WenmarOpen by Wenmar Pro

Service bulletins for the 2014 GMC Sierra

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

3324 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Automatic transmission are shown. Show all

Bulletins, newest first
142042024-01-16. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. Inner Tie Rod Torque
17-NA-0662023-07-25. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN. This service bulletin provides information for automatic transmission Oil Cooler Flush and flow test.
16-NA-1302023-03-08. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT:VALVES/VALVE BODY. This service bulletin provides information for after installation of a replacement upper valve body, the transmission may have no Reverse and no 2nd gear.
06-00-89-031D2021-09-07. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN; ENGINE. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification
990420002L2021-08-09. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION; POWER TRAIN:AUTOMATIC TRANSMISSION; EQUIPMENT. This service bulletin provides information on Driveline Clunk Noise and what is acceptable and what is considered normal operation.
PI11502021-04-28. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. Clicking/Rattle Type Noise from Rear of Engine Some customers may comment on a clicking/rattle type noise coming from the engine compartment. This may be caused by the starter shield contacting the transmission case and causing a rattle
06-00-89-031D2021-04-20. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification
150089004C2021-03-08. Service bulletin. SUSPENSION:FRONT:MACPHERSON STRUT; SUSPENSION:FRONT:SHOCK ABSORBER; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. This service bulletin provides technicians with updated information to help identify the differences between what is considered a fluid leak, and what is considered fluid seepage.
19NA1532021-02-01. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. This technical bulletin provides a procedure to replace the torque converter and inspect the front pump and the TEHCM for metal.
060089031F2020-12-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. This service bulletin provides information on OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification.
1308116001F2020-12-07. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION. The intent of this technical bulletin is to identify aftermarket ALDL or DLC interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them.
PIT5206G2020-08-10. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION; SERVICE BRAKES; EQUIPMENT. This Preliminary Information communication provides information to the technician with the steps on diagnosing and repairing vehicles that may have unwanted grade braking, reduced engine power with no Driver Information Center messages ? Brake Pedal Override Feature ?, transmission busy or frequent shifting up or down, and Diagnostic Trouble Codes P057B, P057C, and/or P057D may or may not be set. Technician will use this preliminary information to find the brake pedal position data parameters in the scan tool, and also to provide some additional diagnostic help. These issues may be caused by an incorrect brake pedal position sensor input to the engine control module. Technician will verify with the scan tool if the engine control module has the correct parameters for the brake pedal position sensor. If an engine control module brake pedal position sensor relearn is performed, the truck may be temporarily repaired until the intermittent wiring issue between the engine control module and brake pedal position sensor occurs again. On 2014 and newer trucks inspect and repair any damage to X115 and X119. On the 2014 and previous trucks inspect and repair any damage to X205.
PIP5175D2020-08-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:GEARS; ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that may have a delayed engagement into drive, shudder at a launch, or the transmission is slipping when shifting into 1st, 2nd, 3rd or 4th gears. This may be due to loose stator support to pump cover bolts causing a leak at the stator support to pump cover gasket. Technician will check for the bolts to be loose. If any of the bolts are loose or the gasket is misaligned or leaking, the transmission pump cover must be replaced and the 1234 clutch plates should be inspected for being distressed and repaired as needed.
PIP5531A2020-02-10. Service bulletin. ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015?0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that "mating" surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped
080730026F2019-09-23. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. This informational bulletin provides information on Some vehicles may rock or move slightly forward or rearward while in Park at start up after cold soak. This condition may be accompanied by a clunk noise. This is a slight movement that is more often seen visually, rather than felt, when viewed from the outside and using the auto-start feature, if equipped.
19NA1532019-08-26. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This technical bulletin provides a procedure to replace the torque converter and inspect the front pump and the TEHCM for metal.
19NA1382019-07-29. Service bulletin. EQUIPMENT; POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. This technical bulletin provides a procedure to replace high pressure pipes if found the cause of the fuel concerns.
PIP5369C2019-06-03. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM:SOFTWARE. This Preliminary Information communication provides information to the technician about vehicles that have "Service 4 Wheel Drive" message on the Driver Information Center. Provides the technician with additional information to ensure that the TCCM contains the latest software released to address previous issues, also advises of default action changes. Calls out specific circuits to be inspected to help isolate intermittent codes.
PIP3366C2018-08-20. Service bulletin. POWER TRAIN:TRANSFER CASE (4-WHEEL DRIVE); POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary information communicates to the dealer technician thatLight Duty Trucks equipped with automatic transmissions and 4 wheel drive may exhibit a condition of grinding/ratcheting type noise when shifting the automatic transmission into park while the transfer case is in 4 wheel drive low (4LO) range. Dealers technician's are advised this condition should be deemed a normal characteristic of 4WD low operation.
13-00-89-007A2018-06-25. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; POWER TRAIN:AUTOMATIC TRANSMISSION. This informational procedure provides additional information on towing a vehicle on all 4 wheels behind another vehicle.eq
09-07-30-018D2018-06-04. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; EQUIPMENT. This informational bulletin provides a revision for 09-07-30-018C to add the 2014 model year and update the Labor Operation.
PI1051A2018-05-29. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM:SOFTWARE. This preliminary bulletin provides a procedure to reprogram the TCM to correct the customers concern of a bump feel when shifting from drive to reverse.
PI0488D2018-05-29. Service bulletin. EQUIPMENT; POWER TRAIN:AUTOMATIC TRANSMISSION. This preliminary informational bulletin provides a procedure to inspect the transmissions filter for splits or cracks to correct the customers concern for no forward, reverse or slips.
02-07-30-029W2018-05-21. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN:AUTOMATIC TRANSMISSION. This informational bulletin provides information to the technician on what parts of an engine or transmission will require the PQC to be notified.
PI0938A2018-05-21. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION. This preliminary bulletin provides information on what labor operation number to use for various electrical/electronic control issues.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.