WenmarOpen by Wenmar Pro

Service bulletins for the 2015 GMC Yukon

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

2691 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Suspension are shown. Show all

Bulletins, newest first
PIP5211C2017-08-15. Service bulletin. ENGINE; SUSPENSION. This Preliminary Information communication provides information to the technician the steps needed to diagnose and repair vehicles with a rough idle and/or vibration at idle in Drive. This condition will not be present in Park, or Neutral. This concern may be caused by ground out within the one or both engine mounts. Technician will use CH-51450-A (Pico Oscilloscope) to measure the vibration disturbance. If the vibration concern is E1.5 in the horizontal / lateral direction with Pico sensor mounted in seat track as indicated ? continue with steps to reduce the amplitude of the vibration by adding spacers in key locations to reduce ground out within the engine mounts. The 6.2L engine has a characteristic E1 which can be felt, and may be described as a lopey idle. Do not confuse 6.2L E1 characteristic (not caused by mount ground-out), with E1.5 normal idle characteristics being transmitted into the truck via ground-out thru the engine mounts. If measuring high at the seat track 12 mg or greater; replacement of the engine mounts should help reduce the amplitude of the vibration. If the disturbance measures at the seat track as E 1.5 lateral in the range of approximately 2.5 - 8 mg using a tri-axis sensor. Then place tri-axis Pico sensor on the inboard seat track forward-most location to record measurement of the rough idle vibration concern. With the Heater-Vent-Air Conditioning on perform several short heavy launch events from stop to stop to bring the temperatures back up while attempting to re-create the rough idle vibration in Drive with Pico sensor placed on inboard seat track; while the vibration is active ? Record Pico reading. This method seems to provide better results than extended test drives. If the Pico reading for E1.5, with vibration active, at specified seat track location measures close to 2mg or less use Service Information to diagnose rough idle / vibration. If the Pico reading for E1.5, with vibration active, at the inboard forward seat track
PIT54042017-08-15. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; SUSPENSION. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a buffeting vibration and/or drone type noise, exhaust tone change, and/or body pressure booming. The concern may be most noticeable while the engine is operating in 4-cylinder Active Fuel Management mode in the 1,100-1,400 RPM range. If the noise is excessive it may excite the roof sheet metal and compound the issue, if this concern is found refer to the latest version of PIT5318. If the concern is qualified to be present during V4 mode operation, but is deemed to be normal by comparing to a like vehicle, then no further repairs should be made, as this is a normal characteristic. If the concern is qualified to be present during V4 mode operation, but is deemed excessive by comparing to a like vehicle then continue with the direction in the Preliminary Information. Vehicles equipped with the 6.2 liter engine and noise cancellation, the noise cancellation may not be working or working incorrectly this can be the cause of the issue. Technician should inspect for aftermarket audio components, objects blocking the microphones or speakers, Diagnostic Trouble Codes B0560, B1277, B127C, or B127D. By the technician pulling the fuse for the amplifier the noise cancellation will be disabled if the noise improves there may be an issue with the noise cancellation system. Technician should inspect the exhaust system also. Exhaust should be checked when it is hot and cold while the vehicle is in neutral, forward and reverse gear. Inspect the exhaust system for loose and/or missing fasteners, heat shields damaged, joints and/or couplings not properly seated, bracket and/or insulator mounting concerns, inadequate clearance to body and/or chassis components, improper alignment, disconnected and/or missing insulators, cracked, dry-rotted, and/or oil-soaked insulators, stretched, twisted, broken, torn, and/or collapsed insulators, and bent, twist
PIT54032017-08-15. Service bulletin. SUSPENSION. This Preliminary Information communication provides information to the technician with the steps to diagnosis and repair vehicles with various handling, vehicle dynamics concerns, noises from the suspension or underbody, or issues related to damaged suspension components. Before any in-depth diagnostics are performed, be aware that various issues could occur if the vehicle has been modified and inform the customer the conditions noted may not be covered under warranty. Technician will inspect for installed aftermarket suspension components. Also inspect for improperly adjusted torsion bars.
PIT5403A2017-08-15. Service bulletin. SUSPENSION. This Preliminary Information communication provides information to the technician with the steps to diagnosis and repair vehicles with various handling, vehicle dynamics concerns, noises from the suspension or underbody, or issues related to damaged suspension components. Before any in-depth diagnostics are performed, be aware that various issues could occur if the vehicle has been modified and inform the customer the conditions noted may not be covered under warranty. Technician will inspect for installed aftermarket suspension components. Also inspect for improperly adjusted torsion bars.
