen. |
| SA-001-23 | 2023-02-02. Service bulletin. EQUIPMENT; EQUIPMENT:ELECTRICAL:INFOTAINMENT. Some customers may complain about infotainment center display: - Ghost Touch - DTC B108E:04 may be stored (Touch screen operates by itself) - Surface Peeling - DTC B108E:04 may be stored - Spider Cracks - White dots IMPORTANT NOTE: DO NOT replace the infotainment center display assembly. Low cost repair kits are available to repair the infotainment center display screen. |
| RF-23-01 | 2023-02-02. Service bulletin. ENGINE AND ENGINE COOLING. When servicing SKYACTIV engine vehicles requiring to replace the Oil Galley Plug and Crush Washer, order the required part numbers below. These parts are not listed in GEPC and were previously listed as "non-serviceable" in the cylinder block diagram. |
| RF-22-01R3 | 2023-02-02. Service bulletin. EQUIPMENT. This Parts Flash replaces RF-22-01R2 released January 04, 2022. It includes new display repair kit part numbers for the 2018-2019 Mazda2, 2018-2020 CX-3 and 2018-2020 MX-5. Repair kits are available to replace just the screen. There is no need to replace the entire infotainment display unit as the supply chain has been heavily impacted due to the global shortage of semiconductors. |
| RF-22-01R2 | 2023-02-02. Service bulletin. EQUIPMENT; EQUIPMENT:ELECTRICAL:INFOTAINMENT. This Parts Flash replaces RF-22-01R released November 21, 2022. It includes a new display repair kit part number for the 2020-2022 MX-5. Repair kits are available to replace just the screen. There is no need to replace the entire infotainment display unit as the supply chain has been heavily impacted due to the global shortage of semiconductors. |
| SA-078-22 | 2023-01-05. Service bulletin. SERVICE BRAKES, HYDRAULIC. Some vehicles exhibit brake related concerns such as brake noise, brake judder or brake dragging. If you encounter a customer complaint for any one of these symptoms, refer to the following information to understand why symptoms may occur, and to better assist the customer in resolving their specific brake concern. |
| SA-016-22a | 2023-01-05. Service bulletin. EQUIPMENT. There are currently 2 methods for cutting a new auxiliary key blank. A. Auxiliary Key Trace Cut Method B. Auxiliary Key Code Cut Method |
| RF-22-02 | 2023-01-05. Service bulletin. WHEELS. Following the release of the 2019 CX-5 (KF) a series of wheels are applicable from the 2019-2021 model year. Each wheel is specified by VIN and supplier code, see table below for a visual representation along with the part number. |
| MT-004-22 | 2023-01-05. Service bulletin. ENGINE AND ENGINE COOLING. Some vehicles may experience the Check Engine Light ON with DTC P0171 (Fuel Trim too Lean) and possibly DTCs P030X (Misfire). Vehicles having this concern should use the following Inspection/Repair procedure. |
| SA-076-22 | 2022-12-02. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:DIESEL; ENGINE AND ENGINE COOLING. When replacing the engine oil on the diesel engine, be sure to drain the old oil properly and refill with the accurate amount. The latest engines are equipped with an oil level sensor that measures the amount of oil and stores a DTC according to the oil status. For proper detection of the DTC, proper oil drainage and an accurate replacement amount of oil are required when replacing the engine oil. |
| SA-041-22c | 2022-12-02. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL:INFOTAINMENT. Some customers may complain about infotainment center display: * Ghost Touch * DTC B108E:04 may be stored (Touch screen operates by itself) * Surface Peeling * DTC B108E:04 may be stored * Spider Cracks * White dots |
| SA-075-22 | 2022-12-02. Service bulletin. ELECTRICAL SYSTEM. If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices. Examples: 1. Devices connected to the DLC-2 (battery discharge/DTC stored) 2. Cell phone charger/accessory in 12V socket (engine no start or unable to turn off) 3. GPS tracking device (engine no start/battery discharge) 4. Dash cam (DTC stored) 5. Non-certified USB cable (Apple Carplay™/ Android Auto™ will not connect) 6. Over-sized wheels/tires (incorrect GPS location) |
| SA-074-22 | 2022-12-02. Service bulletin. VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM; ELECTRICAL SYSTEM. Some customers may complain the HVAC system not maintaining the correct temperature or the ambient (outside) temperature reading incorrectly. This is caused by a failure in the ambient temperature sensor. To correct this issue, the ambient temperature sensor has been modified. |
| 22-01R | 2022-12-02. Service bulletin. EQUIPMENT:ELECTRICAL:INFOTAINMENT:VIDEO (TOUCH)SCREEN/MONITOR/UNIT; ELECTRICAL SYSTEM. Repair kits are available to replace just the screen. There is no need to replace the entire infotainment display unit as the supply chain has been heavily impacted due to the global shortage of semiconductors. Please use the table below when ordering the screen repair kits. This can also be found in Service Alert SA-041/22. |
| 15-002-22a | 2022-12-02. Service bulletin. ELECTRICAL SYSTEM. Some vehicles may exhibit either or both of the following symptoms. 1. The SCBS warning light is illuminated with DTC U045A:68 [FORWARD SENSING CAMERA (FSC)]. U045A:68 Error signal received from parking assist unit 2. The parking sensor indicator is flashing with one or more of the following DTCs of PARKING ASSIST SYSTEM. B1B36:14 Front corner ultrasonic sensor (RH) circuit malfunction B1B36:2A Front corner ultrasonic sensor (RH) characteristic malfunction B1B38:14 Front ultrasonic sensor (RH) circuit malfunction B1B38:2A Front ultrasonic sensor (RH) characteristic malfunction B1B40:14 Front corner ultrasonic sensor (LH) circuit malfunction B1B40:2A Front corner ultrasonic sensor (LH) characteristic malfunction B1B42:14 Front ultrasonic sensor (LH) circuit malfunction B1B42:2A Front ultrasonic sensor (LH) characteristic malfunction Due to insufficient waterproof performance of the front harness short cords (1), water may enter in and accumulate in the C-11 (LH) or C-12 (RH) connectors (2) causing a short circuit between wires and an improper signal being sent from the parking (ultrasonic) sensor to the parking sensor unit. To eliminate this concern, the production process of the front harness short cord has been improved to increase waterproof performance. |
| 09-047-22 | 2022-12-02. Service bulletin. STRUCTURE. Some vehicles may exhibit power outer mirror(s) that do not completely fold in and/or out. NOTE: This concern is unrelated to frozen mirrors in icy weather where snow or ice need to be removed for the mirrors to fold in and/or out. This concern may be caused by the following: - The space between the mirror frame and the inner base may be too tight to allow for proper movement. - Due to insufficient water tightness, water enters the electric fold-in unit and results in corrosion damage. - The friction around the folding mechanism shaft may become increased. To eliminate this concern, the following mass-production changes have been implemented: - The hole (1) in the mirror frame connected to the inner base has been enlarged. - The overlapping area (2) of the water-proof seal (inside electric fold-in unit) has been extended. - The washer material has been improved and an additional washer has been added to the shaft. |
| 09-018-22b | 2022-12-02. Service bulletin. ELECTRICAL SYSTEM. Some vehicles may experience the symptoms mentioned below, which can be fixed with the latest software update (Version 74.00.324 or later). The system performance has been improved as follows: Ver. 74.00.324 fixes these software errors (bugs): * If the shift lever is operated quickly while displaying the CarPlayTM screen, the rear view screen may not return to the CarPlayTM screen. * When the gear position is shifted into P from R, the screen may not return to the previous condition before shifting into the R position. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.