WenmarOpen by Wenmar Pro

Service bulletins for the 2015 GMC Canyon

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1818 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Backup camera are shown. Show all

Bulletins, newest first
155952023-12-18. Service bulletin. STEERING; POWER TRAIN; BACK OVER PREVENTION; ELECTRICAL SYSTEM. These vehicles may experience loss of power steering assist at startup or while driving due to a poor electrical connection within the torque-sensor harness connector. If power steering assist is lost or reduced, steering control can still be maintained but would require an increased steering effort, particularly at lower speeds, which presents a greater risk of a crash.To correct this condition, dealers will replace steering gear pinion sensor cover assembly.
070601016G2022-06-13. Service bulletin. BACK OVER PREVENTION. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
PIT5493E2022-02-14. Service bulletin. FUEL SYSTEM, GASOLINE; BACK OVER PREVENTION; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have a fuel gauge that does not read below half a tank. Technician will gain access to the fuel pump and inspect to see if the level sender contacting the side of the fuel tank. The fuel tank fuel pump module fuel level sensor will need to be replaced for this concern.
PIT5705A2021-04-19. Service bulletin. BACK OVER PREVENTION. This Preliminary information communicates a noise from the front end over bumps originating at the battery hold down retainer at inner fender.
PIT5363F2020-06-15. Service bulletin. BACK OVER PREVENTION; SERVICE BRAKES, HYDRAULIC; STEERING; FUEL SYSTEM, GASOLINE. This Preliminary Information communication provides information to the technician about vehicles that may have a click or tick noise heard inside cab with engine running. Technician may find the engine or High Pressure Fuel Pump tick noise that is very loud in the cab of the truck. Comparison with another truck having the same powertrain could show the other truck is quieter. Technician will install an acoustic seal that may be missing or dislodged. Update extends to all engines and all model years.
PIE05582020-05-04. Service bulletin. BACK OVER PREVENTION. This engineering information (EI) is requesting information from technicians to perform the check list provided and contact the engineer listed in regards a loud bang and/or grinding type noise heard coming from the rear axle area.
17NA3752018-06-04. Service bulletin. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. This informational bulletin provides a diagnostic tip for rear vision camera image that is grainy, distorted and/or pixelated
16-NA-1072018-04-23. Service bulletin. EQUIPMENT:ELECTRICAL; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. This technical bulletin provides a procedure to reprogram the radio to correct a customer concern of radio Inoperative, blue Screen, AM clipping noise, HD on/off status not retained in stations, time lag on transitions, no audio with internal amp, and park assist symbol position wrong in rear view camera.
PIP5331E2018-02-21. Service bulletin. BACK OVER PREVENTION. This Preliminary Information communication provides information on a rattle, tick, or knock type noise. Any drivability concerns they should be addressed prior to the following diagnostic progression. A sound file or video with sound of the noise needs to be made prior to dis-assembly to help isolate to one area in the engine. There are four different steps to diagnosis the concern. This communication was updated to include the 2017 and 2018 model year.
PIT54392017-08-15. Service bulletin. EQUIPMENT; BACK OVER PREVENTION. This Preliminary Information communication advises the technician that some vehicles may have the backup camera image may remain on in the radio display for a few seconds or, in the case of vehicles with a manual transmission, the screen may turn blue for a few seconds before returning to the radio display. Engineering is developing new software addressing this concern and no repairs should be attempted at this time.
PIC5611E2017-08-15. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; BACK OVER PREVENTION: CAMERA SYSTEM. This Preliminary Information communication provides information to the technician about the rear view camera options on the vehicles equipped with rear view camera. The rear view camera brightness can be adjusted on some models while the transmission is in reverse and using the Menu or Select button. To turn off or on the guidelines in the rear view camera, use the radio display Config icon then Display, then the guidelines option.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.