PI02003D2017-08-15. Service bulletin. SUSPENSION:FRONT. This preliminary informational bulletin provides technicians a recommendation for when they are performing a front end alignment and find an alignment dowel pin missing .
PIT5049C2017-08-15. Service bulletin. SUSPENSION:FRONT. This Preliminary Information communication provides information to the technician on the steps to help diagnose and repair vehicles with a rattle, squeak, clunk, thump, or bump. If published Service Information diagnostics do not lead to a repair for the concern. Technician should inspect the opposite side shock/strut for the cause of the concern.
PIT5477A2017-08-15. Service bulletin. SUSPENSION. This Preliminary Information communication provides information to the technician about vehicles that may have a squeak, clunk, or knock type noise from the front suspension when hitting bumps. Technician will need to test drive the vehicle to duplicate the concern. Check the upper strut mount area with chassis ears verifies that the noise is noticeable in that area. Technician will replace the jounce bumpers with part number 8457475.
PIT52872017-08-15. Service bulletin. SUSPENSION:FRONT:SHOCK ABSORBER; ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL. This Preliminary Information communication provides information to the technician with the correct way to remove the front shock electrical connector terminals. Technician will need to slightly bend the end of the J-38125-12A release tool. There is a purple Terminal Position Assurance that will align itself in the release position when the release tool is inserted into the release hole. There is a metal locking tab on the terminal that will need to be pushed in before the terminal will pull out of the connector.
PIP51962017-08-15. Service bulletin. POWER TRAIN:AXLE ASSEMBLY; SUSPENSION:MULTIPLE AXLE. This Preliminary Information communication provides information to the technician with the steps to diagnose and repair vehicles that may have a whine noise at highway speeds from the rear of the vehicle. If the technician has diagnosed the noise to be a rear axle related whine noise at highway speed, then use published Service Information "Symptoms - Rear Drive Axle". Technician should also compare the concern with a vehicle of the same build. If the noise level is deemed excessive check the vehicle build. Technician will replace the propeller shafts if needed.
05-03-08-002H2017-08-15. Service bulletin. SUSPENSION:FRONT:SHOCK ABSORBER. This informational bulletin provides information to dealership personnel on diagnosis and replacement of shock absorber and strut due to fluid leak.
PIT55332017-08-15. Service bulletin. WHEELS; STRUCTURE; SUSPENSION. This Preliminary Information communication provides information to the technician about vehicles that have a creak, click, pop, and or crack type noise from the front suspension or front frame area while making tight turns. Technician will need to loosen and then re-torque the four front frame cross member nuts and bolts.
153032017-01-31. Service bulletin. SUSPENSION:REAR. 15303 - SERVICE UPDATE. THIS BULLETIN PROVIDES A SERVICE PROCEDURE FOR CERTAIN 2015 MODEL YEAR CHEVROLET TAHOE AND CHEVROLET SUBURBAN, GMC YUKON AND GMC YUKON XL 2WD VEHICLES EQUIPPED WITH AUTO LEVELLING REAR SUSPENSION (RPO Z85 AND AVF). THESE VEHICLES MAY HAVE AN AUTO-LEVELING FEATURE THAT IS INOPERATIVE. THE AUTO-LEVELING FEATURE WORKS BY SENSING WHEN THE REAR OF THE VEHICLE IS LOADED. REAR SHOCK ABSORBERS’ INTEGRAL AIR SACKS (BOOTS) ARE INFLATED TO COMPENSATE AND LEVEL THE VEHICLE. CUSTOMERS MAY NOTICE THE REAR TRIM HEIGHT LOWER IN THE REAR OF THE VEHICLE WHEN LOADED COMPARABLE TO VEHICLES WITHOUT AUTO-LEVELING REAR SUSPENSION.
PIT5287B2016-11-03. Service bulletin. SUSPENSION. THIS PRELIMINARY INFORMATION COMMUNICATION ADVISES THE TECHNICIAN ON THE STEPS REQUIRED FOR THE FRONT SHOCK ABSORBER TERMINAL REMOVAL.
PIT5403B2016-10-21. Service bulletin. SUSPENSION. THIS PRELIMINARY INFORMATION COMMUNICATION PROVIDES INFORMATION TO THE TECHNICIAN WITH THE STEPS TO DIAGNOSIS AND REPAIR VEHICLES WITH VARIOUS HANDLING, VEHICLE DYNAMICS CONCERNS, NOISES FROM THE SUSPENSION OR UNDERBODY, OR ISSUES RELATED TO DAMAGED SUSPENSION COMPONENTS. BEFORE ANY IN-DEPTH DIAGNOSTICS ARE PERFORMED, BE AWARE THAT VARIOUS ISSUES COULD OCCUR IF THE VEHICLE HAS BEEN MODIFIED AND INFORM THE CUSTOMER THE CONDITIONS NOTED MAY NOT BE COVERED UNDER WARRANTY. TECHNICIAN WILL INSPECT FOR INSTALLED AFTERMARKET SUSPENSION COMPONENTS. ALSO INSPECT FOR IMPROPERLY ADJUSTED TORSION BARS.
PIT5307D2016-10-21. Service bulletin. ENGINE; ELECTRICAL SYSTEM; SUSPENSION. THIS PRELIMINARY INFORMATION COMMUNICATION PROVIDES INFORMATION TO THE TECHNICIAN ABOUT VEHICLES THAT MAY HAVE A SERVICE ENGINE SOON MALFUNCTION INDICATOR LAMP, ANTILOCK BRAKING SYSTEM MALFUNCTION INDICATOR LAMP, SERVICE SUSPENSION SYSTEM MESSAGE, MISFIRE, HESITATION, NO CRANK, HEATER-VENT-AIR CONDITIONING INOPERATIVE. TECHNICIAN MAY FIND F11UA, F104UA, F35UA, AND OR F60UA BLOWN. TECHNICIAN SHOULD INSPECT THE ENGINE HARNESS NEAR THE VACUUM PUMP PULLEY TO BE CHAFING. TECHNICIAN WILL NEED TO REROUTE THE WIRE HARNESS AND REPAIR AND DAMAGED WIRES.
PIT-5457-A2016-08-13. Service bulletin. SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:ABS WARNING LIGHT; SUSPENSION; STEERING:HYDRAULIC POWER ASSIST SYSTEM; SERVICE BRAKES, AIR:ANTILOCK:ABS WARNING LIGHT. THIS PRELIMINARY INFORMATION COMMUNICATION ADVISES THE TECHNICIAN ON THE STEPS FOR DIAGNOSING THE CONCERN, AND COMPLETING A WIRING REPAIR. THE VEHICLE MAY HAVE A SERVICE ANTILOCK BRAKING SYSTEM, TRACTION CONTROL, POWER STEERING OR SUSPENSION SYSTEM MESSAGE ON THE DRIVERS INFORMATION CENTER.
PIT-5287-B2016-08-13. Service bulletin. SUSPENSION:FRONT; SUSPENSION:FRONT:SHOCK ABSORBER. THIS PRELIMINARY INFORMATION COMMUNICATION ADVISES THE TECHNICIAN ON THE STEPS REQUIRED FOR THE FRONT SHOCK ABSORBER TERMINAL REMOVAL.
PIT-5307-C2016-08-11. Service bulletin. ENGINE; SUSPENSION; EQUIPMENT:APPLIANCE:AIR CONDITIONER; SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:ABS WARNING LIGHT; SERVICE BRAKES, AIR:ANTILOCK:ABS WARNING LIGHT. THIS PRELIMINARY INFORMATION COMMUNICATION ADVISES THE TECHNICIAN ON THE STEPS TO DIAGNOSE THE CONCERN WHEN THE VEHICLE HA SA SERVICE ENGINE SOON LIGHT, ANTILOCK BRAKING SYSTEM LIGHT OR SERVICE SUSPENSION MESSAGE, MISFIRE, HESITATION, NO CRANK, AIR CONDITIONING INOPERATIVE.
PIT54572016-07-07. Service bulletin. SUSPENSION. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
PIT5287A2016-06-13. Service bulletin. SUSPENSION. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
PIT52872016-06-13. Service bulletin. SUSPENSION:FRONT. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
PIP51962016-06-09. Service bulletin. SUSPENSION:FRONT:WHEEL BEARING; EQUIPMENT. SUMMARY TO BE PROVIDED ON A FUTURE DATE.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.